FCC ID: Q3K-NEO5X Single Carrier 5.x GHz Base Station with Beamforming Antenna, Dual Carrier 5.x GHz Base Station with Beamforming Antenna

NEO, NEO DUO Single, Dual Carrier 5 GHz Base Station with Beamforming Antenna REFERENCE GUIDE Regulatory Compliance FCC/ISED - Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and ISED RSS standards. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Changes or modifications to this equipment not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Outdoor units and antennas should be installed ONLY by experienced installation professionals who are familiar with local building and safety codes and, wherever applicable, are licensed by the appropriate government regulatory authorities. Failure to do so may void the product warranty and may expose the end user or the service provider to legal and financial liabilities. Resellers or distributors of this equipment are not liable for injury, damage or violation of regulations associated with the installation of outdoor units or antennas. The installer should configure the output power level of antennas according to country regulations and antenna type. Caution Prudence Les units extrieures et les antennes doivent tre installs que par des professionnels expriments d'installation qui sont familiers avec les normes locales et les codes de scurit et, si applicable, sont agres par les autorits gouvernementales de rglementation comptents. Ne pas le faire peut annuler la garantie du produit et peuvent exposer l'utilisateur final ou le fournisseur de services financiers. Revendeurs ou distributeurs de ces quipements ne sont pas responsables des blessures, des dommages ou violation des rglements lis l'installation des units extrieures ou des antennes. L'installateur doit configurer le niveau de puissance de sortie des antennes conformment aux rglementations nationales et le type d'antenne. d'obligations juridiques et NEO, NEO DUO Reference Guide i This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body. Warning Avertissement Les antennes utilises pour cet metteur doivent tre installes de manire fournir une distance de sparation d'au moins 20 cm par rapport toutes les personnes The device is granted to operate under FCC Rules in the 5.2 / 5.3 / 5.4 /

5.8 GHz bands. Warning Le module est autoris fonctionner sous certification ISDE dans les bandes 5,3 / 5,4 / 5,8 GHz. This device complies with Part 15 of the FCC rules and with ISED license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:

(1) Lappareil ne doit pas produire de brouillage;

(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. This Class B digital apparatus complies with Canadian ICES-003. NEO, NEO DUO Reference Guide ii Overview The NEO, NEO DUO is a single or dual carrier base station radio device. It encapsulates two 5.x GHz radio modules as well as independent beamforming antenna for each individual radio. The unit is designed to deliver up to 2 x 1500Mbps. It supports 10, 20, 40 80 MHz channel bandwidths in the frequency range 5150 5250 MHz*, 5725 - 5850 MHz. It is using OFDM transmission technique in TDD Duplexing method. The modulation supported is BPSK, QPSK, 16QAM, 64QAM, 256QAM OFDM The NEO incorporates a beamforming antenna coupled with a radio with software capability to toggle between wide and narrow operating modes. The NEO DUO incorporates an independent beamforming antenna for each radio with software capability to toggle between wide and narrow beamwidths operating modes. The NEO, NEO DUO is powered by a PoE device and has a LAN port option. The NEO, NEO is certified under the identification numbers FCC ID: Q3K-NEO5X and IC: 5100A-NEO5X.

* Only supported under FCC Rules Condition of Use The NEO, NEO DUO is a proprietary radio device and can only be deployed and maintained by RADWIN professional installers or its authorized subcontractors FCC Rules and ISED Regulation Restrictions The ODU firmware is factory programmed to operate under the FCC rules and ISED regulation restrictions. The firmware is locked and inaccessible by any third party. As a result of the above the user interface allows both the installer and the user to control the ODU only within the boundaries of the regional restrictions. Antenna The NEO, NEO DUO is certified with a beamforming crossed dual pole antenna type. The antenna is capable to operate in two modes configurable by software: wide angle (90deg) and narrow angle (30deg). NEO, NEO DUO Reference Guide 1 Certified Antenna Following is the antennas certified for use with the NEO, NEO DUO:

Antenna Type Manufacturer Model Number Integrated RADWIN Ltd. MR0269440 Integrated RADWIN Ltd. MR0269440 Antenna Max Gain

(dBi) 10 @ 5.1-5.4 GHz 11 @ 5.8 GHz 16 @ 5.1-5.4 GHz 17 @ 5.8 GHz Dir BW

(deg) 90 30 Maximum Output Power 5725 5850 MHz band - FCC Part 15 Subpart E, ISED RSS 247 The maximum output power can be set as follows, when operating in the 5.8 GHz band, under FCC 47 CFR Part 15.407 New Rules and ISED RSS-247 regulations. Total EIRP is limited to 36 dBm. Conducted output power in 90deg configuration is 25 dBm. Conducted output power in 30deg configuration is 19 dBm. 5150 5250 MHz band FCC Part 15 Subpart E The maximum output power can be set as follows when transmitting in the 5.1 GHz band, under FCC 47 CFR Part 15.407 New Rules and regulations. Total EIRP is limited to 36 dBm. Conducted output power in 90deg configuration is 26 dBm. Conducted output power in 30deg configuration is 20 dBm. 5250 5350 MHz band FCC Part 15 Subpart E, ISED RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. Total EIRP is limited to 30 dBm. Conducted output power in 90deg configuration is 20 dBm. Conducted output power in 30deg configuration is 14 dBm. 5470 5725 MHz band FCC Part 15 Subpart E, ISED RSS 247 The maximum output power is set as follows, under FCC and ISED regulations. Total EIRP is limited to 30 dBm. Conducted output power in 90deg configuration is 20 dBm. Conducted output power in 30deg configuration is 14 dBm Radio parameters accessed by end-user The following parameters can be accessed by user:

