User manual of CY-LHDE01A 1. Introduction CY-LHDE01A is a ZigBee/ Z-wave Combo module compliant with IEEE802.15.4 MAC/baseband/radio and ITU-T G.9959 optimized for low-power applications. The ZigBee chipset is from Silicon Labs, part number EM357-RTR and Z-wave chipset is from Sigma Designs, part number SD3503. 2. Hardware Architecture:
2.1 Main Chipset Information Item IEEE802.15.4 ITU-T G.9959 Vendor Silicon Labs Sigma Designs Part Number EM357-RTR SD3503 3. Operational Description CY-LHDE01A is the 802.15.4 ZigBee, ITU-T G.9959 Z-wave COMBO Module that acts as a communication controller for users of a wireless device to connect to SMART TV
- Features
> ZigBee 2.4GHz IEEE 802.15.4
> AES128 encryption accelerator
> Low power consumption, advanced management
>On-chip power amplifiers and low noise amplifiers for both bands
> Z-Wave ITU-T G.9959
> Z-Wave 9.6/40/100 kbit/s data rate
>128-bit AES security processor and hardware random number generator
- Time base of the RF frequency For ZigBee IF and RF frequency, a crystal(24MHz) is a clock reference. For Z-wave IF and RF frequency, a crystal(32MHz) is a clock reference.
- ZigBee Transmission The ZigBee Tx path produces an O-QPSK-modulated signal using the analog front end and digital baseband. The area- and power-efficient Tx architecture uses a two-point modulation scheme to modulate the RF signal generated by the synthesizer. The modulated RF signal is fed to the integrated PA and then out of the EM357.
- ZigBee Receiver The ZigBee Rx path uses a low-IF, super-heterodyne receiver that rejects the image frequency using complex mixing and polyphase filtering. In the analog domain, the input RF signal from the antenna is first amplified and mixed down to a 4 MHz IF frequency. The mixers output is filtered, combined, and Version 1.0 Samsung Electronics page 1 of 7 amplified before being sampled by a 12 MSPS ADC. The digitized signal is then demodulated in the digital baseband. The filtering within the Rx path improves the EM35xs co-existence with other 2.4 GHz transceivers such as Zigbee/ 802.15.4-2003, IEEE 802.11-2007, and Bluetooth radios. The digital baseband also provides gain control of the Rx path, both to enable the reception of small and large wanted signals and to tolerate large interferers.
- Z-wave Tranceiver The CY-LHDE01A is a fully integrated module with an on-board antenna that allows the establishment of a Z-Wave network with minimum risk. The SD3503 chip is used with an external NVM (Serial Flash MEM), 32MHz crystal, power supply decoupling, SAW filter, matching circuit, and a PCB pattern Antenna. Version 1.0 Samsung Electronics page 2 of 7
- Product Details
> Data Modulation ZigBee : O-QPSK for 802.15.4 Z-Wave : FSK/GFSK for ITU-T G.9959
> Frequency :
ZigBee Channel 0x0B(11ch) Channel 0x0C(12ch) Channel 0x0D(13ch) Channel 0x0E(14ch) Channel 0x0F(15ch) Channel 0x10(16ch) Channel 0x11(17ch) Channel 0x12(18ch) Channel 0x13(19ch) Channel 0x14(20ch) Channel 0x15(21ch) Channel 0x16(22ch) Channel 0x17(23ch) Channel 0x18(24ch) Channel 0x19(25ch) Channel 0x1A(26ch) 2405 MHz 2410 MHz 2415 MHz 2420 MHz 2425 MHz 2430 MHz 2435 MHz 2440 MHz 2445 MHz 2450 MHz 2455 MHz 2460 MHz 2465 MHz 2470 MHz 2475 MHz 2480 MHz Z-wave Version 1.0 Samsung Electronics page 3 of 7
- Product pwr Spec. Symbol VDD Parameter Power supply Min 4.5 Typ. 5 Max 5.5 Unit V
- Product Spec.
> ZigBee Parameter Min Typ. Max Unit RF Characteristics RF Frequency Range Output power TX Frequency Tolerance TX Spurious Emission 30.0MHz to 2.395GHz 2.495GHz to 12.75GHz TX Harmonics 2nd Harmonics 3rd Harmonics Error Vector Magnitude(EVM) RX sensitivity PER at -85dBm RX Spurious Emission 30.0MHz to 12.5GHz
> Z-wave Parameter RF Characteristics(NA) RF Frequency Range Output power TX Frequency Tolerance TX Harmonics RX sensitivity 2nd Harmonics 3rd Harmonics PER at -85dBm RX Spurious Emission 30.0MHz to 12.5GHz 2.405
-
-74.4
-
-
-
-
-
-
-
-
-
-
-
-
-
GHz dBm KHz dBm dBm
%
%
2.4835
+8 74.4
-30
-30 35 1
-54 dBm Min Typ. Max Unit 908.4
-
-45.8
-
-
-
-
-
-
-
-
-
916.0
-4 45.8
-30 3 MHz dBm KHz dBm
%
-54 dBm Version 1.0 Samsung Electronics page 4 of 7 4. Installation Guide
- Contents 1) Users connect the dongle to the USB port in TV. 2) This module describes the information in connection with the end device of the zigbee or z-wave.
(presence sensor, open/close sensor, Etc.)
- Installation Figure Version 1.0 Samsung Electronics page 5 of 7 5. Notice : FCC and IC radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Cet quipement est conforme aux IC RSS-102 des limites dexposition aux rayonnements dfinies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de la classe B est conforme la norme NMB-003 du Canada. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes : (1) lappareil ne doit pas produire de brouillage, et (2) lutilisateur de lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. The device could automatically discontinue transmission in case of absence of information to transmit, or operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the use of repetitive codes where required by the technology. FCC Statement All other devices shall bear the following statement in a conspicuous location on the device:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation. The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning t he equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC Caution:
Any changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
Version 1.0 Samsung Electronics page 6 of 7
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. Version 1.0 Samsung Electronics page 7 of 7