iKBT70 - QSG - English Size: 306 x 150 mm (folded 102 x 150 mm) Material: 85gsm wood free paper Color: 1C + 1C (black) Feb. 24, 2023 Model: iKBT70B.EXv23 Charging the Speaker and Microphone USB-C charging cable
(included) USB AC adaptor
(not included) To charge the battery, connect the larger plug of the included USB-C charging cable to the powered USB port of a computer or a USB/AC adapter, and then connect the smaller plug to the USB-C charging port on the side of the speaker, and the bottom of the microphone.
(Note: The speaker and microphone must be charged separately.) The Charging Indicator will glow red while charging. The indicator will turn off when the unit is fully charged and ready to use. Connecting to Bluetooth The rst time the speaker is powered on, it will enter auto-pairing mode, indicated by ashing red and blue LEDs. 1. Make sure Bluetooth is enabled on your device (check in Settings). 2. iHome iKBT70 will appear on your devices Bluetooth menu. 3. Select iHome iKBT70 to complete pairing. Manual Pairing: Press and hold the Play/Pause Button for 2 seconds to enter pairing mode. Follow steps 1-3 above to complete pairing. To reset pairing table, press and hold the Play/Pause Button for 10 seconds. Controls and Indicators SPEAKER TOP VIEW Bluetooth Pairing LED Power Press and hold to turn ON/OFF Short press to switch modes:
Bluetooth, AUX or TF mode Play/Pause Short press to play/pause audio Short press to answer/end phone call Press and hold to reject incoming call Double press to redial previous call Volume Up Press and hold to increase volume Short press to skip to next track Volume Down Press and hold to decrease volume Short press to skip to previous track Light Modes Short press to cycle through 11 different light modes. Press and hold to turn light ON/OFF. Double press to check battery status. SPEAKER SIDE PANEL Charging LED TF DC5V AUX AUX - Connect a 3.5mm audio cable (not included) to the AUX jack on the speaker, and the other end to your audio device to play audio without using Bluetooth. TF - Insert a TF or SD card to play audio les. DC5V Charging Port - Connect the included USB-C charging cable to charge the speaker. MICROPHONE CONTROLS Power Button - press and hold to turn ON/OFF
- short press to mute/unmute mic Volume Up - short press to increase mic volume Volume Down - short press to decrease mic volume Voice Effects - short press to cycle through 5 vocal effects LED Indicator - red = charging / blue = Bluetooth connected USB Charging Port IMPORTANT SAFETY INSTRUCTIONS Please heed all warnings, read and follow all instructions in their entirety before using or charging the device. Failure to do so may result in personal injury or property damage if used improperly. Keep these instructions handy for future reference. This device uses an internal non- replaceable, rechargeable lithium battery that should last the lifetime of the device. If you suspect that your battery maybe dead, try charging it for an extended period of time or try resetting the unit. 1. Do not block any ventilation openings. Install in accordance with the manufacturers instructions. 2. Heat The speaker and microphone should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including ampliers) that produce heat. 3. Only use attachments/accessories specied by the manufacturer. 4 . Unplug this product during lightning storms or when unused for long periods of time. 5. Damage Requiring Service This product should be serviced by qualied service personnel when:
- Plug has been damaged.
- Objects have fallen into or liquid has been spilled into the enclosure.
- The unit has been dropped or the enclosure damaged.
- The unit exhibits a marked change in performance or does not operate normally. 6. No naked ame sources, such as lighted candles, should be placed on this product. 7. Attention should be drawn to the environmental aspects of battery disposal. 8. This product is suitable for use in tropical and/or moderate climates. 9. Do not dispose of batteries in the household trash or re. 10. If the unit is to be unused for an extended period of time, such as a month or longer, charge the unit fully before storage. 11. Always use a UL/ETL certied charging adapter (not included), and the supplied USB charging cable. WARNING: To reduce the risk of re or electric shock, do not expose this product to rain or moisture. WARNING/DISPOSAL OF UNIT Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device. To dispose of the unit, follow the instructions below:
Never dispose of used batteries/electronics with ordinary solid wastes, since they may contain toxic substances. Always dispose of used batteries/electronics in accordance with the prevailing commu-
nity regulations. Many electronics retailers now recycle batteries and other electronic components at no charge. Visit www.call2recycle.org for more information. GENERAL BATTERY PRECAUTIONS Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal. Rechargeable batteries are only to be charged under adult supervision. Always charge Lithium batteries on surfaces that wont catch on re such as cement, steel, ceramic or stone. Wooden tables and carpeted oors are not recommended charging surfaces. Never leave a charging lithium device unattended. Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other electrolytic substances. Avoid charging a rechargeable battery when the temperature is not within 5C - 35C
(41 - 95 Fahrenheit). Never expose a battery to any liquid. Never expose a battery to excessive heat such as direct sunlight or re. Never use or store a battery device in an unventilated vehicle where excessive internal temperatures may be encountered. Always keep batteries out of the reach of infants and small children. Do not charge batteries near ammable products or liquid. This product is NOT a toy. FCC Information This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. ISED Statement This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. The device comply with ISED RF exposure requirement, users can obtain Canadian information on RF exposure and compliance. This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. Any Changes or modications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes :
(1) Lappareil ne doit pas produire de brouillage;
(2) Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. L'appareil est conforme aux exigences d'exposition RF ISED, les utilisateurs peuvent obtenir des informations canadiennes sur l'exposition aux RF et la conformit. Cet quipement est conforme aux limites d'exposition aux radiations IC CNR-102 tablies pour un environnement non contrl. Tout changement ou modication non expressment approuv par la partie responsable de la conformit pourrait annuler le droit de l'utilisateur utiliser l'quipement. CAN ICES-3 (B) / NMB-3(B) One Year Limited Warranty iHome Products, a division of SDI Technologies Inc. (hereafter referred to as SDI), warrants this product to be free from defects in workmanship and materials, under normal use and conditions, for a period of one (1) year from the date of original purchase. Should this product fail to function in a satisfactory manner, it is best to rst return it to the store where it was originally purchased. Should this fail to resolve the matter and service still be required by reason of any defect or malfunction during the warranty period, SDI will repair or, at its discretion, replace this product without charge. This decision is subject to verication of the defect or malfunction upon delivery of this product to the Factory Service Center authorized by Customer Service. If service is required, please contact Customer Service at ihome.com/support to obtain a Return Authorization Number and shipping instructions. Disclaimer of Warranty NOTE: This warranty is valid only if the product is used for the purpose for which it was designed. It does not cover (i) products which have been damaged by negligence or willful actions, misuse or accident, or which have been modied or repaired by unauthorized persons; (ii) cracked or broken cabinets, or units damaged by excessive heat; (iii) damage to digital media players, CDs or tape cassettes (if applicable); (iv) the cost of shipping this product to the Factory Service Center and its return to the owner. This warranty is valid only in the United States of America and does not extend to owners of the product other than to the original purchaser. In no event will SDI or any of its affiliates, contractors, resellers, their officers, directors, shareholders, members or agents be liable to you or any third party for any consequential or incidental damages, any lost prots, actual, exemplary or punitive damages. (Some states do not allow limitations on implied warranties or exclusion of consequential damages, so these restrictions may not apply to you.) This warranty gives you specic legal rights, and you may also have other rights which vary from state to state. Your acknowledgment and agreement to fully and completely abide by the above mentioned disclaimer of warranty is contractually binding to you upon your transfer of currency (money order, cashier's check, or credit card) for purchase of your SDI product. 2023 SDI Technologies, Inc. All rights reserved iKBT70_QSG_022423-A Printed in China