FCC ID: 2ALG8BEENG500 GPS Tracker

Roambee Sensor Bee BNG 500 User Manual January 2022 Beginning to use the Roambee Sensor Bee The Roambee Sensor Bee, Model: BNG 500, will be shipped with charged NiMH batteries and operational until the batteries discharge. Figure 1 Access and Control The Roambee Sensor Bee works in conjunction with the Roambee Portal. The location and sensor information from the Bee will be transmitted to the Roambee Portal through the cellular modem. The Roambee portal has multiple features that enable the management of the sensor bee. Users in the portal have the ability to locate a bee and change the configuration of the bee. Configuration The Sensor Bee has two basic modes: Transmitting and Sleeping. Transmitting occurs during fixed reporting intervals which can be configured within the portal. The transmission time can vary from between 10 minutes and 24 hours. When the Sensor bee is not transmitting it is still monitoring the sensors and recording the sensor data. Safety The Roambee Sensor Bee is a radio transmitting device. Always adhere to local laws and regulations. Switch off the Roambee Sensor Bee in places where the use of cellular phones is not permitted or where it can create interference, for example near medical equipment that can be affected by radio interference and at blasting sites. Federal Communication Commission Statement This device is used for cargo tracking purposes only and is not to be used on or near animals and humans as a portable device. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. RF Exposure Statement

(3) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, this equipment should be installed and operated with minimum distance 20 cm (7.8 inches) between the antenna and your body during normal operation. Users must follow the specific operating instructions for satisfying RF exposure compliance. ISED Non-Interference Disclaimer This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :

(1) Lappareil ne doit pas produire de brouillage;

(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. RSS Gen Transmit Antenna Statement This radio transmitter 28141-BEENG500 & 10224A-2019BG95M3 has been approved by Innovation, Science and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited for use with this device. Le prsent metteur radio28141-BEENG500 & 10224A-2019BG95M3 a t approuv par Innovation, Sciences et Dveloppement conomique Canada pour fonctionner avec les types d'antenne numrs ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est suprieur au gain maximal indiqu pour tout type figurant sur la liste, sont strictement interdits pour l'exploitation de l'metteur. Under Innovation, Science and Economic Development regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by ISED. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Input Power LTE-M bands: Power Class 5, 21 dBm; GSM bands: Power Class 4, 33 dBm. Approved Antenna Types:

Cellular:

Impedance: 50 Ohm AVX Model: 1004795 Max Gain: 3.1 dBi Radiation Pattern: Omni-Directional Operation Frequency Range: 698 MHz 2700 MHz Impedance: 50 Ohm AVX Model: 1001013 Max Gain: 2.6 dBi Radiation Pattern: Omni-Directional Operation Frequency Range: 2402 MHz 2480 MHz Input Power BLE +3 dBm Impedance: 50 Ohm AVX Model: 1001013 Max Gain: 2.6 dBi Radiation Pattern: Omni-Directional Operation Frequency Range: WiFi b,g,n/HT20: 2412-2472MHz Input Power Wi-Fi 19.5 dBm BLE Wi-Fi RF Exposure Statement This equipment complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm (7.6 inches) between the radiator and any part of your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Pour se conformer aux exigences de conformit ISED RSS-102 RF exposition, une distance de sparation d'au moins 20 cm doit tre maintenue entre l'antenne de cet appareil et toutes les personnes. Lanceurs ou ne peuvent pas coexister cette antenne ou capteurs avec dautres.

Nemko Canada Inc 303 River Road Ottawa K1V 1H2 Canada Attn: Director of Certification Authority to Act as Agent FCC On our behalf, I appoint Spencer Zhong of Nemko Canada, Inc. 303 River Road, Ottawa, Ontario, Canada K1V 1H2, to act as our agent in the preparation of this application for equipment certification. I certify that submitted documents properly describe the device or system for which equipment certification is sought. I also certify that each unit manufactured, imported or marketed, as defined in FCC regulations will have affixed to it a label identical to that submitted for approval with this application. In signing this letter, Applicant certifies that neither the applicant nor any party to the application is not subject to a denial of Federal benefits, that include FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862 because of a conviction for possession or distribution of a controlled substance. See 47 CFR 1.2002(b) for the definition of a "party" for these purposes. For instances where our authorized agent signs the application for certification on our behalf, I acknowledge that all responsibility for complying with the terms and conditions for certification, as specified by Nemko Canada Inc, still resides with Roambee Corporation 3120 De La Cruz Blvd, Suite 210 Santa Clara, CA 95054 USA. March 20 22 1st Day of Dated this Agency agreement expiration date:

By:

Signature Title:

Telephone:

On behalf of:

Vice President 408 663 6655 Roambee Corporation March 1, 2023 Vidya Subramanian Printed Roambee Corporation, 3120 De La Cruz Blvd, Suite 200, Santa Clara, California 95054 www.roambee.com

DATE: March 1, 2022 Nemko Canada Inc 303 River Road Ottawa, Ontario, Canada K1V 1H2 FCC ID: 2ALG8BEENG500 Model: BNG 500 Request for Permanent Confidentiality Pursuant to Sections 0.457(d) and 0.459 of the Commissions rules, we hereby request that the following documents be held confidential:

Schematics Block diagram Bill of Materials Operation description These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated: March 1, 2022 Signed:

Printed name: Vidya Subramanian Title: Vice President On behalf of: Roambee Corporation Roambee Corporation, 3120 De La Cruz Blvd, Suite 200, Santa Clara, California 95054 www.roambee.com