Richest Technology Inc. 6F-1, No. 57, Ln 10, Jinhu Rd., Neihu Dist., Taipei City 114, Taiwan T: +886-2-27989555 F: +886-2-27989475 RT Restaurant Guest Call System User Manual 1. Turn on receivers: Put receivers on charging slot, then Receivers will remove receivers from charging slot. automatically turn on. 2. Turn off receivers: Press 801, then Send to turn off receivers. Note that receivers are also turned off during charging. 3. Call receivers: To call receivers, press receiver number, then Send. 4. Find receivers: Press 805, then Send to alert receivers. Note that receivers will not alert during charing. 5. Range test: Press 806, then Send to test transmitting distance. Transmitter will keep sending signals to alert receiver #1 until it is out of range. 6. Turn on & off buzzer: Remove receivers from charging slots. Press 807, then Send to turn off buzzer (vibration only). Press 808, then Send to turn on buzzer (vibration
+ beep). Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution: To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.