FCC ID: VA5ANH500-1WLF Keyless Entry System

QUICK START CARD FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation. IC This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and

(2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes :

(1) l'appareil ne doit pas produire de brouillage, et

(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. This equipment complies with IC Nerve Stimulation Exposure limits set for an general public environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. Separation distance at least 3cm should be maintain from the device to user hand/foot during operation. Separation distance at least 10cm should be maintain from the trunk of the body would rest in relation to the device under test. Patent: https://firstechllc.com/patents/

Firstech, LLC. | 1 QUICK START CARD QUICK START 1WS2R-AF BUTTON FUNCTION DESCRIPTION Tap button 1 time to lock and/or arm your system. Double tap button to unlock and/or disarm your system. Hold button for 2.5 seconds to activate OR cancel the remote start sequence. 1 quick TAP THEN HOLD for 5 seconds to enable or disable proximity arming function. REMOTE FEATURES NOTE: Passive arming feature 1-08 option 4 (proximity locking) must first be activated on the system by the install tech FEATURE Proximity Lock Proximity Unlock FUNCTION/DESCRIPTION Once the proximity lock feature is enabled, the system will search for the remote once the vehicle is off and all zones are closed. Once the remote has left proximity of the antenna the system will arm/lock. NOTE: If the remote is within range of the antenna for 5 minutes the proximity lock feature will stop until a door is opened or vehicle is started. 15 seconds after the system is armed, the proximity antenna will begin to search for the remote. When the remote moves within range of the proximity antenna (approx. 4-6 ft) the system will disarm/unlock automatically. NOTE: The Orange LED on the remote will flash when the remote is within range of the proximity antenna To reprogram your remote, cycle the key in the ignition 5 times within 7 seconds. Parking lights will flash. Then tap the Lock button on your remote. Repeat for any additional remotes. All remotes must be programmed during one sequence. If you receive two parking light flashes, your Compustar has exited remote programming mode and you must retry. Questions/comments? Contact us at 888-820-3690 from 8 AM to 5 PM PST. Also please visit www.compustar.com for sers manual. Firstech, LLC. | 2 QUICK START CARD ANT-1WAF QUICK START LEDs Solid The system is locked and ready to be armed. Blinking The system is armed / passive arming is on. DESCRIPTION Solid (10sec) The remote battery is low. Please replace the battery in the remote.

(Activated upon the initial "Doors unlock by 1WS2R-AF and Key On" sequence) Firstech, LLC. | 3 Firstech, LLC. | 3 QUICK START CARD ANT-1WAF Description of antenna module installation position

<< Antenna Module >>

<< Harness >>

<< Installation of Antenna Module >>

Note : The antenna module is mounted up in the vehicles dashboard. Firstech, LLC. | 4

Label and Location ANT-1WAF Size Label 38.0 X 9.0 mm This label is attached to the back of the product and not easily removed.

Workshop J2, 4th floor of Block 1, Kinho Industrial Buildings Nos 14-24 Au Pui Wan street, SEGI LIMITED Shatin, N.T, Hongkong Date: July 14, 2022 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 RE: Request of Confidentiality for FCC ID: VA5ANH500-1WLF To Whom It may Concern:

Pursuant to Sections 0.457 and 0.459 of the Commission`s Rules(CFR 47), and Section 552 (b) (4) of the Freedom of Information Act, SEGI LIMITED. Here by requests confidentiality and treatment of certain information accompanying this application. The materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these matters might be harmful to the Applicant and provide unjustified benefits to its competitors. We are also hereby request Short-Term Confidentiality for 180 days after the grant as outlined in Public Notice DA 04-1705. This provision will give SEGI LIMITED. temporary confidentiality of commercially sensitive information prior to product release. The requested permanent and Short-Term Confidential exhibits are listed as follows:

PERMANENT & SHORT-TERM CONFIDENTIAL LIST Exhibit Description PERMANENT SHORT-TERM 1 2 3 4 5 6 7 8 Block Diagram Schematics Part Lists Operation Description Internal photo NA NA NA The Applicant understands that pursuant to Rule 0.457, disclosure of this application and all accompanying documentations, where applicable, will not be public before the date of the Grant for this application. Sincerely, Young il Chang President