FCC ID: 2BDRQRTM-103 RuxTek 4G Portable Router

MiFiRouter Multiple Antennas USB-C Port Battery 2100mAh User Manual 1. Introduction It is a high-performance LTE Mobile Wi-Fi device, with supporting all router functions. User equipment can be connected via Wi-Fi or USB to introduces the enjoy a fast navigation experience. This manual installation and usage of this equipment. For more details about the network connection, please consult your operator. 2. Package contents

-MiFi Router X 1

-Battery X 1

-User Manual X 1

-Warranty card (contained in the user manual) X 1

-USB cable*

*: The USB cable is optional; it depends on the real MiFi you buy. 3. Specifications Communication Mode Standards Connection Availability USB Input Battery Capacity Web UI Working Environment LTE Cat.4 Downlink/Uplink up to 150Mbps/50Mbps IEEE 802.11 b/g/n/ax, 2.4GHz Wi-Fi6 Up to support 12 access points 5V/1A 2100mAh Address: 192.168.0.1 Password: admin Working temperature: 0~+45 Storage temperature: -10~+60 Working humidity: 10%~95%

Storage humidity: 10%~80%

Attention Please observe the following items to avoid any accidental injury, fire or burst:

1. Do not use the device while charging. 2. Do not drop or hit the device. 3. Please do not expose this product to the following environments:

a. High temperature environment or sun exposure environment. b. Dusty, humid or potentially condensing environment. c. Places with strong electromagnetic waves or high magnetic fields. 4. Buttons & Interfaces Dimension: 106mm*63mm*12.5mm Power button 1 2 Signal indicator 3 Wi-Fi indicator Battery status 4 Reset hole, Press the reset button for 5-7s to restore factory 5 settings Charger/USB Type C interface 6 7 Micro-SIM slot 5. Indicator description Name Signal Indicator Wi-Fi Indicator Battery Status Status Constantly Green Green fast flash Red slow flash Constantly Red LED off Constantly Green Green fast flash Constantly Green Constantly Orange Constantly Red Green flash Orange flash Red flash Description Register the network successfully Network searching No network Register failed Wireless function off The Wi-Fi hotspot is enabled Activate WPS and hold the status for 1 minute The battery level is greater than 30%

The battery level is between 10% to 30%

The battery level is less than 30%

Charging and the power > 30%, in this state, when the green light is steady on, indicating that the charging is complete Charging and the battery level is between 10% to 30%

Charging and the battery level is less than 10%

6. Usage scenario 1) Family and dormitory 2) Office and meetings 3) Travel and live broadcast 7. Installation Instructions 7.1 Installation of the Micro SIM card and battery 1) Push to open and remove the rear cover of the device. 2) Put the Micro SIM card into the slot, be mindful of the direction. 3) Put the battery inside with the right direction. 4) Put the cover back of the device and close it. 7.2 Power on/off Power on: Long press the POWER button to turn on the device, the LED will light up. Power off: When the device is on, long press the POWER button to turn off the device. 7.3 Charging By using the charger to connect a USB power supply to the device to charging. 1) Use the USB cable to connect the computer or other equipment to charger the device. 2) Use the charger to connect a USB power supply to the device. Cautions 1. Before plug in and plug out the SIM card, please power off the device first. 2. Please minimize the obstacles between the device and the user terminals. 8. Connection and usage There are two methods to set up the connection: Via USB cable or via Wi-Fi. The SSID and KEY of the device will be posted on the label, or you can obtain this information through the way as below:

Enter the Web UI, enter to settings WLAN settings Basic settings, you will see the information of SSID and KEY. Web UI management interface can help users to manage the device effectively. Here are the steps of how to manage the page. 8.1 Login 1) Power on the device and set up the connection. 2) Start the browser; enter the IP address into the web page in the address bar. 3) In the subsequent pop-up login window, enter the default password admin, click login and you can enter the Web UI management page. 8.2 Web UI Home The home page is as bellow:

Home page will display access to user information list details of the user of the equipment. Direct your mouse to the upper right corner, it will be displayed in sequence from left to right network type, operator, signal strength, messages, SIM card status, Wi-Fi status, battery level and other information. 8.3 Change login password The password can easily be changed. 8.4 Quick Settings On this page you can set up some basic parameters. 1) APN settings 2) SSID The SSID page can be used to turn SSID broadcasting on or off and allows you to change the network name (SSID) 3) Security Mode 4) Click next and the configuration items will be displayed. Click Apply then all connected Wi-Fi devices will need to reconnect when Wi-Fi configuration changes. 8.5 Data Management Click on Data Management and enter into, then you can set the daily, monthly statistic plan. As shown, you can create a flow plan and apply. Warranty Card Dear Customer, thank you for using this product. In order to better serve you, please read, fill in and keep this warranty card after purchasing the product. User information Company or personal name Mailing address Contact number E-mail Product No. Product IMEI No. Date of purchase Invoice No. Distributor name Distributer address Distributer phone Kept by users, no reissuing if lost. Distributor (seal):

1.FCC Regulations:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiated radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. 2.RF Exposure Information (SAR) This device designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC is 1.6W/kg. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines. SAR information on this device is on file with the FCC and can be found under the Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: 2BDRQRTM-103 For body worn operation, this device has been tested and meets the FCC RF exposure guidelines for use with an accessory that contains no metal and the positions the device a minimum of 1 cm from the body. Use of other accessories may not ensure compliance with FCC RF exposure guidelines. If you do not use a body-worn accessory, position the device a minimum of 1 cm from your body when the device is switched on.

RuxT'

Model Wi-Fi Wi-Fi SN: GK1106110390300001 IMEI: 862374057321479 MAC: 14B2E57CA8DE ek 4G Portable Router

: RTM-103 IP Address: 192.168.0.1 Password: admin Name: MiFi_7CA8DE Password: 1234567890 NHN IMUM FE Wm 2BDRQQTM- 103 Made in China 76.0mm WIG '8P FCC ID: 2BDRQRTM-103 RuxT'

Model Wi-Fi Wi-Fi SN: GK1106110390300001 IMEI: 862374057321479 MAC: 14B2E57CA8DE ek 4G Portable Router

: RTM-103 IP Address: 192.168.0.1 Password: admin Name: MiFi_7CA8DE Password: 1234567890 NHN IMUM FE Wm 2BDRQQTM- 103 Made in China 76.0mm WIG '8P

RuxTek 4G Portable Router Model: RTM-103 IP Address: 192.168.0.1 Password: admin Wi-Fi Name: MiFi_DB5617 Wi-Fi Password: 1234567890 2 FCC I: 280 RuxTek 4G Portable Router Model: RTM-103 IP Address: 192.168.0.1 Password: admin Wi-Fi Name: MiFi_7CA8DE Wi-Fi Password: 1234567890 TAU UNMET GK110611039031 wn HLH ui nnn HM FC IMEI: 862374057321479 UU AUI OU AA AA either MAC: 14B2E57CA8DE. Made in China 76.0mm

Date 2023/12/21 Federal Communications Commission Authorization & Evaluation Division 7345 Oakland Mills Road Columbia, Maryland 21046 RE: LETTER OF AGENT AUTHORIZATION To Whom It May Concern:

We, the undersigned, hereby authorize Compliance Testing, LLC to act on our behalf in all matters relating to application for equipment authorization, including the signing of all documents relating to these matters. We also hereby certify that no party to the application authorized hereunder is subject to the denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C.853(a). Sincerely, Name : Title : Manager Applicant Company : RuxTek Co.,Ltd

RuxTek Co.,Ltd DATE :2023-12-21 Equipment Autorisation Division Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 FCC ID: 2BDRQRTM-103 Product Name: RuxTek 4G Portable Router Request for Confidentiality Pursuant to Sections 0.457 and 0.459 of the commissions rules, we hereby request that the following documents be held confidential:

e Schematics e Block diagram e Operation description e Bom e Tune up These materials contain trade secrets and proprietary information and are not customarily released to the public. The public disclosure of this information might be harmful to the company and provide unjustified benefits to our competitors. Dated this 2023-12-21 By: ay [ as Pee Carlos Hsueh Signature Printed Title: manager On behalf of : RuxTek Co.,Ltd Telephone: +886 908 556 835

RuxTek Co.,Ltd Covered Equipment Certification Attestation Letter 12/21/2023 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA ATIN.:

FCC ID: 2BDRQRTM-103 RuxTek Co.,Ltd (the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Note: If the equipment for which the applicant seeks authorization is produced by any of the entities identified on the current Covered List, the applicant should include an explanation on why the equipment is not covered equipment. RuxTek Co.,Ltd (the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List as an entity producing covered equipment. Signed: ares FA. Printed name: Carlos Hsueh Title: Manager Company Name: RuxTek Co.,Ltd Date: 12/21/2023

RuxTek Co.,Ltd U.S. Agent Designation for Service of Process -

Certification Attestation Letter 12/15/2023 TO: Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 ATTN:

FCC ID: 2BDRQRTM-103 FRN of Grantee: 0034526681 Per section 2.911(d)(7) of the FCC rules, RuxTek Co.,Ltd (the applicant) certifies that the equipment for which authorization is sought is designated to the following U.S. agent* for service of process:

Company Name: Stariver Consulting Company FCC Registration Number (FRN): 0033400433 Company Address: 2363 James St #1098 Syracuse, NY 13206, USA Agent Name: Chong He Agent Email Address: stariverusagent@gmail.com The above contact person accepts the obligation for service of process. The applicant accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Applicant Signed:

Agent Signed:

Signed:

Printed name: Carlos Hsueh Title: Manager Company Name: RuxTek Co.,Ltd Date: 12/15/2023 Signed:

Printed name: Chong He Title: Manager Company Name: Stariver Consulting Company Date: 12/15/2023

* the applicant must designate a contact located in the United States for purposes of acting as the applicants agent for service of process, regardless of whether the applicant is a domestic or foreign entity. An applicant located in the United States may designate itself as the agent for service of process.