14+
DX-5 VIDEO STREAMING DRONE DX-5 VIDEO STREAMING DRONE DX-5 VIDEO STREAMING DRONE GETTING TO KNOW YOUR DRONE INTRODUCTION SPECIFICATIONS Congratulations on your purchase of READ ALL WARNINGS AND PRECAUTIONS BEFORE USE. WWW.MERCHSOURCE.COM
: s Drone Battery: 550 mAh Li-po A PLEASE READ ALL WARNINGS AND INSTRUCTIONS ne pe: nA GHz DX-5 Video Remote Controller Battery: 6 x 1.5V AA SAFETY WARNINGS:
PRIOR TO USE. KEEP THIS DOCUMENT AS IT CONTAINS rone. et ready to soar to new Charging Time: Approximately 100 minutes . Not recommended for children under 14 years of age. As with all electrical products, precaution IMPORTANT INFORMATION ABOUT YOUR DRONE. heights. Master the art of drone flying ' , : . and Stunts with remote-control Maximum Recommended Altitude 120 ft. should be observed during handling and use to reduce the risk of electrical shock. maneuverability. This lightweight stunt < Adult supervision is required at all times. 14. CHARGING F y- 9 9 Before each use, an adult should review the product and battery to determine that no damage fs drone will provide hours of fun. oF havarcs exist 5 ea ae ee ees bp mimpeoonerry BO NOT TOUCH SPINNING PROPELLERS,
+ Install batteries in remote . Do not allow anything to intentionally make contact in any way with spinning propellers. 2. PAIRING + Prevent contact with spinning blades by turning off remote prior to handling drone. 5 h flighipairtty te-withthed . Use caution and pay attention to your surroundings while operating drone. eroneeach flight )/palr'the:remote withthe drone: . Do not fly drone into animals, people, or inanimate objects. 1. Turn your drone on and place on a flat, level surface TABLE/OF CONTENTS : Keep drone away from power lines, buildings, trees, public areas, and any other potentially 2. Turn on the remote on and move the left joystick up, then down hazardous areas. 3. The beep will indicate successful pairing : Do not operate in rain, heavy wind, and or any type of severe weather. 4. Repeat steps 1 and 2 if necessary General Warnings Page 1 . Do not land drone on wet surfaces. 3. DIRECTIONAL LIGHTS . e Never touch or allow others to touch drone while it is flying.
+ White lights indicate the front of the drone Contents and Remote Battery Installation Page 2 Always turn drone off when it is not in use.
* Red lights indicate the back of the drone . Always fly drone in large open areas.
* Not applicable in auto-orientation mode Charging Battery and Replacing Propellers Page 3 . Never fly drones above or near people, sudden changes in wind or other conditions could lead to 4. REMOTE CONTROL OVERVIEW . unexpected crashes. Remote Overview Page 4 :
Practice flying your drone below 10 feet and at low speeds until comfortable with all g * Always en nen flying drone vehicles, obey relevant laws, respect the privacy and i inj . ty right tI controls to avoid unnecessary damage or injury Operating Drone Page 5 property rignts of otners: . , .
+ Left joystick: . The drone shall never be modified or used for anything except its intended purpose.
+ Up/Down controls elevation Modes Page 6
+ Left/Right controls spin
+ Right joystick: controls flight direction Tips and FCC Warning Page 7 PLEASE RECYCLE OR
+ Direction Trim: use to eliminate drift @ dispose oF ELECTRONICS To cut power to drone, move left joystick to down position t o PROPERLY RECYCLING INFORMATION IS AVAILABLE AT Me QUESTIONS OR CONCERNS?
PLEASE GIVE US A CALL ... WE'RE HERE TO HELP CUSTOMER SERVICE
(800) 374-2744 Before calling please locate the 10-digit code printed on the back of your remote ee Va ADULT ASSEMBLY REQUIRED. DX-5 VIDEO STREAMING DRONE CONTENTS HIT i+
+]] |} +4}
REMOTE BATTERY INFORMATION 1. Slide open battery compartment 2. Install 6 AA batteries as shown in diagram shown above 3. Replace and close battery compartment meee sR aR There is a risk of fire and personal injury if Li-Po battery is punctured, damaged or misused.
+ Never expose battery to extreme temperatures or moisture.
+ Do not subject battery to strong impacts.
+ Always keep battery away from flammable materials.
