FCC ID: PUU-A19-DMSWIV LED LAMP (BT/WiFi)

FCC ID:PUU-A19-DMSWIV GE Connected A19 CLEDA199LD1, input 120Vac, frequency was 60Hz, high efficiency, safety & stability output. Use Bluetooth 4.2 and Wi-Fi 2.4G Hz chip technology to realize the far distance control. Through the APP to control the PWM signal to dim and even control the switch on & off of the bulb. Product features:

1. Controlled by Bluetooth 4.2 and 2.4G Wi-Fi to realize the far distance control. 2. CCT is 2700K. 3. With advanced chips to make sure the bulb with high efficiency, low consumption and stability. 4. Internal constant current output to make sure the high power conversion efficiency and stability output. Product Name LED LAMP Brand Name GE Model No. CLEDA199LD1@

Working Voltage 120Vac Bluetooth Specification Version 4.2 Wi-Fi Specification 2.4G Hz Frequency Range 2400- 2483.5MHz Channel Number Bluetooth Channel Separation Bluetooth Type of Modulation Bluetooth 40 2MHz GFSK Data Rate Bluetooth 1Mbps(GFSK) Channel Number Wi-Fi 11 Channel Separation Wi-Fi 5MHz Data Rate Wi-Fi 802.11g: 54,48,36,24,18,12,9,6 Mbps 802.11n: up to 20Mbps 802.11b:11, 5.5,2,1 Mbps Antenna Type PCB Antenna Peak Antenna Gain Bluetooth 0dBi Peak Antenna Gain Wi-Fi 0dBi For additional help, regulatory and safety Information, please go to:

Federal Communications Commission (FCC) Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired operation. The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the users authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. CAUTION:

- DO NOT USE WITH STANDARD DIMMERS, SEE INSTRUCTIONS

-NOT FOR USE IN TOTALLY ENCLOSED LUMINAIRES

-SUITABLE FOR DAMP LOCATIONS

-THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS Only use the control provided with or specified by these instructions to control this lamp. This lamp will not operate properly when connected to a standard (incandescent) dimmer or dimming control. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Radiation Exposure Statement:

This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20 cm between the radiator & your body. Dclaration d'exposition aux radiations:

Cet quipement est conforme aux limites d'exposition aux rayonnements IC tablies pour un environnement non contrl. Cet quipement doit tre install et utilis avec un minimum de 20 cm de distance entre la source de rayonnement et votre corps.

FCC ID:PUU-A19-DMSWIV 35 1.58mm 1.3mm FCC ID:PUU-A19-DMSWIV IC:10798A-DMSWA19IV IC HVIN:CLEDA199LD1C MADE IN CHINA YYDDDTS 1.3mm 800 LUMENS 9.5W 95mA 120V 60Hz 2700K CLEDA199LD1 LED LAMP 4US7 2.28mm 1.3mm DO NOT USE WITH STANDARD DIMMERS,SEE INSTRUCTIONS NOT FOR TOTALLY ENCLOSED OR RECESSED LUMINAIRES FOR DAMP LOCATIONS NE PAS UTILISER AVEC DES 1.3mm GRADATEURS STANDARD.SE REPORTER AUX INSTRUCTIONS

-NE PAS UTILISER DANS UN LUMINAIRE ENCASTRE OU FERME-CONVIENT AUX EMPLACEMENTS HUMIDES 20.5 9 32.5 20.5 9

Savant Technologies LLC, dba GE Lighting, a Savant Company Ad-Hoc Country Code Cover Letter We, Savant Technologies LLC, dba GE Lighting, a Savant Company, declare that this EUT FCC ID:PUU-A19-DMSWIV doesnt have Ad Hoc Mode function on non-US/Canada frequencies. In addition, the frequency selection feature is disable by firmware for device marketed to the US/Canada. For DTS part of this device, only channel 1~11 will be used in North America. Country code selection is disabled. Should you have any questions or comments regarding this matter, please have my best attention. Sincerely yours, ___________________ Paul Smith Tel: 2162662189 Fax:2162663003 Email: paul.smith@ge.com Company nameSavant Technologies LLC, dba GE Lighting, a Savant Company

Savant Technologies LLC, dba GE Lighting, a Savant Company Date:05/17/2021 To:

Federal Communications Commission, Authorization & Evaluation Division, 7435 Oakland Mills Road, Columbia, MD 21046 Re: Request of Confidentiality for FCC ID:PUU-A19-DMSWIV To Whom it may concern:

Pursuant to sections 0.457 and 0.459 of Commissions Rules(CFR 47), and Section 552(b)(4) of the Freedom of Information Act, Savant Technologies LLC, dba GE Lighting, a Savant Company hereby requests confidentiality and treatment of certain information accompanying this application. The materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. We are also hereby request Short-Term Confidentiality till date 10/14/2021(max time 180 days from grant date) as outlined in Public Notice DA04-1705. This provision will give Savant Technologies LLC, dba GE Lighting, a Savant Company temporary confidentiality of commercially sensitive information prior to product release. The requested Permanent and Short-Term Confidential exhibits are listed as follows:

PERMANENT AND SHORT-TERM CONFIDENTIAL LIST PERMANENT SHORT-TERM Exhibit 1 2 3 4 6 7 8 9 Description Block Diagram Operational Description Schematics BOM External Photos Internal Photos Test-Setup Photos User Manual The Applicant understands that pursuant to Rule 0.457, disclosure of this application and all accompanying documentations, where applicable, will not be made public before the date of the Grant for this application. NamePaul Smith Company nameSavant Technologies LLC, dba GE Lighting, a Savant Company Address1975 Noble Road Cleveland Ohio United States 44112 Tel 216 266 2189 Emailpaul.smith@ge.com

Savant Technologies LLC, dba GE Lighting, a Savant Company Date: 05/17/2021 To: Federal Communications Commission, Authorization & Evaluation Division, 7435 Oakland Mills Road, Columbia, MD 21046 To Whom It May Concern:

The Savant Technologies LLC, dba GE Lighting, a Savant Company, the undersigned, hereby authorizes Mr. Qijie Xiao from Kehu-Morlab Test Laboratory to act on the behalf of the Savant Technologies LLC, dba GE Lighting, a Savant Company solely in matters relating to the application for an FCC equipment authorization for FCC ID: PUU-A19-DMSWIV including the signing of documents in connection with this Application. Necessary acts carried out Kehu-Morlab Test Laboratory on our behalf of the Savant Technologies LLC, dba GE Lighting, a Savant Company in connection with the Application shall have the same effect as acts of the f Savant Technologies LLC, dba GE Lighting, a Savant Company. Savant Technologies LLC, dba GE Lighting, a Savant Company also hereby certify that no party to this application is subject to a denial of benefits, including FCC benefits, pursuant to Section 5301 of the Anti-Drug Abuse Act of 1988, 21 U.S.C. 862. Thank you for your attention to this matter. Yours Sincerely, Contact name: Paul Smith Title: Systems Engineer Safety & Regulatory Tel: 216 266 2189 Email: paul.smith@ge.com Company name: Savant Technologies LLC, dba GE Lighting, a Savant Company