Users Instruction FCC ID:YMURF1M Cues can be activated one by one through pressing buttons RFRemotech Radio Frequency Remote Technology Remote Control Products, Remote Controllable Service Warning!!!
A. Only the person who has Fireworks licence is allowed to purchase the product, or the person of whom there isnt fireworks purchase limitation in his/her country or district is allowed to purchase the product. RFRemotech/E-MadeinCHN is not with responsibility for any illegal usage. Descriptions Mode: OOK Wireless Radio Type: Learning Code Frequency: 433MHz Every receiver can learn one button of transmitters, Each button can activate its corresponding receiver(s) instantly. A. TCF Transmitter (FCC/CE certified) TCF100-12LN/TCF100-12LNX Channel: 12CH Power: 23A 12V battery Transmitting Range:100m With ON/OFF switch, prevent the buttons from misoperation B.Receiver Model No.:
AlphaFire M: RF1M(FCC/CE certified) Cue: 1 Cue Power: 4x AAA battery Firing current: >750mA, Max. 5000mA Test current: <10mA Sizes: 55x50.5x40mm, Antenna is retractile and can be folded. 1-Antenna, retractile and can be folded. 2-Power/Low Power LED. Normally the LED is always on as 3-Position Switch 4 is at FIRE or TEST. When batteries are low, the LED blinks. 3-Test LED. When exterior circuit is coherent, the LED is on; When exterior circuit is interrupted, the LED is off. 4-3-Position Switch, TEST-Test exterior circuit, OFF-Power is off, FIRE-Receiver is armed to fire fireworks or learn code. 5-Label. 6-Label Location, mark receiver. 7-Learning Button. Only when 3-position switch is FIRE, LEARN button can work. 8-Learning/Firing LED. See the following description Learn Code. 9-Fast Fastening Terminals. 10-Firing LED (see the above picture in Page 2) Before Use Put 4x AAA battery into battery enclosure. Learn Code Receiver must learn code of transmitter button, so that transmitter will work with receiver together. How to Learn Code: Shift 3-position switch to FIRE, keep depressing LEARN button more than 3 seconds to have Learning/Firing LED on, and then release LEARN button, press one of transmitter buttons within 3 seconds, LED will blink once and then be off, learning code succeeds. How to Clear Code: Shift 3-position switch to FIRE, press LEARN button and dont release the button for more than 6 seconds until Learning/Firing LED blinks three times and then goes off, code is cleared. Warning: Only when no fireworks is connected, you can Learn Code or Clear Code!
How to Use A. Test To check if external circuit is coherent. When exterior circuit is connected, Shift 3-position switch to TEST, if TEST LED is on, it indicates the exterior circuit is coherent; If TEST LED is off, it indicates the exterior circuit is interrupted. B. Fire When exterior circuit is tested coherent, shift 3-position switch to FIRE, press transmitter button, Learning/Firing LED will blink once, firing current will be sent out. Please note, in FIRE status, receiver can be re-activated after 5 seconds. Reference Any number of receivers can be programmed to any of the buttons/channels, so a button/channel can fire multiple e-matches simultaneously. Some Recommendations AlphaFire M12Q 1x TCF100-12LN/TCF100-12LNX 12x RF1M Range 100m. FCC, CE certified. Manufacturer: RFRemotech E-mail: service@RFRemotech.com Http://www.RFRemotech.com March, 2012 WARNING:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment.