The ID switch as shown below is located on the backside of the keyboard. > @
& The ID switch as shown below Is located on the backside of tha mouse. > &
(2) a 2 RF Internet Keyboard/Mouse ID Setting 1.Keyboard ID setting. To boot the keyboard, click the button on the receiving part. And then click the button on the keyboard within 5 seconds, and keyboard ID Setting will ba completed.
(The button is located om the backside of the keyboard.) 2. Mouse ID setting. To boot the mouse, cick the button on the receiving part. And then click the button on the mouse within seconds, and mouse ID Setting will be completed.
(The button is located om the backside of the mouse.) Netioe) Ifthe mouse or the keyboard does mot work, repeat the 1D setting, Caution) When a battery is ingerted inversely or when an inappropriate type inserted, there will be danger of fire or explosion, Throw away @ battery out of use to an appointed waste container. Troubleshooting The keyboard and mouse dont work properly after installation, Make sure the receiver has been plugged cormectly to the PS!2 keyboard and mouse port. Please check the cable with the keyboard icon goes inte the keyboard port and the cable with the mouse icon goes inte the mouse port For the best performance, please place the receiver at loast 8 inches or 20 centimeters away from the computer, the computer moniter, or other electrical devices.
@ Make sure the battery has been installed properly, and mot discharged, Ona metallic surfaca, the receiver may not work property. Try to adjust the raceiver 6 position to and fro to optimize RF transmission, Make sure you have setup cormectly the configuration of tha PS/2 keyboard and mouse port. Otherwise, they may be conflicted with other sysiem devices. Check the IRO/address settings of these devices for conflicts, and change the settings right, FCC NOTE This device complies with part 1S afthe FCC Rules. Operation is subject to the following two conditions:
(This device may not cause hannful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION Any changes or modifications in construction of this device which are not expressly approved by the party responsible for compliance could void the user's authonty to operate the equipment NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant te part 15 of the FCC Rules. These limits are designed to provide reasonable protection againal harmful interference in a residential installation, The equipment generates, uses and can radiate frequancy energy and, if net installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantes that interference will not occur in a particular installation, If this equipment does cause harmful interference to radio of television reception, which can be determined by the turning quipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures;
Reorient or relocate the receiving antenna, Increase the separation between the equipment and receiver, Connect the equipment into an outlet on a circuit diferamt from that to which the receiver connected, Consult the dealer or an experienced radio/T technician for help.