FCC ID: 2BDC6-SHELLYBLUDW Smart door sensor

C B A D Fig.1/Abb.1 EN A: Light sensor B: Control button C: Magnet D: Sensor unit A C m / 0.4 in

< 10 m Fig.2/ Abb.2 B D Fig.3/Abb.3

Fig.4/Abb.4

Fig.5/Abb.5

CR2032 Fig.6/Abb.6

Fig.7/Abb.7 3 2 0 2

3 3 EN USER AND SAFETY GUIDE Shelly BLU Door/Window Read before use This document contains important technical and safety information about the device, its safe use and installation. CAUTION! Before beginning the installation, please read carefully and entirely this guide and any other documents accompanying the device. Failure to follow the installation procedures could lead to malfunction, danger to your health and life, violation of law or refusal of legal and/or commercial guarantee (if any). Shelly Europe Ltd. is not responsible for any loss or damage in case of incorrect installation or improper operation of this device due to failure of following the user and safety instructions in this guide. Shelly devices are delivered with factory-installed firmware. If firmware updates are necessary to keep the devices in conformity, including security updates, Shelly Europe Ltd. will provide the updates free of charge through the device Embedded Web Interface or the Shelly mobile application, where the information about the current firmware version is available. The choice to install or not the device firmware updates is the users sole responsibility. Shelly Europe Ltd. shall not be liable for any lack of conformity of the device caused by failure of the user to install the provided up-

dates in a timely manner. Product Introduction Shelly BLU Door/Window (the Device) is a Bluetooth sensor designed to detect the opening and closing of a door or window. It can also measure the inclination of a door or window that tilts and turns. In addition, it features a light sensor. Installation Instructions WARNING! Do not allow children to play with the magnets. Even relatively small magnets can cause se-

rious injury if swallowed. CAUTION! Keep the Device away from liquids and moisture. The Device shouldn't be used in places with high humidity. CAUTION! Do not use if the Device has been dam-

aged!

CAUTION! Do not attempt to service or repair the Device yourself!

CAUTION! The Device may be connected wirelessly and may control electric circuits and appliances. Pro-

ceed with caution! Irresponsible use of the Device may lead to malfunction, danger to your life or violation of the law. First steps Shelly BLU Door/Window comes ready to use with the battery installed. However, if pressing its button does not make the De-

vice start emitting signals, you might need to insert a battery. See the Replacing the battery section. Mounting ATTENTION! When mounting the Device make sure the small triangle on the sensor unit points towards the magnet as shown in Fig. 2 and the distance between the sensor unit and the magnet is less than 10 mm / 0.4 in when the door or the window is closed. You can place the magnet left, right, above, or below the sensor unit. If you want to monitor a door or window that tilts and turns, mount the sensor unit (C) on the door or the window (A) and the magnet (D) on the frame (B) as shown in Fig. 3. Use the supplied double-sided foam stickers to affix the sensor unit and the magnet to the door or the win-

dow and the frame. Depending on the door or window frame, you may need to align the magnet and sensor unit by raising one of them using shims (E). If you want to monitor a conventional door or window, we suggest, if possible, mounting the sensor unit on the frame and the magnet on the door or the window. Using Shelly BLU Door/Window If a conventional door or window is opened, the De-

vice will immediately broadcast information about the event, the illumination, and the battery status at the time of the opening detection. If a door or window, which tilts and turns is opened, the Device will immediately broadcast information about the event, the illumination, and the battery status at the time of the opening detection and 2 seconds later will broadcast information containing the inclination angle, the illumination, and the battery status at the moment. If the inclination angle changes the Device will broad-

cast its new status within 8 seconds. If the door or the window is closed the Device will broadcast information about the event, the inclination angle (zero), the illumination, and the battery status at the time of the closing detection. If the Device beacon mode is enabled it will broadcast information about the current open/close state, the in-

clination angle, the illumination, and the battery status every 30 seconds. To pair Shelly BLU Door/Window with another Blue-

tooth device press and hold the Device button for 10 sec. The device will await connection for the next one minute. The available Bluetooth characteristics are described in the official Shelly API documentation at https://shelly.link/ble To restore the device configuration to factory settings, press and hold the button for 30 seconds shortly after inserting the battery. Initial Inclusion If you choose to use the Device with the Shelly Smart Control mobile application and cloud service, instructions on how to connect the Device to the Cloud and control it through the Shelly Smart Control app can be found in the mobile application guide. The Shelly mobile application and Shelly Cloud service are not conditions for the Device to function properly. This Device can be used standalone or with various other home automation platforms which support BTH-

