80.00 mm User Manual Model: Deck D-Z Accessories:
1 Wireless 1 Type C cable 1 User manual stand charging ll"t](
Connect towallch E E O O
.O t I Tips:
of 9V/3A to achieve use an adapter minimum output with a Please of 20W. output the maximum J 4
.r. Anti-Slip Footpads
*Wall charger not included Connect Once connected, charger your dual wireless RED. the LED lights to the wall adapter using the Type C cable. Charge your phone Place your Qi-enabled Once in charging wireless charging device
,the LED lights or be equipped flat on the top of Wireless Surface BLUE. (Your phone must be able to support receiver chip) with a wireless Charging Tips:
Please device align your to the correct area for higher charging efficiency
I I I I r - - - - - - - - - - - - -
I | Standby
| | WorkingProper1 I | FOD
: | Over-voltage/Lowvoltage
-7 1 Red LEDStaysOn | |
y lBlue LEDStaysOn | I
| Red LED Flashes | I
| Red LEDflashes | 1 L----------------------.J A NOWIRELESSCHARGING wall adapter required to access 15W fast use our TYPE-C cable (included) or other fast charger when the phone is being charged and your smartphone to get and used at the hot under proper cable. charging use, please QC3.0/QC4.0 especially music). QC2.0/
1. Quick charge wireless
. 2. To ensure chargingTYPE-C 3. It is normal for the wireless working conditions, same time (such as playing 4. Not works with SV/lA or lower input. socket). 5. Remove the magnetic charging. in fast mode, Two devices 6. One device 7. Do not disassemble, expose to water or intense 8. Keep the product if damaged. out of reach of children charging in normal mode. charging heat. and animals. to use Do not continue or metal accessories from the phone case when
(such as PC powered or USB port from u sdract re d 1 When your wireless Clean the clutter Please phone coil. When the wireless from the wireless down before c charging on the wireless make sure the wireless trying is not working properly charge charging coil is correctly positioned with the charger is overheating, transmitter. Please it. to charge wait for the wireless keep your mobile device transmitter away to cool CE s0 Made in China This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. The device has been evaluated to meet general RF exposure requirement. The distance between user and products should be no less than 15cm.