* Only use manufacturer specified batteries), charger(s), and/or adapters, if applicable, a >) A\LITHIUM-POLYMER BATTERY WARNING Page i DX-5 VIDEO STREAMING DRONE CHARGING BATTERY Note: The Battery Charge Cable will light up when it is charging the battery and turn off when the battery is fully charged. Charge time is approximately 100 minutes. Connect the Charging Cable to the Drone Insert the Turn off the drone before charging. ] \ $ Charging Cable into a USB Connect the Battery Charge Cable to the charging : power source port on the Drone. Connect USB connector to power source. Replacing Propellers 1. Follow diagram 2. Remove screw from top of Propeller 3. Remove broken Propeller and replace with new Propeller 4. Make sure you installed the correct blade. Each blade has a number _ written on it. Match the blades with . the corresponding number on the ps drone | |
5. Insert screw into top of Propeller =
ir Invasion of Privacy Warning Always be mindful of others privacy and do not record video or take images of others without their consent. Check and comply with your federal, state and local laws regarding privacy. Page 1 DX-5 VIDEO STREAMING DRONE Light indicates remote is on Stunt button Throttle Joystick ro oyst Controls
[ Increases or decreases flight direction drone elevation
< Spins drone Auto orientation Auto land Trim controls are used to minimize drift specified by the manufacturer. See page 5
+ Battery is not serviceable. DRONE APP for more details Smart Phone + Let battery cool to room temperature before charging. ge hed Mount Y | Qe0-
loun + While charging, never leave battery unattended. Go to your app store on your smart phone and download the 360-L Flight application. Spin trim el + Recycle or dispose of battery according to federal, 3 2 a th state and local laws. Live Options
\ + The battery is not replaceable. ON/OFF |
- {_ KEEP THIS INSTRUCTION MANUAL FOR REFERENCE J remote switch [
m4 fL
=> BATTERY WARNING ee
+ Do not mix old and new batteries se pa + Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries | -
ts + Insert batteries using the correct polarity. Do not short-circuit the supply terminal Charge Cable with a :
55cm (21.6inch) length Replacement + Always use, replace, and recharge (if applicable) batteries under adult supervision Pairing Drone - First Time After Connecting Drone Propellors 1. Press the connect to Wi-Fi 1. Press the Stream Button to KEEP THE PACKAGE FOR REFERENCE AS IT CONTAINS IMPORTANT INFORMATION Page DX-5 VIDEO STREAMING DRONE INSTALLING PHONE HOLDER 2 Insert antena through hole at the base of the Align hole on Mount with hole in antena. Insert Carefully slide phone into Mount by pulling up Smart Phone Mount. screw to secure Mount to remote. on top of Mount. Adjust angle accordingly. OPERATING DRONE Step 5 - Drone Begins to Drift Follow this step if your drone begins to drift while take off or during Step 1-Pre Flight Checklist _ flight. Note: Auto Orientation mode is oriented to the user when pairing. If the remote is moved after pairing Auto Orientation, please During drone flight, the remote LED is flashing:
1. Read all warnings and instructions. + Drone drifts backwards: Press the forward Direction Trim follow directions above to reset Auto Orientation. 1) Remote batteries are low; replace them with new batteries 2. Install remote batteries, page 2. Button. , 3. Make sure that drone and remote are powered off. + Drone drifts forwards: Press the Backwards Direction Trim Auto Landing Button Drone and remote properly pair, but the drone will not lift-off:
4. Install drone holder. Button. + Make sure you have achieved level, balanced flight, where the drone is neither climbing nor descending. This mode allows you 1) Drone battery needs charging. Use the USB Charge Cable to connect the drone to 5. Charge batteries, page 3. + Drone drifts left: Press the Right Direction Trim Button. Step 2 - Choosing a location + Drone drifts right: Press the Left Direction Trim Button.
+ Drone is designed to be flown indoors and + Drone spins clockwise (viewing drone from top): Press the outdoors. Left Spin Trim Button
+ Always make sure you have enough space to fly + Drone spins counter-clockwise (viewing drone from top):
drone. Press the Right Spin Trim Button
+ Always follow warnings, page 1. Step 6 - Operating Drone in Flight The drones range is approximately 250 feet or 120 feet of altitude:
+ Read and be aware of all warnings found on Page 1.
+ Maintain your desired elevation by using the Throttle.
