iW3 Safety Card -- Front April 23, 2012 material: 150gsm2, art paper glossy, 1C + 1C SIZE: 115MM X 115MM iW3 Safety Card --
1C 1C iW3Consumer Guide --
iW3 Safety Card -- Front May 09, 2012 material: 150gsm2, art paper glossy, 1C + 1C SIZE: 115MM X 115MM English Important Safety Instructions 1. Water and Moisture The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. 2. Ventilation The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, it should not be situated on a bed, sofa, rug or similar surface that may block ventilation openings. Also, it should not be placed in a built-in installation, such as a bookcase or cabinet, which may impede the ow of air through the ventilation openings. 3. Heat The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including ampliers) that produce heat. 4. Power Sources The unit should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance. 5. Power Cable Protection Power supply cables should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. It is always best to have a clear area from where the cable exits the unit to where it is plugged into an AC socket. 6. Cleaning The unit should be cleaned only as recommended. See the Maintenance section of this manual for cleaning instructions. 7. Objects and Liquid Entry Care should be taken so that objects do not fall and liquids are not spilled into any openings or vents located on the product. 8. Attachments Do not use attachments not recommended by the product manufacturer. 9. Lightning and Power Surge Protection Unplug the unit from the wall socket and disconnect the antenna or cable system during a lightning storm or when it is left unattended and unused for long periods of time. This will prevent damage to the product due to lightning and power-line surges. 10. Overloading Do not overload wall sockets, extension cords, or integral convenience receptacles as this can result in a risk of re or electric shock. 11. Damage Requiring Service The unit should be serviced by qualied service personnel when:
A. the power supply cable or plug has been damaged. B. objects have fallen into or liquid has been spilled into the enclosure. C. the unit has been exposed to rain. D. the unit has been dropped or the enclosure damaged. E. the unit exhibits a marked change in performance or does not operate normally. 12. Antenna Do not connect an external antenna to the unit (other than that provided). 13. Periods of None Use If the unit is to be left unused for an extended period of time, such as a month or longer, the power cable should be unplugged from the unit to prevent damage or corrosion. 14. Servicing The user should not attempt to service the unit beyond those methods described in the users operating instructions. Service methods not covered in the operating instructions should be referred to qualied service personnel. Maintenance Place the unit on a level surface away from sources of direct sunlight or excessive heat. Protect your furniture when placing your unit on a natural wood and lacquered nish. A cloth or other protective material should be placed between it and the furniture. Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine, thinner or similar materials can damage the surface of the unit. iW3 - Consumer Product Safety Guide FCC Statement FCC ID: EMOIW3 IC: 986B-IW3 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Increase the separation between the equipment and receiver. Modifying or tampering with your systems internal components can cause a malfunction and might invalidate the systems warranty and void your FCC authorization to operate it. The separation distance between the equipment and the user shall not be less than 20 cm. This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de la classe B est conforme la norme NMB-003 du Canada. FCC Radiation Exposure Statement This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and it also complies with Part 15 of the FCC RF Rules. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions:
1. This device may not cause interference and 2. This device must accept any interference received, including interference that may cause undesired operation Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modications to this equipment. Such modications could void the user authority to operate the equipment. Printed in China Questions? Visit www.ihomeaudio.com iW3 04232012-A iW3 Safety Card -- CAN Front April 23, 2012 material: 150gsm2, art paper glossy, 1C + 1C SIZE: 115MM X 115MM iW3 Safety Card --
1C 1C iW3 Consumer Guide --