1. Output Power 2. Frequency channel 3. Channel bandwidth NEO, NEO DUO Reference Guide 2

Agent Authorization Dual Carrier 5.x GHz Base Station with Beamforming Antenna Dual Carrier 5.x GHz Base Station with Beamforming Antenna Company: RADWIN Ltd. Address: 27 Habarzel Street Tel Aviv, 6971039 Israel Product Name: Single Carrier 5.x GHz Base Station with Beamforming Antenna, Model Number(s): NEO, NEO DUO Product Description: Single Carrier 5.x GHz Base Station with Beamforming Antenna, We authorize MiCOM Labs Inc., 575 Boulder Court, Pleasanton, California 94566, USA, to act on our behalf on all matters concerning the certification of above named equipment. We declare that MiCOM Labs Inc. is allowed to forward all information related to the approval and certification of equipment to the regulatory agencies as required and to discuss any issues concerning the approval application. Any and all acts carried out by MiCOM Labs on our behalf shall have the same effect as acts of our own. Signature:

Date: April 1, 2021 Name:

Shlomo Weiss Title:

Standardization Officer Company: RADWIN Ltd.

Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 USA Date: April 4, 2021 Subject; Request for Confidentiality FCC ID: Q3K-NEO5X To Whom It May Concern, Pursuant to the provisions of the Commissions rules Title 47 Sections 0.457 and 0.459, we are requesting the Commission to withhold the following attachment(s) as confidential documents from public disclosure indefinitely. These documents contain detailed system and equipment descriptions and are considered as proprietary information in operation of the equipment. The public disclosure of these documents might be harmful to our company and would give competitors an unfair advantage in the market. Additionally the device is not accessible to users being installed in hosts manufactured only by RADWIN and hosts being mounted on antenna towers. Schematic Diagram Block Diagram Parts List Operational Description Security Descriptions Internal Photos External Photos Test Setup Photos User Manual In additional to above mentioned documents, in order to comply with the marketing regulations in Title 47 CFR 2.803 and the importation rules in Title 47 CFR 2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices, we request Short Term Confidentiality of the following attachment(s);

OR For 45 days, pursuant to Public Notice DA 04-1705. For 180 days pursuant to KDB 726920 D01. It is our understanding that all measurement test reports, FCC ID label format and correspondence during the certification review process cannot be granted as confidential documents and this information will be available for public review once the grant of equipment authorization is issued. Sincerely, Signature:

Name: Shlomo Weiss Title: Standardization Officer

Model Difference Declaration Letter There are 2 models requested for approval under FCC ID: Q3K-NEO5X 1. NEO 2. NEO DUO The radio module, the digital board and the beamforming antenna is identical in both models. The models indicate single or dual assembly options as shown below 1. NEO assembly incorporating a single digital board, a single radio module, and a single 2. NEO DUO assembly incorporating a single digital board, two radio modules, and a two Shlomo Weiss Standardization Officer beamforming antenna beamforming antennas. Name:

Title:

Signature of applicant

Date: April 4, 2021 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Subject: FCC Restriction Configuration Control Attestation for FCC ID: Q3K-NEO5X To Whom It May Concern:

RADWIN Ltd. attests that the software of the model: NEO, NEO DUO conforms to the requirements of the FCCs SOFTWARE SECURITY REQUIREMENTS FOR U-NII DEVICES specified in 594280 D02 U-NII Device Security v01r03 and KDB 442812 D01 SDR Apps Guide v02r03 under the SDR rules. We have submitted separate documentation to the FCC outlining the software security features. Furthermore that the software of the NEO, NEO DUO cannot be modified by any third party in any way that causes the NEO, NEO DUO to operate in violation of the limits of the FCC GRANT OF EQUIPMENT AUTHORIZATION for FCC ID: Q3K-NEO5X. Sincerely Yours, Name:

Title:

Date: April 4, 2021 Shlomo Weiss Standardization Officer RADWIN Ltd.

+972-3-7662988

+972-3-7662902 shlomo@radwin.com Phone:

Fax:

Email:

RDWN73 FCC Restriction Config Control Attestation Rev1.1.docx

FCC Software Configuration Control Declaration Date: April 4, 2021 Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 USA Attn: OET Dept. Product/ Model Number: NEO, NEO DUO Regarding FCC Country Code Selection guidelines identified in KDB 594280. All applications for equipment authorization for transmitters that can have radio parameters, or other technical parameters, reported to the Commission set by software must have an attestation indicating that no third party will have software, or configuration control, to program the device out of compliance of the technical rules under which it has been certified. We declare that no third party will have software, or configuration control, to program the device out of compliance of the technical rules under which it has been certified. Name: Shlomo Weiss Title: Standardization Officer Signature of applicant Date: April 4, 2021 RDWN73 Software Config Control Declaration Rev1.1.docx