Maintenance heat. Place the unit on a level surface away from sources of direct sunlight or excessive Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents such as thinner or similar materials can damage the surface of the unit. A Consumer Guide to Product Safety IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1. Water and Moisture The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Ventilation The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the flow of air through the ventilation openings. 3. Heat The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat. 4. Power Sources The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 5. Power-Cable Protection Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. 6. Cleaning The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions. 7. Objects and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. 8. Attachments Do not use attachments not recommended by the product manufacturer. 9. Lightning and Power Surge Protection Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges. 10. Overloading Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in a risk of fire or electric shock. 11. Damage Requiring Service The unit should be serviced by qualified service personnel when:
A. the power supply cable or plug has been damaged. B. objects have fallen into or liquid has been spilled into the enclosure. C. the unit has been exposed to rain. D. the unit has been dropped or the enclosure damaged. E. the unit exhibits a marked change in performance or does not operate normally. 12. Periods of Nonuse If the unit is to be left unused for an extended period of time, such as a month or longer, the power cable should be unplugged from the unit to prevent damage or corrosion. 13. Servicing The user should not attempt to service the unit beyond those methods described in the users operating instructions. Service methods not covered in the operating instructions should be referred to qualified service personnel. Questions? Visit www.ekids.com Model: Li-B17E7 (Front) IB (English) Size: 432Wmm x 200Hmm Color: Print in Black color Date: May 20, 2019 Limited 1 Year Warranty Information eKids, LLC warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to first return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, eKids will repair or, at its discretion, replace this product without charge. This decision is subject to verification of the defect or malfunction upon delivery of this product to the Factory Service Center authorized by Customer Service. If service is required, please call Customer Service at 1-800-288-2792 to obtain a Return Authorization Number and shipping instructions. A copy of the sales receipt is required to validate in-warranty coverage. Disclaimer of Warranty NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been modified or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CDs or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner. This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser. In no event will eKids or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost profits, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Your acknowledgement and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your eKids product. Questions? Visit www.ekids.com For any other questions: 1-800-288-2792 Toll Free
& Lucasfilm Ltd. Used Under License. eKids, LLC Internal Rechargeable Lithium-ion Battery This device uses an internal rechargeable lithium-ion battery that should last the lifetime of the device. If you suspect your battery may be dead, try charging it several times. If the battery does not recharge, please contact us for repair information. WARNING/DISPOSAL OF UNIT Please do NOT attempt to change the battery yourself. If the battery has died and you do not want us to replace your battery, you should follow the disposal instructions below:
Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances. Always dispose of used batteries/electronics in accordance with the prevailing community regulations that apply to the disposal of batteries/electronics. If there are no local regulations concerning battery/electronics disposal, please dispose of the device in a waste bin for electronic devices. Many electronics retailers now recycle batteries and other electronic components at no charge. Check to see which ones in your area do so. mistreated in any way abnormal. of alkaline solution or other electrolytic substance. charge the battery. CAUTION The battery used in this device may present a risk of fire, explosion or chemical burn if Never use or charge the battery if it appears to be leaking, discolored, deformed, or Never disassemble the unit or attempt to remove battery as that could cause leakage Always confirm that the temperature is 5C 35 C (41 - 95 Fahrenheit) before you Leakage or deterioration of the battery may occur if this warning is not heeded. Never expose the battery to any liquid. Never expose the battery to excessive heat such as direct sunlight or fire.Never use the battery pack in an unventilated vehicle where excessive internal temperatures may be encountered. Always keep the battery out of the reach of infants and small children. Li-B17-031319-C Printed in China Charging the Li-B17 The Li-B17 is powered by a rechargeable battery in the speaker. Make sure to charge speaker before use, using supplied USB cable. Connect the micro-USB plug to the Audio/Charging jack on the speaker. Connect the standard USB plug to a powered USB port, such as that on a computer. Your computer should be connected to a wall outlet when speaker is charging. The light on the speaker will turn to solid red while charging and turn off when fully charged. When the battery is low, the red LED light will turn on. If you start to notice sound distortion at higher volumes, it's time to recharge the batteries. NOTE: The charging LED light will override the pairing LED light pattern. Using Bluetooth with the Li-B17 Whenever the unit is set to Bluetooth ( ) mode, the Li-B17 will attempt to autolink a previously paired device for 3 minutes. If no device is paired, or to pair a new device, follow the steps below:
Make sure your Bluetooth device and the Li-B17 are fully charged. Turn on your Bluetooth device and turn on Bluetooth mode (check in Options or Settings). Slide the Try Me/OFF/ Switch on the speaker to the Bluetooth position
( ). Press and hold the Bluetooth Pairing Button for 3 seconds. The blue LED light will flash, and a tone will sound as the speaker enters pairing mode. StarWarsLi-B17 should appear on your device. If Not Connected or similar message appears, select StarWarsLi-B17 to connect. If your device asks for a passcode, enter 1234. Once paired, a confirmation tone will sound and the blue LED will glow solid. You can then stream audio to the speaker. Control Bluetooth audio from your device. Remember to turn off the speaker and your device after listening. If no device is paired within 15 minutes, a failure tone will sound, the blue LED will flash slowly and the unit will revert to standby mode. To retry pairing, press and hold the Bluetooth Pairing Button for 3 seconds. If pairing is not success-
ful, turn the power OFF on the speaker and repeat pairing procedure. NOTE: To cancel current pairing mode, quickly press the Bluetooth Pairing Button for 1 second. Answer / End Calls The Li-B17 also comes equipped with a Speakerphone function which will be active when a call is coming through to your linked Bluetooth device. When an incoming call the Bluetooth Pairing/Spearkerphone/Sound Effects Button on the speaker once to answer the call. Press and hold for 2 seconds to reject the call. Speak into the microphone during the Bluetooth Pairing/Speakerphone/Sound Effects Button again. is received on your device, briefly press the call, briefly press the call. To end Model: Li-B17E7 MILLENNIUM FALCON SPEAKER CHARGE BEFORE USE Questions? Visit www.ekids.com This item is NOT a toy FCC Information FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. FCC ID: EMOLIB17 IC: 986B-LIB17 This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. pursuant to Part 15 of the FCC Rules. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is Consult the dealer or an experienced radio/TV technician for help. Increase the separation between the equipment and receiver. connected. IC Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
(1) Lappareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. le dispositif a t valu satisfaire l'exigence gnrale de l'exposition aux rf. l'appareil peut tre utilis dans des conditions d'exposition portatif sans restriction. CAN ICES-3 (B)/NMB-3(B) Declaration ID: D024962 IMPORTANT Read before proceeding If you have any question regarding the operation or use of this product, please visit www.ekids.com to view answers to frequently asked questions. To learn more about this and other iHome products, please visit us online at www.ekids.com Press and hold to pair to play Bluetooth Mode LED Indicator:
Blue = Bluetooth pairing Red = Charging/Low Battery Top View Micro USB plug Standard USB plug Note: These plastic parts are used to secure the speaker in the package. Please discard the parts upon removing the speaker from the package. USB charging cable Charging the Li-B17 CHARGE BEFORE USE Charging Jack E M Y R T Try me/OFF/
Switch Bluetooth Pairing/
Speakerphone/
Sound Effects Button Microphone LED Try me/OFF/ Switch This unit comes shipped in Try me mode for in-store demonstration purposes. When you are ready to play, slide the Try me/OFF/ switch on the back of the unit to the ON position. When you are finished, be sure to slide the switch to the OFF position to save battery life. Computer connected to working outlet Computer USB port OR USB AC adaptor
(not included) USB AC adaptor connected to working outlet