ome protocol. For more information visit bthome.io Replacing the battery 1. Open the back cover as shown in Fig. 4. 2. Extract the exhausted battery by first pushing it through the battery holder cutout and then pulling it out as shown in Fig. 5. 3. Slide in a new battery as shown in Fig. 6 CAUTION! Use only 3 V CR2032 or a compatible bat-

tery! Pay attention to the battery polarity!

4. Replace the back cover by pressing it to the sensor unit at the four angles until you hear a clicking sound as shown in Fig. 7. Troubleshooting In case you encounter problems with the installation or operation of Shelly BLU Door/Window, please check its knowledge base page:

https://shelly.link/blu-dw_KB Specifications Dimensions:

- 35x35x7 mm / 1.381.380.27 in (sensor unit)

- 35x12x7 mm / 1.440.470.27 in (magnet) Weight:

- 10 g / 0.35 oz (sensor unit with battery)

- 8 g / 0.28 oz (magnet) Working temperature: -20C to 40C Humidity 30 % to 70 % RH Power supply: 1x 3 V CR2032 battery (included) Battery life: 5 years Radio protocol: Bluetooth RF band: 2400 - 2483.5 MHz Max. RF power: < 4 dBm Beacon function: Yes Encryption: AES encryption (CCM mode) Operational range (depending on local conditions):

- up to 30 m outdoors

- up to 10 m indoors Declaration of conformity Hereby, Shelly Europe Ltd. (former Allterco Robotics EOOD) declares that the radio equipment type Shelly BLU Door/Window in compliance with Directive 2014/53/EU, 2014/35/EU, 2014/30/EU, 2011/65/EU. The full text of the EU declaration of conformity is available at the following internet address:

https://shelly.link/blu-dw_DoC FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with mini-

mum distance 20cm between the radiator & your body. FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference re-

ceived, including interference that may cause unde-

sired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-

quency energy and, if not installed and used in accor-

dance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference will not occur in a particu-

lar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dif-

ferent from that to which the receiver is connected. Consult the dealer or an experienced radio/TV tech-

nician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for com-

pliance could void the user's authority to operate the equipment. Manufacturer: Shelly Europe Ltd. Address: 103 Cherni vrah Blvd., 1407 Sofia, Bulgaria Tel.: +359 2 988 7435 E-mail: support@shelly.cloud Official website: https://www.shelly.com Changes in the contact information data are published by the Manufacturer on the official website. https://www.shelly.com All rights to the trademark Shelly and other intellec-

tual rights associated with this Device belong to Shelly Europe Ltd.

Reference No.: WTX23X09205522W001 Page 1 of 10 ANNEX EXHIBIT 1 - PRODUCT LABELING Proposed FCC ID Label Format FCC ID: 2BDC6-SHELLYBLUDW Specifications: The label shall be securely affixed to a permanently attached part of the device, in a location where it is visible or easily accessible to the user, and shall not be readily detachable. The label shall be sufficiently durable to remain fully legible and intact on the device in all normal conditions of use throughout the devices expected lifetime. Proposed Label Location on EUT FCC ID Label Location Waltek Testing Group (Shenzhen) Co., Ltd. Http://www.waltek.com.cn

Shelly Europe Ltd. 103 Cherni Vrah Blvd., Sofia 1407, Bulgaria

Date: 2023-11-01 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 Ref: Attestation Statements Part 2. 911 (d) (5) (i) Filing SUBJECT: FCC Application for FCC ID: 2BDC6-SHELLYBLUDW To Whom It May Concern Shelly Europe Ltd. certifies that the equipment for which authorization is sought is not "covered"

equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules

Shelly Europe Ltd. 103 Cherni Vrah Blvd.,

Sofia 1407, Bulgaria

Date: 2023-11-01 Commission Division Communications and Evaluation Mills Road MD 21046 Federal Authorization 7 435 Oakland Columbia, USA Ref: Attestation Statements Part 2.911 Application for FCC ID:

