MT02-0101-069011 5CH Remote Control 01 Remote Controller Buttons 1. The transmitter should not be exposed to moisture or impact, so as not to affect its life. 2. During use, when the remote control distance is significantly shorter or less sensitive, please check whether the battery needs to be replaced. 3. When the voltage is too low, orange LED will flicker during operation, indicating to replace the battery. 4. Please properly dispose of used batteries according to the local garbage classification and recycling policy. 04 Instruction a. Prohibit Dual-key Operation Press Prg x10s, LED flickers trice Repeat the above, dual-key operation activated Note: When dual-key operation prohibited, these programming setting function are not allowed b. Number of Channels Setting PressCH- & CH+ together for 3s, LED flickers trice, short pressCH- or CH+, then short press Stop,LED flickers twice. Note: When all LEDs are lit, that is channel 0 (All channels move together). C. For other operations, please refer to the motor operation instruction FCC Compliance This device complies with Part 15 of the FCC Rules / Innovation, Science and EconomicDevelopment Canadas licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Lmetteur/rcepteur exempt de licencecontenu dans le prsentappareilestconforme aux CNR dInnovation, Sciences et Dveloppementconomique Canada applicables aux appareils radio exempts de licence. Lexploitationestautorise aux deux conditions suivantes :
(1) Lappareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillageradiolectriquesubi, mmesi le brouillageest susceptible dencompromettre le fonctionnement. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.