iW3 Safety Card -- CAN Front May 09, 2012 material: 150gsm2, art paper glossy, 1C + 1C SIZE: 115MM X 115MM French-CAN IMPORTANTES CONSIGNES DE SCURIT 1. L'eau et l'humidit L'appareil ne doit pas tre utilis proximit de l'eau. Par exemple : prs d'une baignoire, d'un lavabo, d'un vier de cuisine, d'une cuve lessive, d'une piscine ou dans un sous-sol mouill. 2. Ventilation L'appareil doit tre situ de sorte que son emplacement ou sa position ne gne pas sa bonne ventilation. Par exemple, il ne doit pas tre situ sur un lit, un sofa, un tapis ou une surface similaire pouvant bloquer ses vents. Il ne faut pas non plus le placer dans un endroit engonc, tel une bibliothque ou une armoire, ce qui pourrait bloquer le dbit d'air travers les vents. 3. Chaleur Placez l'appareil l'cart de sources de chaleur comme un radiateur, une chaudire, un pole ou d'autres appareils (y compris un amplicateur) qui produisent de la chaleur. 4. Sources d'alimentation lectriques L'appareil doit tre connect un bloc d'alimentation uniquement du type dcrit dans le mode d'emploi ou indiqu sur l'appareil. 5. Protection du cordon d'alimentation Acheminez le cordon d'alimentation de sorte que personne ne puisse marcher dessus ou qu'il ne puisse tre coinc par des lments placs sur lui ou contre lui. Il vaut toujours mieux dgager l'endroit d'o merge le cble de l'appareil jusqu' celui o il est branch dans une prise de courant. 6. Nettoyage L'appareil doit tre nettoy uniquement tel que recommand. Voyez la section Entretien de ce manuel pour plus de dtails. vers dans les ouvertures du produit. 7. Pntration par des objets et des liquides Assurez-vous qu'aucun objet ne tombe ou qu'aucun liquide ne soit 8. Accessoires N'utilisez pas d'accessoires non recommands par le fabricant. 9. Protection contre la foudre et les surtensions Dbranchez l'appareil de la prise murale et dconnectez l'antenne ou le cble durant un orage lectrique ou si l'appareil est sans surveillance et inutilis pendant des priodes prolonges. Ceci permettra d'viter d'endommager l'appareil cause de la foudre ou de surtensions. 10. Surcharge Ne surchargez pas les prises de courant, les rallonges ou les botiers multiprises car cela pourrait poser des risques de dcharge lectrique ou dincendie. 11. Dommages ncessitant une rparation Conez l'appareil un technicien professionnel dans les situations suivantes :
A. Le cordon dalimentation ou sa che sont endommags. B. Du liquide ou des corps trangers ont pntr dans le botier de lappareil. C. Lappareil a t expos la pluie. D. Lappareil est tomb ou son botier est endommag. E. Les performances de lappareil ont chang de manire vidente ou l'appareil ne semble pas fonctionner normalement. 12. Antenne Ne branchez pas une antenne externe cette unit (autre que l'antenne fournie). 13. Priodes de non-utilisation Si l'appareil reste inutilis pendant une longue priode, un mois ou plus par exemple, dbranchez le cble d'alimentation de l'appareil pour viter les risques de dommages ou de corrosion. 14. Entretien vitez tout entretien de l'quipement qui n'est pas explicitement dcrit dans le mode d'emploi. Pour toute intervention technique non couverte par le mode d'emploi, adressez-vous un technicien quali. Maintenance Tenez lappareil sur une surface plane hors des rayons direct du soleil ou de toute chaleur excessive. Protgez vos meubles quand vous posez lappareil sur du bois naturel ou sur une surface laque. Un vtement ou un autre matriau de protection doit tre plac entre lappareil et le meuble. Nettoyez votre appareil uniquement avec un tissu doux et un peu de savon doux. Les agents nettoyants tels que le benzne ou autres dtergents pourraient endommager la surface de lappareil. mprim en Chine Des questions ? Visitez le site www.ihomeaudio.com iW3 04232012-A iW3 - Guide du consommateur concernant la scurit des produits Canada Statement /Canada Dclaration This device complies with Industry Canada RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device. FCC ID: EMOIW3 IC: 986B-IW3 Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio RSS-210. L'exploitation est autorise aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radio lectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain Canadian information on RF exposure and compliance. Le dispositif rencontre l'exemption des limites courantes d'valuation dans la section 2.5 de RSS 102 et la conformit l'exposition de RSS-102 rf, utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformit de rf. Toute modication ou altration des composants internes de votre systme peut entraner un dysfonctionnement et peut annuler la garantie du systme et l'autorisation de la FCC pour le faire fonctionner. La distance sparant l'utilisateur de l'quipement doit tre suprieure ou gale 20 cm. Cet appareil numrique de la class B est conforme la norme NMB-003 du Canada