SUBJECT: FCC

(d) (5) 2BDC6-SHELLYBLUDW

(ii) Filing Europe To Whom It May Concern:

Shelly the Covered List (as a speccall

"covered"

equipment. Ltd. certesthat, as of the date of the fingof the application, ynamed entity the applicant or affiliates) or any of its subsidiaries on producing is not identified as an entity Sincerely, Signat

[Svetoz'

Shelly Europe Ltd. 103 Cherni Vrah Blvd.,

Sofia 1407, Bulgaria

Date: 2023-11-01 FEDERAL COMMUNICATIONS COMMISSION DIVISION AUTHORIZATION 7435 OAKLAND MILLS ROAD MD 21046 COLUMBIA, AND EVALUATION SUBJECT: FCC Application for FCC ID:

2BDC6-SHELLYBLUDW Confidentiality Request to the provisions to withhold To whom it may concern, Pursuant Commission BlockDiagram Opeational Schematics PartsList Description of the Commission's rules attachment(s) the following the we are requesting disclosure indefinitely Title 47 Sections as confidential and0.459, 0.457 from public documents Tune-UpInformation Information Security Defined Software Radio (SOR) Information contain trade secrets of these materials information may be hamfulto the applicant not customarily and provide eleasedto the public. The benefits to its unjustified and proprietary documents, in order to comply 47 CFR2.1204, with the marketing 47 CFR regulations in Title sensitive that business information marketing of newly authorized we request Short Term Confidentiality while ensuring devices, disclosure The above materials public competitors. In addional 2.803 remains of the following External Internal to above mentioned and the importation confidential until attachment(s);

Photos Photos rules in Title the actual TestSetup Photos UserManual For45 days, pusuantto Public or For180 days pursuant The applicant understands to KDB 726920 that pusuantto Section 001. Notice DA 04-1705. 0.457 of the Rules, disclosure of this application and all

Shelly Europe Ltd. 103 Cherni Vrah Blvd.,

Sofia 1407, Bulgaria

Date: 2023-11-01 COMMUNICATIONS FEDERAL AUTHORIZATION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 AND EVALUATION COMMISSION DIVISION SUBJECT: FCC Application for FCC ID: 2BDC6-SHELLYBLUDW POWER OF ATTORNEY To Whom It May Concern:

We, the undersigned, apply to the Federal Testing Group (Shenzhen) Communications Waltek Testing Commission on ouequipment. shall Co., Ltd. Jandy So on our behalf have the same effect as acts of our own. heebyauthorize Group (Shenzhen) Co., Ltd. Jandy So on our behalf, to Any and all acts carried out by Waltek This is to advise subject no patyto the application that we are in full compliance benefits with the Anti-Drug to Section of federal pursuant to a denial 5301 of the Anti-Drug benefits of federal is subject to a denial Abuse Act. We, Shelly pusuantto that section Europe Ltd. are not Act of 1988, 21 USC853a, and Signa

[Svetozar IiiCEO]

Shelly Enno pe Ltd. Date: 2023-11-09 FEDERAL COMMUNICATIONS COMMISSION AUTHORIZATION AND EVALUATION DIVISION 7435 OAKLAND MILLS ROAD COLUMBIA, MD 21046 USA Ref: Attestation Statements Part 2.911(d Grantee Code: 2BDC6 Applicant FRN: 0034405464 d) (7) Filing Shelly Europe Ltd. certifies that, as of the date of the filing of the application, Shelly USA, INC is our designated U.S. agent for service of process for the above referenced Grantee Code. Shelly Europe Ltd. accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. Shelly USA, INC accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process for the above referenced Grantee Code Designated U.S. Agent Information:

Name: Shelly USA, INC U.S. Agent FRN: The agent for service of process does no other business with the FCC and does not have an FRN. Address: 980 Federal Highway Suite 430, Boca Raton Florida 33432 USA Contact Person: Svetlin Todorov Tel.: +1 (702) 533 3307 Email: svetlin.todorov@shelly.com Sincerely, Signed on behalf of Shelly Europe Ltd. Cyth one J Hilly Signed on behalf of Shelly USA, INC. Suethin Vodovev-

Name: Svetozar Iliev Name: Svetlin Todorov Title: CEO Title: Chief Executive Officer Date: 2023-11-09 Date: 2023-11-09