FCC ID: WNG-TM-EAP-01 Pad Transmitter

Rondish Company Limited Early Alert Bed Sensor Pad TM-EAP-01 For Safety, Replace This Pad After 18-Month of Use CAUTION: Technology alone cannot prevent falls of injury. This device must supplement a facilitys fall management and supervisory program. Sensor Pad Instructions Select Pad Setting:

1. Open the pocket to access the 3-way switch on the transmitter module. The default position of OFF. 2. TX-only will activate Early-Alert function only on the transmitter side of the sensor pad. Alarm goes off when a patient is sitting on the TX side edge of the sensor pad and about to leave their bed. The other side remains in a normal setting. The alarm goes off when the patient leaves their bed. Both-sides will enable Early-Alert function on both sides of the sensor pad. Secure the Pad:

1. Position the sensor pad across the bed beneath the hips of the patient. The neck of the sensor pad should exit out the side of the bed. 2. Optional clip sets are available to prevent pad movement. They loop through the eyelets as shown below. 3. They can be clipped to the bed to hold the sensor pad in place. Pad with Monitor:

1. Press the Program button on the wireless monitor unit you will hear a beeping from the monitor. 2. Press and release the centre zone of sensor pad to add it into memory. You will see visual and audible feedback from the monitor to confirm the signal was received. 3. Test the sensor pad by pressing and releasing. Care & Maintenance Instructions:

Use disinfectant wipes or antibacterial cleansers to clean the pad. DO NOT immerse the sensor pad in any liquid. DO NOT expose the sensor pad to high temperature sanitizers. Storage:

Always keep the sensor pad flat when in storage Operating temperature: 10oC ~ 40oC (50oF ~ 104F) Storage temperature: 0oC ~ 50oC (32oF ~ 122F) Warnings Test regularly to ensure the sensor pad is working properly. This product uses radio frequency signals, which can be affected by building layout and construction materials. The manufacturer cannot guarantee the wireless range you get will match the estimates provided. You should test that there are no dead areas in your facility where alarms cannot be received. FCC Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Notice:

Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/ TV technician for help.

A 2023-6-8

: RonDish

: 2304-05-R&D

: RonDish

: TM-EAP-01

: 2304-05-R&D

: A

: AS-TMEAP01-00A

: 20230609

Color Table Pantone 445C

Designs in Security / Healthcare / Communication Rondish Company Limited Unit G & H, 4/F, Block 1, Kwai Tak Ind. Ctr, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong Tel.: (852) 25431955 Fax: (852) 25417411 Date: 1-Sep-2023 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize (Eurofins Electrical Testing Service (Shenzhen) Co., Ltd.) to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). This agreement expires one year from the current date. Sincerely, Signature:

Name: TERRENCE YING Applicant: RONDISH CO. LTD Address: UNIT G&H, 4/F, Block 1, KWAI TAK IND. CTR, 15-33 K HONGKONG, China TEL: 852-25431955 RONDISH COMPANY LIMITED Unit G/H, 4/F, Block 1, Kwai Tak Industrial Centre, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong. Tel.: (852) 2541 6685 Fax: (852) 2541 7411 Email: rcl@rondish.com Website: www.rondish.com

Designs in Security / Healthcare / Communication Rondish Company Limited Unit G & H, 4/F, Block 1, Kwai Tak Ind. Ctr, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong Tel.: (852) 25431955 Fax: (852) 25417411 Date: 1-Sep-2023 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(i) request for FCC ID: WNG-TM-EAP-01

[RONDISH CO. LTD] certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Signature:

Name: TERRENCE YING RONDISH COMPANY LIMITED Unit G/H, 4/F, Block 1, Kwai Tak Industrial Centre, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong. Tel.: (852) 2541 6685 Fax: (852) 2541 7411 Email: rcl@rondish.com Website: www.rondish.com

Designs in Security / Healthcare / Communication Rondish Company Limited Unit G & H, 4/F, Block 1, Kwai Tak Ind. Ctr, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong Tel.: (852) 25431955 Fax: (852) 25417411 Date: 1-Sep-2023 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Attestation Statements Part 2.911(d)(5)(ii) request for FCC ID: WNG-TM-EAP-01 RONDISH CO. LTD certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Sincerely, Signature:

Name: TERRENCE YING RONDISH COMPANY LIMITED Unit G/H, 4/F, Block 1, Kwai Tak Industrial Centre, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong. Tel.: (852) 2541 6685 Fax: (852) 2541 7411 Email: rcl@rondish.com Website: www.rondish.com

