50x80mm Wireless Remote Control Shutter Bution On/Off Switch Shutter Bution On/Off Switch Apple Shutter Bution Android Shutter Bution Apple Shutter Bution Android Shutter Bution On/Off Switch On/Off Switch 1. Turn the On/Off Switch on the Bluetooth Remote to the "On" position. 2. Turn on your smartphone's Bluetooth func-
tion. When you see AB Shutter3 in your list of Bluetooth devices, pair your phone to that device. 3. Once paired, open up the camera feature of your smartphone. 4. Attach your phone to the mount. The smartphone mount can accept phones up to 3.5"wide. 5. To take a picture,press the Shutter Release button. For Apple (iPhones), press the iOS button. For Android phones, press the Android button. Note: Some Android users may notice the camera zooming when the Shutter Button on the remote is pressed. If this occurs, please go into your smartphone's camera settings and change the
"Volume Key" setting to "Camera".Please refer to your smartphone manual for assistance in changing this setting. Note: You cannot pair more than one remote at the same time. 3.0/4.0/5.0
1:/
2:
:AB Shutter3 3:!
Camera360 APP
: 3.0/4.0/5.0
: 10
: CR 2032
: 3 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction
