105g: 105x144mm: 315x144mm4C Front Display Icons You can see the button unit on the back of the scale and press it to change the unit. kg/lb unit is available. Smart Body Composition Scale Gently step onto the scale in an upright standing position.Your scale will firstly measure your weight and will blink three times before displaying percentage and your heart rate. Display Icons body fat percentage This is the Bluetooth icon.It displays when Bluetooth is enabled. BATTERY REPLACEMENT:
Reorient or relocate the receiving antenna. In the event that the scale batteries need to be replaced (display shows Lo),remove Increase the separation between the equipment and receiver. the battery cover.Replace the old batteries with 3 new AAA alkaline batteries. Clean Connect the equipment into an outlet on a circuit different from the battery contacts and also those of the device prior to battery installation. Ensure that to which the receiver is connected. the batteries are installed correctly with regard to polarity,and the supply terminals Consult the dealer or an experienced radio/TV technician for help. Back are not to be short-circuited,then replace the battery cover. Remove used batteries promptly. Dispose of the old batteries as per legal regulations. Do not attempt to open the scale or to remove any components. Servicing should be done by qualified technicians only. FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference , and (2) this device must accept any interference received,including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: