FCC ID: 2AQZU-18052 CEILING FAN REMOTE CONTROL

CEILING FAN REMOTE CONTROL MANUAL LEARNING PROCESS NOTEThe Hand Held Remote Control System is equipped with a learning frequency function which has code combinations to prevent potential interference from other remote units Step: 1 Open the remote battery cover and install DC12V,23A 1pc battery Step: 2 Within 30 seconds of turning the Receivers AC power ON. Step: 3 Press and hold remote LEARN key for over 3 seconds, once the receiver has detected the frequency, Then fan turn on low speed and light turn off. This will indicate the receiver has learned the frequency that was previously selected on the transmitter. NOTE: After the AC power is on, do not press any other button on the transmitter before setting learning. Doing so will cause the procedure to fail. After completing the steps above, you should be able to operate the ceiling fan and light. If the fan is not responding to the transmitter, please turn the power off to the receiver. And repeat step 1 and 2. NOTE: Remove the battery if not used for long periods of time to prevent damage to the hand held remote. FUNCTIONS OF TRANSMITTER 1. To turn the fan off. 2. :Turn on ceiling fan at high speed 3. : Turn on ceiling fan at medium speed. 4. : Turn on ceiling fan at low speed. 5. : Tap once to activate. Light on ceiling fan blinks once to confirm Walk Away Delay is active. The light turns off after 1 minute. Press any key to cancel function. 6. : Home Shield--Press and hold button to activate. Light on ceiling fan blinks two times to confirm Home Shield is active. Fan remains off and the light randomly turns on for a minimum of 5 minutes and a maximum of 20 minutes. The light remains off for 60 minutes between events. To deactivate press any button once 7.

: NATURAL FLOW, press the button for set fan speed change automatically. Press Fan Speed to deactivate. 8. Press and release immediately to turn on or off the light DIMMER- Press and hold to dim or brighten lights to the desired level and release. 9. When pressing remote button, the LED indicator would be on. If you press remote button and LED indicator would not be on, you should change new DC12V,23A 1pc battery. To assure continued FCC compliance:

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver.

--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or an experienced radio/TV technician for help. CAUTION:

To assure continued FCC compliance:

Any changes or modifications not expressly approved by the grantee of this device could void the user's authority to operate the equipment. Model: TRA049G1M FCC ID2AQZU-18052 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Warning NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Reference No.: WTH23X12275817W Page 1 of 9 ANNEX EXHIBIT 1 - PRODUCT LABELING Proposed FCC ID Label Format FCC ID: 2AQZU-18052 Specifications: The label shall be securely affixed to a permanently attached part of the device, in a location where it is visible or easily accessible to the user, and shall not be readily detachable. The label shall be sufficiently durable to remain fully legible and intact on the device in all normal conditions of use throughout the devices expected lifetime. Proposed Label Location on EUT FCC ID Label Location Waltek Testing Group (Shenzhen) Co., Ltd. Http://www.waltek.com.cn

Satellite No.8, - - Chuang Ye Road, Torch- --Development

Shan)Ltd. Electronic(Zhong

Zone, Zhongshan, Guangdong, China

Date: 2024-01-10 Federal Communications Commissio Authorization and Evaluation Division 7 435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements Part 2.911 (d) (5) (i) Filing SUBJECT: FCC Application for FCC ID: 2AQZU-18052 To Whom It May Concern:

Satellite Electronic(Zhong Shan)Ltd. certesthat the equipment for which authorization is sought is not

"covered"

equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, S

.19 t o n a ry he a n e z a gn a M rJe gn

Satellite No.8, - - Chuang Ye Road, Torch- --Development

Shan)Ltd. Electronic(Zhong

Zone, Zhongshan, Guangdong, China

Date: 2024-01-10 Federal Communications Commission Authorization and Evaluation Division 7 435 Oakland Mills Road Columbia, MD 21046 USA Ref: Attestation Statements Part 2.911 (d) (5) (ii) Filing SUBJECT: FCC Application for FCC ID: 2AQZU-18052 To Whom It May Concern:

Electronic(Zhong Satellite not identedon the Covered List (as a speccally that, as of the date of the fingof the application, as an or any of its subsidiaries named entity Shan)Ltd. certifies or affiliates) the applicant is entity producing "covered"

equipment. Sincerely, y S

.19 ot n a e a n ry he gJn M na ega rJ

Satellite No.8, - - Chuang Ye Road, Torch- --Development

Shan)Ltd. Electronic(Zhong

Zone, Zhongshan, Guangdong, China

Date: 2024-01-10 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 SUBJECT: FCC Application for FCC ID: 2AQZU-18052 Request Confidentiality To whom it may concern, Pursuant to the provisions of the Commission's rules Title 47 Sections 0.457 and0.459, we are requesting the Commission to withhold the following attachment(s) as confidential documents from public disclosure indefinitely BlockDiagram Tune-UpInformation Operational Description Security Information Schematics PartsList SoftwareDefined Radio (SOR) Information T he above materials contain trade secrets not customarily and proprietary information released to the public. The public disclosure of these materials may be hamfulto the applicant and provide to its unusedbenefits competitors. In additional to above mentioned documents, in order to comply with the marketing regulations in Title 47 CFR 2.803 and the importation rules in Tle47 CFR2.1204, while ensuring that business sensitive information remains confidential until the actual marketing of newly authorized devices, we request Short Term Confidentiality attachment(s);

of the following D External Internal Photos Photos TestSetup Photos D User Manual D For 45 days, pursuant or to Public Notice DA 04-1705. D For 180 days pursuant The opplicant to KDB 726920 001. that pursuant understands to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely,

.19 e M s ls ana eg rJ

Satellite No.8, - - Chuang Ye Road, Torch- --Development

Shan)Ltd. Electronic(Zhong

Zone, Zhongshan, Guangdong, China

Date: 2024-01-10 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 SUBJECT: FCC Application for FCC ID: 2AQZU-18052 POWER OF ATTORNEY To Whom It May Concern:

We, the undersigned, heebyauthorize Waltek Testing Group (Shenzhen) Co., Ltd. Jandy So on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Waltek Testing Group (Shenzhen) Co., Ltd. Jandy So on our behalf shall have the same effect as acts of our own. This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, Satellite Electronic(Zhong Shan)Ltd. are not subectto a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section Sincerely, Signatory

[sean zheng, Manager]

Satellite Electronic(Zhong Shan)Ltd. No.8, Chuang Ye Road, Torch Development Zone, Zhongshan, Guangdong, China Date: 2023-09-05 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 USA Ref: Attestation Statements Part 2.911(d) (7) Filing Grantee Code: 2AQZU Applicant FRN: 0027796747 Satellite Electronic(Zhong Shan)Ltd. certifies that, as of the date of the filing of the application, Oriental Industries Group is our designated U.S. agent for service of process for the above referenced Grantee Code. Satellite Electronic(Zhong Shan)Ltd. accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Oriental Industries Group accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced Grantee Code. Designated U.S. Agent Information:

Name: Oriental Industries Group U.S. Agent FRN: 0033523226 Address: 1639 Clarks Lane SanchezJose, CA 95129 United States Contact Person: Mr Simon Kang Chen Tel.: (650) 433-6921 Email: simonkchen@gmail.com Sincerely, Signed on behalf of Satellite Electronic(Zhong Signed on behalf of Oriental Industries Group Shan)Ltd. Name: sean zheng Name: Simon Kang Chen Title: Manager Title: President Date: 2023-09-05 Date: 2023-09-05