Designs in Security / Healthcare / Communication Rondish Company Limited Unit G & H, 4/F, Block 1, Kwai Tak Ind. Ctr, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong Tel.: (852) 25431955 Fax: (852) 25417411 Date: 1-Sep-2023 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: CONFIDENTIALITY REQUEST FOR (Pad Transmitter / TM-EAP-01 / FCC ID: WNG-TM-EAP-01) To Whom It May Concern:

This letter serves as an official request for confidentiality under sections 0.457 and 0.459 of CFR 47. We have requested that the (Block Diagrams, Schematics, Operational Descriptions) required to be submitted with this application be permanently withheld from public review. The above documents are company proprietary information that could never get into the possession of your competition. Please contact me if there is any information you may need. Sincerely, Signature:

Name: TERRENCE YING Applicant: RONDISH CO. LTD Address: UNIT G&H, 4/F, Block 1, KWAI TAK IND. CTR, 15-33 K HONGKONG, China TEL:

RONDISH COMPANY LIMITED Unit G/H, 4/F, Block 1, Kwai Tak Industrial Centre, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong. Tel.: (852) 2541 6685 Fax: (852) 2541 7411 Email: rcl@rondish.com Website: www.rondish.com

Designs in Security / Healthcare / Communication Rondish Company Limited Unit G & H, 4/F, Block 1, Kwai Tak Ind. Ctr, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong Tel.: (852) 25431955 Fax: (852) 25417411 Date: 1-Sep-2023 Eurofins Electrical and Electronic Testing NA, Inc. 914 West Patapsco Avenue Baltimore, MD 21230 RE: Short Term Confidentiality Request For(Pad Transmitter / TM-EAP-01 / FCC ID:

WNG-TM-EAP-01) To Whom It May Concern:

In accordance with sections 0.457 and 0.459 of CFR 47, < RONDISH CO. LTD >. requests short-term Confidentiality of following sections of this application for a period of 45 days after grant is issued. Test setup photos External photos Internal photos Users manual These documents contain detailed system and equipment descriptions and related information about the product, which < RONDISH CO. LTD > considers to be proprietary, confidential, and a custom design and otherwise, would not release to the general public. Since this design is a basis from which future technological products will evolve,

< RONDISH CO. LTD > feels that this information would be of benefit to its competitors, and that the disclosure of the information in these documents would give our competitors an unfair advantage in the market. Please contact me if there is any information you may need. Sincerely, Signature:

Name: TERRENCE YING Applicant: RONDISH CO. LTD Address: UNIT G&H, 4/F, Block 1, KWAI TAK IND. CTR, 15-33 K HONGKONG, China TEL: 852-25431955 RONDISH COMPANY LIMITED Unit G/H, 4/F, Block 1, Kwai Tak Industrial Centre, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong. Tel.: (852) 2541 6685 Fax: (852) 2541 7411 Email: rcl@rondish.com Website: www.rondish.com

Rondish Designs in Security / Healthcare / Communication U.S. Agent Designation for Service of Process

(Applicant and U.S. Agent are Separate Parties) ATTENTION: FCC Certification Section 2.911(d)(7) Information Designated U.S. Agent Company Name: Rondish Company Limited FRN: 0033512179 Contact Name: Michael Dunphy Street Address: 36041 Hwy 58, City/Province/Zip: Pleasant Hill, OR 97455 Telephone No: +1 541 600 9812 Email: mpdunphy@gmail.com Signature: AAffy Date: 7-Sep-2023 Signed by (Printed Name/Title): Michael Dunphy / Global Marketing Manager This letter is to confirm that we (the Designated U.S. Agent) have accepted the responsibility to act as the Designated U.S. Agent for Service of Process as required by section 47 CFR 2.911(d){7) on behalf of the Applicant noted below. The Applicant acknowledges that they must maintain an agent for no less than one year after terminating all marketing and importation OR the conclusion of any Commission-related proceeding involving the equipment. The applicant further acknowledges their responsibility to inform the FCC whenever the Designated U.S. Agent information above changes. Applicant Company name: Rondish Co. Ltd Grantee Code: WNG FCC ID: WNG-TM-EAP-01 Contact Name: TERRENCE YING Street Address: UNIT G&H, 4/F, Block 1, KWAI TAK IND. CTR, 15-33 K HONGKONG, China City/Province/Zip: HONGKONG Telephone No: 852-25431955 Email: Terrence.ying@rondish.com i f L At IN L/

Signature:

Date: 7-Sep-2023 Signed by (Printed Name/Title): TERRENCE YING / Senior QA Engineer RONDISH COMPANY LIMITED Unit G/H, 4/F, Block 1, Kwai Tak Industrial Centre, 15-33 Kwai Tak St., Kwai Chung, N.T., Hong Kong. Tel.: (852) 2541 6685 Fax: (852) 2541 7411 Email: rcl@rondish.com Website: www.rondish.com