FCC ID: ZCASMR220 Wearable Device

Package contents Galaxy Fit2 USB cablecharging dock Device layout The items supplied with the Galaxy Fit2 and their images may vary by region. Quick start guide After purchasing the Galaxy Fit2 , connect the charger to turn on the power. You must first charge the battery sufficiently. After fully charging your Galaxy Fit2, pull on the handle of the charger to disconnect it. To view the full user manual and the full safety information, including device and battery disposal instructions, launch the Galaxy Wearable app on your mobile device and tap User manual. Or, visit www.samsung.com/ca. When measuring your heart rate, wear the Galaxy Fit2 snugly on your arm above your wrist as shown in the figure below. Do not fasten the Galaxy Fit2 too tightly. When taking off the Galaxy Fit2 , pull down on the buckle and pull it out as shown in the figure below. Charging the battery Accessing more information Notice for measuring the heart rate Taking off the Galaxy Fit2 USB cablecharging dock The method for accessing the user manual from the Galaxy Wearable app may vary depending on your mobile device. The user manual may not be available depending on the web browser or service provider. Use only Samsung-approved chargers. The Galaxy Fit2 has no separate power key and is powered on when the battery Pressure vent The charger should remain close to the electric socket and be easily accessible is charged. while charging. Connecting the Galaxy Fit2 to a mobile device On your mobile device, launch Wearable app, launch it, and then follow the on-screen instructions to complete the connection. Galaxy Store Play and download the Galaxy or Connection methods and screen may vary depending on your mobile device and software version. Supported mobile devices and features may vary depending on your region, service provider, and device manufacturer. The accuracy of the heart rate sensor can be affected depending on the users movements, personal physiology, and the measurement conditions and surroundings. Take heart rate measurements when you are seated and relaxed. Do not look directly at the heart rate sensors lights. Doing so may impair your vision. If your device becomes hot to the touch, please remove it until it cools. Exposing skin to a hot surface of the device for a long time may cause skin burn. Quick Start Guide SM-R R375_QSG_CA_ENG_2.indd 1 Printed in Korea GH68-50109K Rev.1.1 English (CA). 05/2019 Do not insert sharp objects into the pressure vent. Inner components of the Galaxy Fit2 may be damaged along with the water-resistance feature. Charging contacts 5/4/2019 6:02:16 AM If the Galaxy Fit2 is frozen and unresponsive, connect the charger for more than 3 seconds to restart it. Correct disposal Follow the warnings below to prevent injury to people or damage to the device If the device is dropped or receives an impact , the water- and dust-resistant features of the device may be damaged. Some features may not work properly if the device is used in water

. Acknowledging Special Precautions and ISED (Innovation, Science and Economic Development Canada) Notice This device contains a Li-Ion battery. For safe disposal options, contact your nearest service centre. For information on battery replacement, please contact your service provider. Do not disassemble, crush, or puncture the device. Do not dispose of it in re. Be sure to dispose of your device properly. In some areas, the disposal of batteries in household or business trash may be prohibited. For safety, do not handle the device if the Li-Ion battery is damaged or leaking. For information on Samsungs environmental commitments and product regulatory obligations, visit our sustainability page available via www.samsung.com/ca. FCC Part 15.19 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Safety information FCC RF Radiation Exposure Statement Read all safety information before using the device to ensure safe and proper use. This equipment complies with FCC RF Radiation exposure limits set forth for an uncontrolled environment. This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. Warning Some content may di er from your device depending on the region, service provider, or software version, and is subject to change without prior notice. This product includes certain free/open source software. To see the instructions for viewing the open source licence, go to the Samsung website (opensource.samsung.com). Copyright 2019 Samsung Electronics R375_QSG_CA_ENG_2.indd 2 Follow the warning information provided below to prevent incidents such as fire or explosion Do not expose the device to physical impact or damage. Use manufacturer-approved chargers, accessories, and supplies. Prevent the battery terminals from contacting conductive elements, such as metal or liquids. If any part of the device, such as the glass or acrylic body, is broken, smokes, or emits a burning odour, stop using the device immediately. Use the device again only after it has been repaired at a Samsung Service Centre. Do not allow children or animals to chew or suck the device. The device can be used in locations with an ambient temperature of 0 C to 35 C. You can store the device at an ambient temperature of -20 C to 50 C. Using or storing the device outside of the recommended temperature ranges may damage the device or reduce the batterys lifespan. Do not use your device in a hot environment or near re. Comply with all safety warnings and regulations regarding mobile device usage while operating a vehicle. Do not wear the device too tightly. Make sure to keep the device clean and dry. Though this device has met international safety standards, some people may experience skin irritation if they are allergic to certain substances. It is recommended not to us result in afterimages (screen burn-in) or ghosting. xed graphics on part or all of the screen for extended periods. Doing so may Maintaining water and dust resistance Your device supports water- and dust-resistance. Follow these tips carefully to maintain the water- and dust-

resistance of your device. Failure to do so may result in damage to your device. Do not expose the device to water moving with force. Do not use your device when you dive into the water, snorkel or try any water sports in fast owing water. If the device or your hands are wet, dry them thoroughly before handling the device. If the device is exposed to fresh water, dry it thoroughly with a clean, soft cloth. If the device is exposed to other liquids, such as salt water, swimming pool water, soapy water, oil, perfume, sunscreen, hand cleaner, or chemical products such as cosmetics, rinse it with fresh water and dry it thoroughly with a clean, soft cloth. If you do not follow these instructions, the devices performance and appearance may be a ected. Removing the battery To remove the battery, contact an authorized service centre. For your safety, you must not attempt to remove the battery. If the battery is not properly removed, it may lead to damage to the battery and device, cause personal injury, and/or result in the device being unsafe. Samsung does not accept liability for any damage or loss (whether in contract or tort, including negligence) which may arise from failure to precisely follow these warnings and instructions, other than death or personal injury caused by Samsungs negligence. Cautions Any changes or modi cations to your device not expressly approved by Samsung could void your warranty for this equipment, and void your authority to operate this equipment. Only use approved batteries, antennas, and chargers. The use of any unauthorized accessories may be dangerous and void the device warranty if said accessories cause damage or a defect to the phone. Although your device is quite sturdy, it is a complex piece of equipment and can be broken. Avoid dropping, hitting, bending, or sitting on it. Information to User This equipment has been tested and found to comply with the limits of a Class B digital device. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation; if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o encouraged to try to correct the interference by one or more of the following measures:

Reorient/relocate the receiving antenna. Connect the equipment to an outlet on a circuit di erent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Increase the separation between the equipment and receiver. nd on, the user is Specific Absorption Rate (SAR) certification information Your device conforms to ISED (Innovation, Science and Economic Development Canada) standards that limit human exposure to RF (radio frequency) energy emitted by radio and telecommunications equipment. These standards prevent the sale of mobile devices that exceed a maximum exposure level (known as the Speci c Absorption Rate, or SAR) of 1.6 W/kg (head and trunk) and 4.0 W/kg (limbs). More SAR information can be accessed online on ISEDs website ic.gc.ca/eic/site/ceb-bhst.nsf/eng/h_tt00084.html. In normal use, the actual SAR is likely to be much lower, as the device has been designed to emit only the RF energy necessary to transmit a signal to the nearest base station. By automatically emitting lower levels when possible, your device reduces your overall exposure to RF energy. Depending on the region or model, some devices are required to receive approval from Innovation, Science and Economic Development Canada (ISED)/the Federal Communications Commission (FCC). If your device is approved by the ISED/FCC, you can view the ISED/FCC ID of the device and the speci c SAR levels at the following ISED website: sms-sgs.ic.gc.ca/equipmentSearch/searchRadioEquipments. ISED Notice This device complies with ISED (Innovation, Science and Economic Development Canada) licence exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause interference. the device. 2. This device must accept any interference, including interference that may cause undesired operation of 5/4/2019 6:02:17 AM

S/N:0000000000 FCC ID : ZEASMR220 PO BOX 12987,Dublin JE SM-R220 Rated:5 V==;150 mA Madeihchina _ _

Authority to Act as Agent Date: __0706,2020_____ American Certification Body, Inc. 6731 Whittier Avenue Suite C110 McLean, VA 22101 To Whom It May Concern:

______(CTTL,Telecommunication Technology Labs,CAICT)______ is authorized to act on our behalf, until otherwise notified, for applications to American Certification Body, Inc. (ACB). We certify that we are not subject to denial of federal benefits, that includes FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Further, no party, as defined in 47 CFR 1.2002 (b), to the application is subject to denial of federal benefits, that includes FCC benefits. Thank you, Agency Agreement Expiration Date: _____12 months_____ By:

______ ______ _____Jenni Chun_________

(Signature1)

(Print name) Title:

______General Manager________ On behalf of: __Samsung Electronics American,Inc___

(Company Name) Telephone:

___973-808-6375____ 022818 11 1 - Must be signed by applicant contact given for applicant on the FCC site, or by the authorized agent if an appropriate authorized agent letter has been provided. Letters should be placed on appropriate letterhead. Request for Confidentiality Date: _0706,2020__ Subject: Confidentiality Request for: ____FCC ID: ZCASMR220____ Pursuant to FCC 47 CFR 0.457(d) and 0.459 and IC RSP-100, Section 9.4, the applicant requests that a part of the subject FCC application be held confidential. Type of Confidentiality Requested Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Short Term Permanent Permanent *2 Permanent Permanent Permanent Permanent Permanent *3 Exhibit Block Diagrams External Photos Internal Photos Operation Description/Theory of Operation Parts List & Placement/BOM Tune-Up Procedure Schematics Test Setup Photos Users Manual _____SAMSUNG Electronics______ has spent substantial effort in developing this product and it is one of the first of its kind in industry. Having the subject information easily available to "competition" would negate the advantage they have achieved by developing this product. Not protecting the details of the design will result in financial hardship. Permanent Confidentiality:

The applicant requests the exhibits listed above as permanently confidential be permanently withheld from public review due to materials that contain trade secrets and proprietary information not customarily released to the public. Short-Term Confidentiality:

The applicant requests the exhibits selected above as short term confidential be withheld from public view for a period of __180___ days from the date of the Grant of Equipment Authorization and prior to marketing. This is to avoid premature release of sensitive information prior to marketing or release of the product to the public. Applicant is also aware that they are responsible to notify ACB in the event information regarding the product or the product is made available to the public before the requested period has expired. ACB will then release the The asterisked items (*) require further information to be provided to ACB before permanent confidentiality will be extended to these exhibits. Please refer to FCC KDB 726920 and the specific Document link for D01 found at:

https://apps.fcc.gov/oetcf/kdb/forms/FTSSearchResultPage.cfm?switch=P&id=41731 and review section II, 3) regarding specific information that must accompany these requests. documents listed above for public disclosure pursuant to FCC Public Notice DA 04-1705. NOTE for Industry Canada Applications:

regarding specific information that must accompany these requests. 022818 11 IC currently only distinguishes Permanent Confidentiality exhibits as shown above. Short Term confidentiality is not considered applicable to IC applications. Sincerely, By:

/General Manager______

(Signature/Title3) ___Jenni Chun____

(Print name) 3 - Must be signed by applicant contact given for applicant on the FCC site, or by the authorized agent if an appropriate authorized agent letter has been provided. Letters should be placed on appropriate letterhead. 022818 11