ha lx ZX-34 Z-mote Battery Installation Ix ZX-34 Radio Controlled Zibits Xplorer ZX-34 Battery Installation on l Sem ene?
Yeher POWER SWITCH Aemer POWER SWITCH Push the Power Switch on the Push the Power Switch on the ~p = bottom of the ZX-34 to the ON = -=
bottom of the ZX-34 to the ON position to power on ZX-34.
| ZX-34 requires 4x AA Alkaline batteries (NOT Included). To install CCQ ha 3x Power Orbs and change batteries, open the battery door (battery door is located on the rear side of ZX-
| _ driver. Position the batteries as shown above. When the
| _ batteries are positioned correctly, close the battery door and 34) with a Phillips head screw
| _ tighten the screw with a Phillips head screw driver (not included). Some assembly required. May need adult assistance. |
| Battery Installation ew Yer Controller Button Breakdown LOAD BUTTON FIRE BUTTON position to power on ZX-34. CONTROL STICK RIGHT ZX-34 Z-mote Battery Installation The Z-mote requires 1x 9V battery (NOT included). To install and change batteries, open the battery door (battery door is located on the bottom side of the Z-mote) with a Phillips head screw driver. Position the batteries as shown above. When the batteries are positioned correctly, close the battery door and tighten the screw with a Phillips head screw driver (not included). |
CONTROL STICK LEFT BASIC CONTROLLER DIRECTIONS
| Push the power switches to ON on the Z-mote and the ZX-34. Point the Z-mote
| towards ZX-34 and push both CONTROL STICKS forward and backward to make ZX-34 go forward and backward. Make sure to push both CONTROL STICKS at the same time to go ina straight line. Move the CONTROL STICKS in opposite directions to turn. See the POWER ORB PICK-UP and SHOOTING POWER ORBS pages to see how
| to pick-up and fire POWER ORBS. Power Orb Pick Up |
# Pick-Up Port |
DRIVE OVER THE POWERORBS_ |
Locate your POWER ORBS and drive your ZX-34 over the POWER ORBS, making sure the POWER ORB goes into the PICK-UP PORT. While driving forward, over the POWER ORB, push and hold the LOAD button. Keep holding down the LOAD button until the POWER ORB is fully picked up . ZX-34 holds up to 3 POWER ORBS. Shooting Power Orbs |
Do not aim at eyes or face. Warning! The toy includes a discharge mechanism. Do not launch or play with any object other than that provided with the toy. A Battle Canon FIRING THE CANON Once you have picked up the POWER ORBS, you are ready to shoot the BATTLE CANON. Push the FIRE button to shoot the BATTLE CANON. If the BATTLE CANON does not shoot. Hold down your LOAD button until you hear the POWER ORB fall into place in ZX-34. Then push the FIRE button to shoot the BATTLE CANON. BACK Vv CAUTION: Battery Warnings
+ An adult should supervise battery installation.
+ Take the batteries out of your ZX-34 when you are not going to use it for a long time.
+ Dont mix old and new batteries.
+ Dont mix alkaline batteries with standard (carbon-zinc) or rechargeable batteries.
+ Dont mix different brands or kinds of batteries.
+ Use the type and size of batteries recommended in this instruction manual.
+ Match the positive and negative ends of the batteries correctly.
+ Take dead batteries out of the ZX-34 right away.
+ Dont short circuit the supply terminals.
+ Dont attempt to recharge non-rechargeable batteries. Remember: If you use batteries incorrectly you might cause heat generation, acid leakage, or explosion. You might cause an injury or damage your Zibit. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
C az
+ Reorient or relocate the receiving antenna. Made in Dongguan, China ZX-34 is a battle vehicle that can handle the toughest terrain. It has also been equipped with systems to collect the volatile power orbs, and fire them, at potential enemies, or to simply clear a path for 2X-34. 2X-34 definitely helps even the odds in the struggle against the fearsome Blurge. R/C Zibits Xplorer ZA. WARNING CHOKING HAZARD small parts. Not for children under 3 yrs.
* Increase the separation between the equipment and receiver. s 5
* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
+ Consult the dealer or an experienced radio/ TV technician for help.
| | PR iq 2011 Senario jario 1725 Kilkenny Court
Product fror . magesshown Nw.senario.com Woodstock, IL 60098
| images shown, Division: Sweet Thang OdHome/Office/Stationery OVideo Entertainment O Storybook Pillows FOLD LIKE THIS PR Ae lad Woodstock, IL 60098 p: (815) 337-0889 Pav CIE) PERO:
Other BACK a Date: 05.31.2011 Item #: UPC #:
License: ZIBITS . Product: 7X-34 IM Flair Art: 100 * of renal size File Name: 2-34 us im rev0531 1 Iai Print: 100% of original art Current Stage: Olnitial Concept OFinished Concept OMechanical Next Stage: ORevise Concept OSubmit to Licensor OMechanical OProduction Art prepared by: Brian Povich Internal Approval (tnitia/Date): Merch.: Mkting OOO UPC OO O Website URL O O Warnings OO O Item# OOO Spelling O O O Age Grading O O Battery Info. OO Material Specs/Callouts O Country of Origin O O O Trademark O Dimensions/Size O O O Color Specs O O O Copyright OO O Copy content O O O Disclaimers OO O Legal O O Translations Additional Comments:
Final Sign-offs (tnitia/Date): Dir. of Creative Sery.:
\ Exec. VP-Mkting: CEO/Exec.VP:_ J)