SIZE:145*210MM FCC NOTICE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,including interference that may cause undesired operation. 2. Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC WARNING:
To assure continued operation, follow the attached installation instructions and use only shield cables when connecting to other devices. Changes or modications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. LOCATION CONTROLS:
11 12 13 VOLUME
--
++
NOTES:
Your battery will last longer if youre following these simple guidelines for caring and storing:
A. Before rst time use, recharge the unit approximately 5 hours until the unit is fully charged. B. Charge and store the unit within the temperature range of 5C - 35C (40F - 95F). C. Do not overcharge (longer than 24 hours). Excessive charging or running the unit until battery fully drains will damage battery. Battery life will be extended if you keep the battery fully charged. D. Battery life naturally shortens slowly over time. E. The rechargeable battery incorporated in this product is not user replaceable. OPERATION:
General Operation:
1. Recharge the built-in Li-ion battery as previously instructed. 2. Switch the Power ON/OFF Button to ON position to power on the unit. The LED Display and Decorative LED Lights on the speaker will illuminate. 3. Press the Button repeatedly to switch to desired playback mode. The unit will display with your selection (see list below):
1. Power ON/OFF Buttton 2. (Skip Backward) Buttton 3. (Play/Pause) Buttton 4. Volume Control Knob 5. (Skip Forward) Buttton 6. 7. MICRO SD (TF) Card Slot
(Mode/Decorative LED Lights On-Off) Button 8. MIC (Microphone InputJack) 9. DC 5V (Micro USB) Port (For charging only) 10. Red LED Indicator 11. LED Display 12. AUX (Aux/Line In) Jack 13. USB Port Playback Modes:
USB Micro SD
(TF) Card AUX (Aux/Line in) BT (Bluetooth) Showing on Display USb will appear on the display; music in the USB Device will be playback automatically. Sd will appear on the displaymusic in the card will be playback automatically. will appear on the display. bLUE will appear on the display
(and blink). Note:
If the AUX (Aux/Line in) plug, Micro SD (TF) Card and/or USB Device have NOT been inserted into the unit, the corresponding selection will not be available. POWER SOURCE:
The unit has a built-in Li-ion rechargeable battery, charge it before rst time use or when it is drained as follows:
1. Connect the small plug from the supplied USB Connection Cable to the DC 5V (Micro USB) Port on the unit. 2. Connect the full size USB Plug from the supplied USB Connection Cable to the USB Port on the supplied USB Charger. To DC 5V
(Micro USB) Port VOLUME
--
++
To the USB Port of supplied USB Charger 3. When charging, the Red LED Charging Indicator on the unit will illuminate. When charging is complete, it will turn off. 4. When charging, you can also play and listen to music at the same time. 4. During playback, turn the Volume Control Knob to adjust volume level as desired. 5. Press and hold the (Mode/Decorative Light On-Off) Button to turn off the Decorative LED Lights; press and hold again to turn it back. 6. When finished listening, switch the Power ON/OFF Button to OFF position to shut off the unit. BT Mode:
BT (Bluetooth) pairing:
First time use or re-pairing the unit to a new BT Device, pairs as follows:
1. Power on the unit and enter to BT mode as previously instructed. bLUE will appear on the display and blink. 2. Power on the external BT Device and enter to BT search mode. Start pairing following the on screen instructions from the external BT Device. When paired. bLUE on the display will stop blinking. 3. If pairing is complete you may now play music with your external BT Device. 4. During playback:
Turn the Volume Control Knob to adjust volume level as desired. Press the Button on the unit to pause, press again to resume normal playback. Press the or buttons repeatedly to skip tracks. 5. When finished listening, switch the Power ON/OFF button to OFF position to shut off the unit. Notes:
When the external BT Device searches for the unit, our model number MHT882 will appear on the display of external BT Device. If while pairing you are asked for a code please try "0000" or "1234". Normal operation after pairing:
1. Power on the external BT Device and enter to BT playback mode. 2. Power on the unit and enter to BT mode as previously instructed. bLUE will appear on the display and blink. 3. Wait a few seconds until the unit is automatically paired to the external BT Device. bLUE on the display will stop blinking. 4. After pairing is complete you may now play music with your external BT Device. USB:
To play the music in USB Device:
