ROCKIOO WATCH USER GUIDE Rockioo Technology Co.,Ltd. Model: R1 Thanks for buying ROCKIOO watch. Please read the user guide carefully before using the watch. This manual special used to guide you understand th e watch functions and features. If you have any issues, please contact us by www.rockioo.com. 1 Buttons 1. 2. Charging Cable Connect charging cable with power adaptor, then connect with pin contacts at the end of longer wrist band, shown as below:
2 The watch will power on automatically while charge up to 2%, please consume all battery for first 3 times, it will help to keep the battery in best use status. 3. Power off the watch, put the metal contact part of SIM card upside, shown as below; if you want to take the SIM card out, please power off the watch first. Install SIM Card and take it out 4. Power on and off Use the SIM card screw driver to press the up button of back side until you see the ROCKIOO logo. 3 Go to settings, slide to bottom and select power off. 5. Accessories USB charging cable, SIM card screw driver. Basic use, gestures shown as below. FCC statement 6. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful 4 interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from is connected.
-- Consult the dealer or an experienced radio/TV technician for help. the receiver to which that This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 5 Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF Exposure Information (SAR) This device meets the governments requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. Tests for SAR are conducted using standard operating positions accepted by the FCC with the watch transmitting at its highest certified power level in all tested frequency bands. The FCC has granted an Equipment Authorization for this model watch with all reported SAR levels evaluated as in in compliance with the FCC RF exposure guidelines. 6 SAR information on this model watch is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/
fccid after searching on FCC ID: 2AEGL-R1 To comply with RF exposure requirements, a minimum separation distance of 10 mm must be maintained between the users mouth, and this model watch including the antenna during voice communications. This device is restricted to worn on the wrist operations. 7 Rockioo Technology Co.,Ltd. Address: Room B201, Building 1, Phase III ,MinXing Road, MinZhi Street, LongHua District ,ShenZhen. Tel0755-28178517 Websitewww.rockioo.com 8