+ Push the Throttle joystick to right or left to spin the drone. Step 3 - Starting Drone 1. Making sure your remote is off, slide drone switch to ON. Drone lights will begin to flicker. 2. Place drone on a flat even surface with clearance according to diagram (Fig 1). toside. 3. Turn remote on. Make sure the left stick (throttle) + Review step 5 if your drone begins to drift. Isin a: neutral position (stick is centered). + Drone will begin to blink when drone is paired to remote 4. Push the stick up and then down. and battery is low. 5. A single tone indicates that the drone is paired. Step 7 - Landing Drone Drone lights will flicker rapidly then turn on There are two ways to land the drone:
permanently once paired. -
6. If Pairing Is unsuiccessiul, repeat steps 3-4. the drone begins to drift, you can still control the drones direction using the Multi Directional Button. Step 4 - Lift Off 2. Slowly and carefully press the Throttle Joystick down until drone Slowly and carefully press the Throttle Joystick up. Drone will begin to elevate. You can compensate for direction using the Multi Directional Button. some of the drones drifting by using the Multi Directional Button or by following Step 5. You may need to practice this step several times before successfully getting drone into the air. Fig. 1 Always turn off remote prior to retrieving or picking up drone. This will help you avoid accidently activating propellers.
+ Use the right joystick to move forward backwards, and side 1. Press the Auto Land Button. The drone will slowly begin to land. If lands. If the drone begins to drift, you can still control the drones button begin streaming 2. Follow the on screen 2. Press the Album Button to instructions review pictures and videos Page 3 DX-5 VIDEO STREAMING DRONE MODES Stunt Button Once you are comfortable flying the drone, use the Stunt Button to perform acrobatic stunts. 1. Hover the drone to at least above 10 feet. 2. Press the Stunt Button. You will hear beeping coming from the remote 3. Move the Multi Directional Button to the desired direction that you would like the drone to flip Auto Orientation Button
+ Auto Orientation default setting is off. To enter this mode press Auto Orientation button. Remote will beep twice.
+ After drone is successfully paired, the 2 white LED lights toward orientation will be the original forward orientation, when drone is in auto orientation mode, the drone will orient to the user (remote), no matter what direction the drone is facing. Pushing the right stick up will send the drone away from the user, pushing it to the right will move the drone right, etc.
+ Remote will beep every 6 seconds to indicate the drone is in Auto Orientation mode.
+ To exit mode, press the Auto Orientation button. Remote will sound 1 long beep indicating that it has exited Auto Orientation mode. to safely and slowly land your drone without having to control the speed. It is done for you automatically. The ideal auto landing height is 25-30 ft. Press the Land button to trigger auto land. Remote will beep continuously until you exit the auto land mode. To steer the drone during landing, use the right control until drone has reached the ground. Press the Land button again to exit auto landing mode. NOTE: Please make sure the throttle joystick is in the down position before exiting auto landing mode Camera - taking pictures and creating videos
+ Taking a picture- press camera icon on app once to take a picture.
+ Creating video- press video icon on app once to take a video. Press the video icon on app again to stop recording. Page 6 Page 4 DX-5 VIDEO STREAMING DRONE CUSTOMER SERVICE
(800) 374-2744 TIPS
+ Do not crash drone into sand or dirt. Drone gears may become clogged
+ When first learning to fly, practice lifting off and hovering
+ Stay several feet from walls and buildings
+ Always press throttle all the way down after crashing or when something gets stuck in propellers
+ Never fly drones above or near people, sudden changes in wind or other conditions could lead to unexpected crashes.
+ Always use caution when flying drone vehicles, obey relevant laws, respect the privacy and property rights of others.
+ The drone shall never be modified or used for anything except its intended purpose. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. TROUBLESHOOTING:
When remote switch is turned on, the remote light does not illuminate: (Fig. 1) 1) Check that batteries in the remote are installed correctly OR 2) Replace with new batteries power source. After trimming the drone, the drone flight is very unstable and cannot fly properly:
1) One or more blades are most likely damaged;
2) Turn off the drone and remote. 3) Replace with the proper number replacement blade and try flying again. After impact, the drone is unstable:
1) Put the left remote control lever to the left bottom and put the right remote control lever to the right bottom at the same time. This will reset the gyroscope (Fig. 1). 2) _ If the above does not resolve the issue, reboot the drone and controller and pair again. Remote Controller and Drone can not be paired:
1) Check Point: Remote Controller must be closed to Drone, not exceed 12 feet. Note: If there are 2 sets of Drones within 12 feet for Pairing, you must pair one successfully before pairing the second set. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class 8 digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turing the equipment off and on the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver.
= Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCCs RF exposure guidelines, place the drone at least 20cm from nearby persons. Sharper Image name and logo are registered trademarks. Distributed by and 2017 MerchSource, LLC. Irvine, CA 92618. All rights reserved. The artwork and design of this package are protected by US copyright law and may not be reproduced, distributed, displaced, published or used for any purpose without prior written permission. Altering, removing or reproducing any of the trademark or copyright notices on this package is not permitted. China Patent No. ZL201730677298.4 PATENT PENDING Page 7 Printed in China