FCC ID: OM601480T27 26.96-27.28 MHz WIRELESS REMOTE CONTROL TOY-TX

Age 5+

ITEM#01480 RONIN SYNDICATE RSTOYS.COM 8100 E. Indian School Rd. Suite 103 Scottsdale, AZ 85251 MADE IN CHINA INSTRUCTION MANAUL |

eke _ IF BUMPER BASHER DOES NOT RESPOND PROPERLY, PLEASE REPLACE THE BATTERIES IN VEHICLE (3 AAA IM PO RTANT: PER VEHICLE NOT INCLUDED) AND BATTERIES IN CONTROLLER (1 9V PER CONTROLLER NOT INCLUDED). Kk a NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. his device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions:

1. This device may not cause harmful interference, and 2. This device must accept any Interference received, Including interference that may cause undesired operation. DO NOT MIX ALKALINE, STANDARD (CARBON ZINC) OR RECHARGEABLE (NICKEL CADMIUM) BATTERIES. DO NOT MIX OLD AND NEW BATTERIES. DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK. Colors and decorations may vary. Keep content details for future reference. CONTENT LIST 2 Controllers 2 Bumper Bashers Vehicle 18 Fence Vehicles 1) Using a crosshead screwdriver, unscrew and remove the battery cover. 2) Insert the 3 AAA battery per vehicle

(not included) into the vehicle. Replace battery cover and tighten the screw. Controllers 1) Using a crosshead screwdriver, unscrew and remove the battery cover. 2) Insert the 9V battery per controller

(not Included) into the controller. Replace battery cover and tighten the screw. / ; \

1) Please install the Fence as the diagram shown. 1 PLEASE NOTE:

A) Make sure the batteries have been Inserted correctly (+ or -) into the products. B) lf the Vehicle does not reponse properly, please replace the batteries. C) Use Alkaline battery for the longest battery life, and best performance. DO NOT MIX ALKALINE, STANDARD (CARBON ZINC) OR RECHARGEABL

(NICKEL CADMIUM) BATTERIES. DO NOT MIX OLD AND NEW BATTERIES.

(\ CAUTION:

DO NOT MODIFY TOY IN ANY WAY.ADULT SUPERVISION IS DO NOT DISPOSE OF BATTERIES IN FIRE, BATTERIES MAY EXPLODE OR LEAK. ADVISED!

Back Cautions:

1. Make sure you always use new or fully charged batteries. 2. Do not operate the Bumper Bashers If it becomes damaged In any way. 3. Check that the Radio Control signal from the controller is making a connection with the Bumper Bashers before operating. 4. Check that the area Is clear of all obstacles before you operate. Adult supervision Is always recommended. 6. Never operate near animals. Keep Bumper Bashers away from your fingers, hair, eyes and other body parts. otay away from obstacles and electrical hazards. Warning:

. Non-rechargeable batteries are not to be recharged. Rechargeable batteries are only to be charged under audit supervision. Rechargeable batteries are to be removed from the toy before being charged. Different types of batteries or new and used batteries are not to be mixed. Batteries are to be Inserted with the correct polarity. Exhausted batteries are to be removed from the toy. The supply terminals are not to be short-circuited. NOOR WD NOTE:

Operating multiple RC's with the same frequency in close proximity will cause interference and poor performance. Works best away from electrical hazards and large obstacles. Do not put objects or fingers near the front or rear of the wheels while it Is turning. When not in use, remove batteries from compartements (both vehicle and controller). USING YOUR BUMPER BASHERS:

1) Flip the ON/OFF switch to the "ON" positon on both vehicles and controllers. 2) Select the "A,B,C, or D" frequency band correspond of both controller and vehicle.

(NOTE 2 PLAYERS CANNOT BE USING THE SAME FREQUENCY BAND, NEED TO BE DIFFERENT FREQUENCY BAND IN ORDER TO PLAY TOGETHER). 3) Place the vehicle on the ground, and use the controller to maneuver the vehicle. 4) Control your Vehicle Backward

)) When all 3 sides button Is hit (2 sides and rear bumper), your Figure ejects and you lose.