1. In power off mode, connect the USB Device into the USB Port on the unit as illustrated below:
VOLUME
--
++
2. Power on the unit and enter to USB mode as previously instructed:
USbwill appear on the display. Music in the USB Device will be playback automatically. 3. During playback:
Turn the Volume Control Knob to adjust volume level as desired. Press the Button on the unit to pause, press again to resume normal playback. Press the or buttons repeatedly to skip tracks. 4. When finished listening, switch the Power ON/OFF Button to OFF position to shut off the unit. Micro SD (TF) Card:
To play the music in Micro SD (TF) Card:
1. In power off mode, insert the Micro SD (TF) Card (not included) into the Micro SD (TF) Card Slot on the unit with contacts facing down as illustrated below:
VOLUME
--
++
2. Power on the unit and enter to Micro SD (TF) Card mode as previously instructed:
Sd will appear on the display. Music in the card will be playback automatically. 3. During playback:
Turn the Volume Control Knob to adjust volume level as desired. Press the Button on the unit to pause, press again to resume normal playback. Press the or buttons repeatedly to skip tracks. 4. When finished listening, switch the Power ON/OFF Button to OFF position to shut off the unit. AUX (Aux/Line in):
Listen from an external Audio Player such as MP3 Player, Discmanetc. 1. In power off mode, connect one end of the supplied Audio Connection Cable to the AUX Out/Line Out/
Phone Jack on the external Audio Player. 2. Connect the other end of the cable to the AUX (Aux/Line in) Jack on the unit as illustrated below:
Line in To AUX (Aux/Line in) Jack VOLUME
--
++
To AUX Out/Line Out/
Phone Jack on the external Audio Player 3. Power on the unit and enter to AUX (Aux/Line in) mode as previously instructed. will appear on the Display. 4. Play the music on the connected Player as usual. (Make sure the volume level of the connected Audio Player is turned to high level.) 5. During playback:
Turn the Volume Control Knob to adjust volume level as desired. Press the Button to mute the sound, press again to turn the sound back. 6. When finished listening, switch the Power ON/OFF Button to OFF position to shut off the unit. Notes:
Up to 16 GB Micro SD (TF) Card/USB Device supported. When inserting the Micro SD (TF) Card/USB Device, make sure the direction you selected is correct. Never insert violently to avoid damaging the Micro SD (TF) Card/USB Device or the unit. If it doesnt work, please check if the direction is correct. Before replacing Micro SD (TF) Card/USB Device, make sure the unit has been powered off. You also need to download the desired music in MP3 format into the Micro SD (TF) Card/USB Device before insert into the unit. To sing with playing music:
To sing while music is playing:
1. Power on the unit and plays music in any modes as instructed earlier. 2. Connect the plug from the Microphone (not included) into the MIC (Microphone Input) Jack on the unit. 3. Turn the Volume Control Knob to adjust the sound level of microphone and music as desired. Note:
If feedback noise (high audio frequency noise) is hearing from the speaker, turn the Volume Control Knob counterclockwise to reduce the microphone sound level or moving the Microphone away from the speaker. Check the following before requesting service:
TROUBLE SHOOTING GUIDE:
SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION Cant power on Built-in battery drained The unit in power off mode Recharge the battery as page 1-2 Switch the Power ON/OFF Button to ON position to power on the unit No sound or sound weak Volume of the unit was set to minimum position Increase the volume level by turn the Volume Control Knob clockwise Volume level of paired/
connected device is in low level Rise the volume level of the paired/connected device Volume level too high Reduce the volume level by turn the Volume Control Knob counterclockwise Volume level of the paired/
connected device too high Reduce the volume level of the paired/
connected device The external BT device had NOT paired to the unit The external BT device too far from the unit Pair the external BT device to the unit as page 2-3 Place the external BT device close to the unit GENERAL SPECIFICATIONS:
Built-in DC 3.7 V, 2400 mAh (8.88 WH) rechargeable Li-ion Battery;
recharge by DC 5 V through the DC 5V (Micro USB) Port 2 x 8W ; 4 Total 10W (RMS) 5.0 Up to 32 Feet in open area Sound distortion BT not functioning Power Source:
Impedance of Speakers:
Audio Power:
BT Version:
BT Operation Distance:
PACKAGE INCLUDES:
1 x Owners Manual 1 x USB Connection Cable (For Charging only) 1 x Audio Connection Cable with 3.5 mm plugs SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE 1 2 3 4 5