The Advanced reflex1onm7 Adjustable Bed STEARNS & FOSTER Wireless Hand Remote Operation .
-ontinued Wireless gy is
-_ Wave Massage Adjustments (N)
* Activates both units to wave mode massage. NOTE: You must stop the massage in order to activate another massage setting such as full body or another wave massage. Full Body Massage (M)
* Press to activate both the head and foot massages at the same time. Pre-Programmed Memory Position (G)
* These 3 program function keys allow you to select the most popular positions with 1 touch. Stop Button (L) Hold down for 2 seconds to stop massage. REMEMBER: YOU MUST STOP MASSAGE BEFORE ALTERNATING BETWEEN MASSAGE FUNCTIONS. Under Bed Light (O) Press the button to turn on or off the under bed light. (Button on back of Hand Wand) Remote Features The Wall-Glide Adjustable Bed uses a RF (Radio Frequency) hand control system. NOTE: This bed may show minor intermittent performance because of typical RF interference. This is normal in the operation of the bed, not a defect.
* The buttons are backlit, when a button is pressed, to aid in the visibility of the remote in low light environments.
* It is not necessary to face the receiver to operate the remote control. Remote signal is best transmitted within 9 feet (3 meters) of the receiver. Safety In the case that an overload of weight is placed on the head or foot mechanism, the control unit will automatically stop all functions. The control unit will automatically resume all functions 30 seconds after excess weight is removed.
* Massage motors will automatically shut off after running continuously for 15 minutes. All massage functions will be operational again after 5 minutes. Automatic Shut Off will occur after 15 minutes of continuous use. The input transformer voltage is ACI 20V 60HZ, the output voltage is DC24V 3A. In the case of a short-circuit, a fuse on the transformer will blow to protect the electrical equipment (Fuse: 1A~1.5A.). Should this occur, you MUST seek professional assistance to replace the fuse, Call Customer Care at: 1-877-826-8757 Notice: The changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Important Note: To comply with the FCC RF exposure compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device could result in the device exceeding the RF exposure requirements and void user's authority to operate the device. THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.