(Note when the button Is hit, the LED will light up) 6) Put the figure back to the seat and play gain. WARNING:

1) DO NOT USE ANY PROJECTILES OTHER THAN FCC NOTE:

The antenna provided Is a unique antenna. By installation of unauthorized antenna to this equipment, such THE FIGURE PROVIDED WITH THE TOY. 2) DO NOT AIM AT EYES AND FACE WHEN INSTALLING unauthorized installation could void the user's authority to THE FIGURE TO THE VEHICLE. operate the equipment. PLEASE NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, If not installed and used In accordance with the instructions, may cause harmful intererence to radio communications. However, there is no guarantee that interference will not occur In a particular Installation. If this equipment does cause harmful interference to radio or television receiption, which can be determined by turning the equipment off and on, the user Is encouraged to try to connect the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.

- Consult the dealer or an experienced radio/TV technician for help.

FCC ID Label Sample (Part 1) for FCC ID: OM601480T27 27 MHz Item Number: 01480 FCC ID: OM601480T27

FCC ID Label Sample (Part 2) for FCC ID: OM601480T27 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Ronin Syndicate LLC 8100E. Indian School Road, Suite 103, Scottsdale, AZ85251, USA Tel: 602-748-3020 / Fax: 602-264-2786 2nd September, 2013. Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046. Confidentiality Request regarding application for certification of FCC ID: OM601480T27. To Whom It May Concern:

Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

Exhibit Type File Name Block Diagram OM601480T27_BlockDiagram.pdf Schematic Diagram OM601480T27_SchematicDiagram. pdf Layout Drawing OM601480T27_LayoutDrawing.pdf Tw OE OM601480T27_PartsList.pdf Circuit Description OM601480T27_CircuitDescription.pdf The above exhibits contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Please do not hesitate to contact me if you have any queries. Yours faithfully, Ronin Syndicate LLC T.K. Wong (General Manager)

SEM.Test Compliance Service Co., Ltd. 3/F, Jinbao Commerce Building, Xinan Fanshen Road, Baoan District, Shenzhen, P.R. China LetterforConfirmationoftheTest DateofTests:

ApplicantName:

FCCIDNumber:

NameofEngineerto performtheTests:

StatementforConfirmationof theTests:

20130902 RoninSyndicateLLC FCCID:OM601480T27 LahmPeng(Engineer) GakkikuTechnologyCompanyhiredustoperformthetests. Wedeclarethattestedsamplehasbeentestedinaccordance withthetestmethodidentifiedonthetestreportandourtest engineerwasperformingthetests.Wealsodeclarethatsample compliedwiththerelevantlimits.Allinstrumentationand accessorieswereusedtotestthatsampleforcompliancetothe indicatedtestmethodandthosewerecalibratedregularlyin accordancewithISO17025:2005requirementsbylaboratories accreditedbyA2LA,NVLAPorACLASforthemeasurement parameters. SEM.TestComplianceServiceCo.,Ltd. 3/F,JinbaoCommerceBuilding,Xin'anFanshenRoad, Bao'anDistrict,Shenzhen, P.R.China JandySo(Manager) Themeasurementsweremadeat:

Representativeoftheorganization performingthetests:

Signature:

EmailAddress:

TelNo.:

jandyso@semtest.com.cn

+86 75533663308808

Ronin Syndicate LLC 8100E. Indian School Road, Suite 103, Scottsdale, AZ85251, USA Tel: 602-748-3020 / Fax: 602-264-2786 FCC ID: OM601480T27 POWER OF ATTORNEY 2nd September, 2013 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046. To Whom It May Concern:

We, the undersigned, hereby authorize Gakkiku Technology Company (Dick Chan, Director) and SEM. Test Compliance Service Co., Ltd. (Jandy So, Manager) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Gakkiku Technology Company (Dick Chan, Director) on our behalf shall have the same effect as acts of our own. This authorization expires on 1st December, 2013. PUODCSB IR Kom:Ceh smd elTmCce-TKCB DEBUT Mcoyentarbatocm ater mdsts Anti-Drug Abuse Act. We, Ronin Syndicate LLC, are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853<a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Please do not hesitate to contact me if you have any queries. Yours faithfully, Ronin Syndicate LLC TK Wong (General Manager)