FCC ID: VHTEVERUN UMPC

| 5. Using Windows XP in Everun - Mouse Settings Mouse Setting 1. Go to Start > Control Panel > Mouse 2. Select the desired items. 3. Click OK to save the setting e p Mouse Properties Buttons | Pointers Pointer Options Wheel | Hardware ky ) a PP Search a Folde| Button configuration

(J Switch primary and secondary buttons Select this check box to make the button on the Tight the one you use for primary functions such as selecting and dragging, 7 Double-click speed See Also / Double-click the folder to test your setting. IF the:

folder does not open or close, try using 4 slower

% Windows Update ; setting

@) Help and Support | Speed: Slow < Fast fe ClickLock,

(J Tum on ClickLock Settings Enables you to highlight or drag without holding down the mouse button. To set, briefly press the mouse button. To release, click the mouse button again. Apply 38 6. Recovering Windows XP Using Windows XP Self Recovery

2

2

FCC RF Exposure Information In August 1996 the Federal Communications Commission (FCC) of the United States with its action in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies. The design of EVERUN complies with the FCC guidelines and these international standards. Use only the supplied or an approved antenna. Unauthorized antennas, modifications, or attachments could impair call quality, damage your EVERUN, or result in violation of FCC regulations. EVERUN was tested for typical body-worn operations using the optional belt-clip / holster placed touch

(0cm) from the body. To comply with FCC RF exposure requirements, a separation distance of touch

(0cm) must be maintained between the user's body and EVERUN, including the antenna, whether extended or retracted. The use of non-tested accessories or other body-worn operations may not comply with FCC RF exposure requirements and should be avoided. Contact your local dealer for optional accessory items. For more information about RF exposure, please visit the FCC website at www.fcc.gov FCC Radio Frequency Emission This phone meets the FCC Radio Frequency Emission Guidelines. FCC ID number:

HVTEVERUN. More information on the phones SAR can be found from the following FCC website: http://www.fcc.gov/oet/fccid USER INFORMATION Acknowledging Special Precautions and the FCC Industry Canada Notice Cautions Modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC compliance Information This device complies with part 15 of FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and 2. This device must accept any interference received. Including interference that may cause undesired operation. Information to User This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio Frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.