Title :Information DocumentNO.Date0. GENERAL0.1. MakeSEOYON ELECTRONICS Co.,Ltd.0.2. Model No.- Transmitter : Remote Keyless Entry Transmitter SYEC4TX1611- Receiver : Body Control Module0.3. Name and address of manufacturerSEOYON ELECTRONICS Co.,Ltd.424, Sinwon-ro, Danwon-gu, Ansan-si, Gyeonggi-do, Korea0.4. Address of assembly plantSEOYON ELECTRONICS Co.,Ltd.424, Sinwon-ro, Danwon-gu, Ansan-si, Gyeonggi-do, KoreaSHT/SHTS : 2/11 Title :Information DocumentNO.Date2.PRODUCT SPECIFICATION2.1Scope of RKE, Body Control Module2.1.1Folding TX KEY : It has the RKE functions.Data is transmitted with radio frequency2.1.2BCM(RX) : ECU is control the whole BCM funtion with RKE2.2SPECIFICATIONS2.2.1Transmitter2.2.2RECEIVERSHT/SHTS : 3/11ITEMSPECIFICATIONRated supply voltageDC 3VOperating voltage rangeDC 2.5 ~ 3.2VOperating temperature range- 10 ~ + 60 with BatteryStorage temperature range- 40 ~ + 85 without BatteryModulationFSKFrequency433.92MHzCodeRolling Code(Hopping Algorithm)Electric field strength10mW (433.92MHz)Battery life2 Year(10Times/Day)(Lithium 3V 1EA)ItemSpecificationRated Supply VoltageDC 12VOperating VoltageDC 9 ~ 16VOperating Temperature- 30 ~ + 80Max Humidity95%Standby CurrentBelow than 5.5mA(in alarm setting condition) Title :Information DocumentNO.Date2.3Operating summary-RKETRANSMITTER's button is pushed.TRANSMITTER sends the code by radio frequency.RECEIVER gets the code and decodes it.RECEIVER judges the code whether it is right code or not.RECEIVER checks door lock or unlock, trunk state. RECEIVER drives the actuator.2.3.1LOCK & UNLOCKIf LOCK or UNLOCK button is pushed for less than 1 sec, then TRANSMITTER sends the LOCK or UNLOCK DATA.If TRUNK button is pushed for more than 1 sec, then TRANSMITTER sends the TRUNK DATA.If PANIC button is pushed for more than 1 sec, thed TRANSMITTER sends the PANIC DATA.2.4 CautionDanger of explosion if battery is incorrectly replaced.SHT/SHTS : 4/11Replace only with the same or equivalent type recommended by the manufacturer.Dispose of used batteries according to the manufacturer's instructions. Title :Information DocumentNO.Date3.USER MANUAL3.1ITEM : Body Control Module- This system is BCM and inculdes RKE.SHT/SHTS : 5/11- RKE in BCM system is intended for auto door lock or unlock or TRUNK in vehicle.- This BCM system is to be installde on motor vehicles as *OE item.*OE : Original Equipment.*BCM : Body Control Module*RKE : Remote Keyless Entry.3.2SYSTEM CONSTRUCTION3.2.1SYSTEM IN VEHICLEANTENNA3.2.2SYSTEM FOR TESTRadio Frequency(433.92MHz)BCMRadio Frequency(433.92MHz) if press button on the transmitter, RF signal is transmitted and turns on the LED* It shows the status of operation through the LED used.BATTERY FCC Information This device complies with part 15 of the FCC Results. Operation is subject to the following two conditions :
(1) This Device may not cause harmful interface, and
(2) This device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following measures:
1.1. Reorient or relocate the receiving antenna. 1.2. Increase the separation between the equipment and receiver. 1.3. Connect the equipment into an outlet on a circuit different from that to which receiver is connected. 1.4. Consult the dealer or experienced radio/TV technician for help. WARNING Changes or modifications not expressly approved by the manufacturer could void the users authority to operate the equipment. CAUTION : Exposure to Radio Frequency Radiation. Antenna shall be mounted in such a manner to minimize the potential for human contact during normal operation. The antenna should not be contacted during operation to avoid the possibility of exceeding the FCC radio frequency exposure limit.
"ATTENTION: L'exposition aux rayonnements frquence radiolectrique. Antenne doit tre monte de telle manire minimiser le risque de contact humain pendant l'utilisation normale. L'antenne ne doit pas tre contact pendant le fonctionnement pour viter la possibilit de dpasser la limite de l'exposition aux frquences radio de la FCC. IC Information This device complies with Industry Canada license-exempt RSS standard(s). Operation in subject to The following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR dIndustrie Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
1) lappareil ne doit pas produire de brouillage;
2) lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement.