Quick Start Guide Wireless Headset HS-1500BT II Made for professional sounding calls www.CyberAcoustics.com CA P/N: HS-1500BT II Rev. A00 2024-10 In the Package
Quick Start Guide Wireless Headset HS-1500BT II
www.CyberAcoustics.com
Wireless Headset HS-1500BT II Table of Contents Using the Headset
LED Lights
Pages 1 2 3 4 5 6 7, 8 9 10 11 12,13 Using the Headset Best for Use With Skype, Zoom & Other Internet Calls Music Page 1 Getting Started
To connect with a Windows PC or Mac
Note:
Bluetooth Light Power
Bluetooth
Getting Started To connect with an iPhone, iPad, Android smartphone or tablet
Bluetooth Light Note:
Power
Bluetooth
To connect with your computer and smartphone at the same time
Note:
Getting Started Disconnecting the CA Essential Wireless Headset from connected devices
Bluetooth Dongle Light
- To disconnect the headset when connected to both your computer with the USB Bluetooth Dongle
Note: The light on the USB Bluetooth Dongle turns orange when the headset is disconnected or
Page 4 Getting Started Using the CA Essential Wireless Headset as a USB headset
To enable or disable the USB Audio function
LED Lights Headset Powered On Bluetooth Pairing Bluetooth Connected Incoming Call Call in Progress Busy Light Enabled Microphone is Muted Battery Status Charging Fully Charged
Bluetooth Light is lit solid Blue
Bluetooth Dongle Connected to Headset Pairing with Headset Disconnect from Headset Bluetooth Light is lit solid Blue
Bluetooth Light is lit solid Orange Busy Light Bluetooth Light Bluetooth Dongle Light Page 6 Controls Call Button (Only when connected to smartphone)
- Answer / End call: Press for less than 1 second
- Reject incoming call: Press and Hold for 2 seconds
(During a Voice Call, the manual control of the Busy Light is not available)
- Two connected Bluetooth devices: Press once to change between the
Volume Up Button
Multi-Function Button
- Play / Pause: Press for less than 1 second
Volume Down Button
Disconnect connected devices
Clear the headset memory of all previously connected Bluetooth devices
Page 7 Controls Mute / Unmute Mic
- Rotate the Mic Boom up towards the headband to mute the mic
- Rotate the Mic Boom down away from headband to unmute Alternative
- Short press both Volume up and Volume down simultaneously to mute/unmute the mic input
Bluetooth Button
- Press and Hold for more than 2 seconds to reset the unit and clear up the pairing device record
devices and switch the headset to Bluetooth pairing mode
Power On / Off
to a device Charging
Page 8
Sensitivity Frequency response Impedance
Recommended system requirements Supported operating system Operating temperature Windows 10, Windows 11, Mac OS X 10.4.11, or higher
Customer Support
www.cyberacoustics.com/support/contact
www.cyberacoustics.com/faqs/headsets Page 10 Safety and Precautions
- When the headset is plugged in to a charging source with the USB Type C Charging Cable, never use the headset in the shower, bath, or near water, to prevent risk of electric shock.
- Unplug the USB Type C Charging Cable during lightning storms or when unused for long
- Do not place the headset near any heat sources such as radiators, heat registers, stoves, or
- Use this headset only with an agency approved power supply which meets local regulatory
- Do not expose this headset to excessive heat
made, seek medical advice.
Page 11
BC
IC WARNING This device contains licence-exempt transmitter(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device. Lmetteur/rcepteur exempt de licence contenu dans le prsent appareil est conforme aux CNR dInnovation, Sciences et Dveloppement conomique Canada applicables aux appareils radio exempts de licence. Lexploitation est autorise aux deux conditions suivantes:
1. Lappareil ne doit pas produire de brouillage;
2. Lappareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible den compromettre le fonctionnement. Notice: The power delivered by the charger must be between min 5 Watts required by the radio equipment, and max 10 Watts in order to achieve the maximum charging speed. High sound pressure Hearing damage risk Do not listen at high volume levels for long periods. Page 13
