Product Description The OUV 200/601/702 module is a wireless outdoor camera activated by a connected detector. It is designed for use in Videofied security systems. Polyvalent 90 infrared camera 4 infrared LEDs for extended night vision Protection marking IP54 Temprature resistant (-25C/+70C) Transmits check-in/status signal every 8 minutes 8-pin control connector Installation Guidelines For easier installation, programming and RF testing should be done to check for good communication between the control panel and all system devices before mounting system devices. Install the detector and other system devices in the order of the following steps:
> Programming/RF Testing - program detector and all other devices into the control panel and test RF communication from each intended device location to the control panel.
> Mounting - mount detector at the tested location. Mounting instructions
> The module is mounted through 2 backside screw threads (2mm x 7,5 mm).
> Plug the connector to the detector (the use of a short cable is permissible).
> Mount the detector according to the manufacturer recommendations. 1 DOC. - REF. 213-OUVVERSION : JUNE 2016INSTALL SHEETOUV OUTDOOR UNIVERSAL VIEWER Programming/RF Testing/Mounting following provides summarized steps for device The programming, testing, and mounting. For complete details, refer to the control panel installation manual. 1 Put control panel into Programming/Configuration mode. 9 The display shows NAME + LOCATION:
Enter appropriate device name/location (up to 16 characters), then press OK/YES. The display shows the device number and name for your verification. Install the OUV and its detector. Follow the detector 10 manufacturer mounting instructions. 11 Press OK/YES. The display shows FUNCTIONAL DEVICE TEST? Press OK/YES and verify camera operation. The activation of the LED will determine the detection field. 12 Press OK/YES to end detection verification. 13 The display shows OPERATION COMPLETED or ADD A NEW DEVICE? Press YES/OK. Repeat steps 1 12 for remaining cameras. 14 When finished, exit from configuration mode. 2 Using a programmed alphanumeric keypad, proceed through menus until the display shows ADD A NEW DEVICE. Press OK/YES. the display shows PRESS PROGRAM 3 BUTTON OF DEVICE. 4 Apply a voltage on the OUV programming pin (6) through the connected detection device par lintermdiaire de lquipment connect. The OUV blinks. 5 Wait for keypad display to show CAMERA(1 - 25) PROGRAMMED. Press OK/YES, the display shows RADIO RANGE TEST? Press OK/YES again. The camera LED starts flashing and keypad display shows RF TEST. Take the OUV module to its intended mounting location 6 and make sure LED flashes continuously or you receive a 9/9 indicating good communication with the control panel. 7 8 Press OK/YES to end radio range test then press ESC/NO. The keypad displays :
AREA ALLOCATION :
AREA : 1 Press either arrow button repeatedly until desired area number appears then press OK/YES. By default all devices in Area 1 are automatically delayed. Pin 1 2 3 4 5 6 7 8 Name Vcc GND Detect Trouble Armed Config Ext-trouble IR-ON Function Notes and setting Input voltage Ground Intrusion detection Communication lost System armed Programming button Problem on the connected detector Infrared illumination activation 2.8 to 5 VDC 0 V State 1 (>2VDC) during 100 ms while powering the OUV The connected detector must ignore that pin at startup State 0 (<0.5VDC) during 100 ms while powering the OUV 2 INSTALL SHEETOUV OUTDOOR UNIVERSAL VIEWER FCC Regulatory Information for USA and CANADA FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC authorization to operate this equipment. FCC Part 15.105 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
> Reorient or relocate the receiving antenna.
>
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio/TV technician for help. Increase the separation between the equipment and receiver. Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. Cet quipement est conforme aux limites dexposition aux rayonnements IC tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
1 2 This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
1 2 compromettre le fonctionnement. Lappareil ne doit pas produire de brouillage, et Lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den 3 INSTALL SHEETOUV OUTDOOR UNIVERSAL VIEWER ELECTRICAL PROPERTIES VIDEO PROPERTIES Panel compatibility W, XL, XT, XV and their variants Power Power voltage Power consumption Average current consumption Standby current consumption Max current consumption RADIO PROPERTIES RF S2View technology Radio type Operating frequency 8-pin connector 2.8VDC to 5VDC 85 A
< 15 A 350 mA Spread spectrum bidirectionnal 868MHz - OUV 200 (Europe, Africa, Asia) 915 MHz - OUV 601 (USA, Canada, South America) 920 MHz - OUV 702 (Australia, South America) Camera Angle Sensor type Daylight video Night video Infrared illumination Infrared illumination distance Video Video format Frame rate Video duration Video resolution Average video file size Image Format Resolution 90 CMOS Programmable : Color or B&W Automatic black & white infrared Automatic with 4 IR LEDs Up to 12m MJPEG-WMV, MJPEG-DIFF 5 images per second Programmable (10 seconds by default) QVGA (320x240) 220 kb JPEG VGA (640x480) 8 kb AES encryption algorithm Radio, batteries, tamper, position Integrated Average image file size STANDARDS AND CERTIFICATIONS 868MHz (OUV 200) Compliant with the annex IV of the R&TTE Directive 1999/5/EC Polycarbonate and elastomer 43 mm x 20 mm x 26.6 mm 12g
-25/+70C 95%, without condensing IP 54 / IK 06 USA FCC Canada IC 915MHz (OUV 601) 920MHz (OUV 702) Part 15C RSS-247 Issue 1 Australia RCM AS/NZS4268 Transmission security Supervision Radio antenna BOX Physical properties Material Dimensions Weight Environmental data Operating temperature Max. relative humidity Protection marking This symbol on the product or on its packaging indicates that this product should not be treated as household waste. It must be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health. The recycling of materials will help to conserve natural resources. For more information about recycling of this product, please contact your local municipality, your waste disposal service or the company that installed the product. 4 www.videofied.comINSTALL SHEETOUV OUTDOOR UNIVERSAL VIEWEREMEA SALES23, avenue du Gnral Leclerc92340 BOURG-LA-REINEFRANCEE-Mail : emeasales@rsivideotech.comNorth American Headquarters1375 Willow Lake Blvd, Suite 103Vadnais Heights, MN 55110USAE-Mail : usasales@rsivideotech.comThe EC declaration of conformity ofthis product is available by flashingthat QR code :