The ID switch as shown below is located on the backside of the keyboard. > @
@ The ID switch as shown below is located on the backside of thea mouse. > @
(2) a t]
RF Internet Keyboard/Mouse ID Setting 1.Keyboard ID setting. To boot the keyboard, click the button on the receiving part. And then click the button on the keyboard within 5 seconds, and kayboard ID Setting will ba completed.
(The button is located om the backside of the keyboard.) 2. Mouse ID setting. To boot the mouse, click the bution on the receiving pat. And then click the button on the mouse within 5 seconds, and mouse ID Setting will be completed.
(The button is located om the backside of the mouse.) Notice) If the mouse or the keyboard does not work, repeat the ID setting, Caution) When a battery is inserted inversely or when an inappropriate type inserted, there will be danger of fire or explosion, Throw away a battery out of use to an appointed waste container. Troubleshooting The keyboard and mouse dont work properly after installation, Make sure the recaiver has been plugged correctly to the PS/2 keyboard and mouse port. Please check the cable with the keyboard icon goes inte the keyboard port and the cable with the mouse icon goes into ihe mouse port. For the best performance, please place the receiver al least B inches or 20 centimeters away from the computer, the computer moniter, or other electrical devices.
@ Make sure the battery has been installed properly. and not discharged, Ona metallic surfaca, the receiver may nol work property. Try to adjust the receiver 5 peaition te and fro to optimize RF transmission,
@ Make sure you have set up correctly the configuration of the P52 keyboard and mouse port. Otherwise, they may be conflicted with other system devices. Check the IRQ/address sattings of these devices for conflicts, and change the settings right, FCC NOTE This device complies with part 15 a0fthe FOG Rules. Operation is subject to the following two conditions:
(This device may not cause hannful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authonty to operate the equipment NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant te part 15 of the FOC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, The equipment generates, uses and can radiate frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is mo guarantee that interference will not occur in a particular installation, if this equipment does cause harmful interference to radio or television reception, which can be determined by the tutning quipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorent or relocate the receiving antenna, Increase the separation betwean the equipment and receiver, Connect the equipment inte an outlet on a circuit different from that to which the receiver connected, Consult the dealer or an experienced radio/TV technician for help,