WARNING:pdfminer.pdfpage:The PDF <_io.BufferedReader name='/Volumes/Scratch/Incoming/eg-scratch/6190763.pdf'> contains a metadata field indicating that it should not allow text extraction. Ignoring this field and proceeding. Use the check_extractable if you want to raise an error in this case OC-01 Card Tracker Setup and Installation Guide VERSION 1.0 Please read the manual before using and saving it for future reference. And please fully charge it before using Parameters:
Cat M1&Cat NB1: QUECTEL BG96 LTE FDD:B2/B4/B12 Data transmit by: TCP/IP Working voltage:3.4-4.2V DC GNSS accuracy:2.5m CEP50 GNSS:GPS,GLONASS,Beidou,Gailileo,QZSS GNSS sensitivity : cold start: -146 dbm, reacquisition -157dbm, tracking: -157 dbm GNSS start time : cold start TTFF<31s, warm start TTFF<21s, Working temperature : -20~+70 Working humidity:20%~80%RH Color: white Dimension:90*54*11mm N.W:65g Functions:
Support LTE CATM1 data transfer Support WPT RX Built-in high sensitivity GPS + AGPS rapid positioning Support AT commands for easy and fast development Communicated via SMS/TCP Historical track and playback OTA firmware upgrading Data buffer storage 100 points Support 3 aixs accelerometer Support Geo-fencing function Support wireless recharging Installation:
Please insert the micro sim card and switch on the device. Led indicator:
RED led BLUE led GREEN led On: charging off: full charged Flash: searching LTE signal off: ready to use Flash: searching GPS signal off: ready to use SMS configuration:
1,IP setting Command:CMD,IP,new ip,new port#
2,APN setting Command:APN,new apn#
3,reset Command:reset# Compatible:CQ#
4,restore factory setting Command:RFS#
5,parameter query Command:QP#
Auto-reply:
IMEI:359600108190001 APN:internet IP:"47.112.147.216",10216 LMT:0 CENTER:
CQS:31-(31) GPS:1 BAT:78% (3.98V) 6,set the center number Command:center,000000,mobile No.#
7,google link Command:URL# (with imei and time) URLS# (without imei and time) Only reply to the center number. 8,Low battery alarm Command:LB,ON#
LB,OFF#
(turn on)
(Turn off) Please note that when you send sms to turn off this function.Then the platform wont get the alarm either. FCC Regulations:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. FCC RF Exposure Information (SAR) This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the United States. During SAR testing, this device is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that simulate RF exposure in usage near the body with the separation of 10mm. Although the SAR is determined at the highest certified power level, the actual SAR level of the while operating can be well below the maximum value. The exposure standard for wireless employs a unit of measurement known as the Specific Absorption Rate, or SAR. The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. While there may be differences between the SAR levels of various devices and at various positions, they all meet the government requirement. The tracker is to embed it in binder which contain materials we want to be able to track. The binder is normally carried in a briefcase when not in use and when being used would be at a normal reading distance from the person.