FCC ID: 2ABUP-FT0311YB Remote Controller Transmitter

USER MANUAL FOR FT0311YB REMOTE CONTROL TRANSMITTER I. Operation ON/OFF the fan Breeze Mode Speed of the fan Timer Direction of the fan FT0311YB transmitter Instructions 1. ON/OFF the Fan When fan shut down, press this button, the fan run at the speed before fan shutdown. When fan are on, press this button, the fan shut down. 2. Breeze Mode: Between Speed 2 to Speed 4, at 40 seconds in a curve and circle speed. Reach one specific speed, it changes to another speed. 3. Speed of the fan (1~6 level) The "+" key increases the fan gear. The higher the gear, the higher the fan speed. The "-" key lowers the fan gear, and the lower the gear, the lower the fan speed. The number of indicators displayed corresponds to the current fan gear. The lowest gear is 1st gear and the highest gear is 6th gear. 4. Fan timing control Set up the timer at 1hours,4hours ,8 hours. 1H 4H 8H press this key, the fan will stop after 1 hours. press this key, the fan will stop after 4 hours. press this key, the fan will stop after 8 hours. The timing function of the key works when the fan is running. Press the key +or- will cancel the timer. The latest timer will take place the previous one. The number of LED lights corresponds to the number of hours when the fan is shut down. 5. Direction of the fan Press the key to control the direction of the fan fan to make the wind blow on the ground. It is usually used in summer.Press and hold this key for 5 seconds to turn on this function. At the same time, the LED lights will display from bottom to top in order. Finally, all the indicators will turn on and off. Press the key to control the direction of the fan, so that the wind blows upward from the ceiling. It is usually used in winter.Press and hold this key for 5 seconds to turn on this function. At the same time, the LED lights will be displayed in order from top to bottom. Finally, all the indicators will turn on and off. 6. The transmitter use 2pcs of 1.5V AAA battery, please install the battery correctly. II. Use precautions 1. When press the key of transmitter, the LED indicator doesnt on, please inspect the battery installation. 2. When press the key of transmitter, the LED indicator flashing, that means the battery get low voltage, please replace a new one. 3. Please pull out of the battery from the transmitter when leaving unused for a long time. FCC Instructions This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This product generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If the product does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

--- Reorient or relocate the receiving antenna.

--- Increase the separation between the product and receiver.

--- Connect the product into an outlet on a circuit different from that to which the receiver is connected.

--- Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause Undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the product. FCC ID: 2ABUP-FT0311YB IC Caution:

RSS-Gen Issue 5 "&" RSS-Gen numro 5

- English:

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause undesired operation of the device. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. RF exposure statement:

The equipment complies with IC Radiation exposure limit set forth for uncontrolled environment.

- French:

Cet appareil contient des metteurs / rcepteurs exempts de licence conformes aux RSS (RSS) d'Innovation, Sciences et Dveloppement conomique Canada. Le fonctionnement est soumis aux deux conditions suivantes:

(1) Cet appareil ne doit pas causer d'interfrences.

(2) Cet appareil doit accepter toutes les interfrences, y compris celles susceptibles de provoquer un fonctionnement indsirable de l'appareil. Tout changement ou modification non expressment approuv par la partie responsable de la conformit pourrait annuler l'autorit de l'utilisateur utiliser l'quipement. Dclaration d'exposition RF:

L'quipement est conforme la limite d'exposition aux radiations de la IC tablie pour un environnement non contrl. IC25540-FT0311YB

30 mm M O D E L N O F T 0 3 11 Y B

FCC ID: 2ABUP-FT0311YB IC: 25540-FT0311YB This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:

(1)This device may not cause harmful interference. and(2)This device must a c c e p t a n y i n t e r f e r e n c e r e c e i v e d . i n c l u d i n g i n t e r f e r e n c e t h a t m a y c a u s e u n d e s i r e d o p e r a t i o n . m m 0 3 25 mm 25 mm Model: FT0313JL FCC ID: 2ABUP-FT0313JL IC: 25540-FT0313JL m m 6 FCC ID: 2ABUP-FT0313JL IC: 25540-FT0313JL m m 6

Shenzhen Funpower General Technology Co., Ltd. Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: 08-24-2023 Ref: Attestation Statements Part 2.911(d)(7) Filing Shenzhen Funpower General Technology Co., Ltd. (the applicant) certifies that, as of the date of the filing of the application, TianHeng Consulting, LLC is our designated U.S. agent for service of process. Shenzhen Funpower General Technology Co., Ltd. accepts to maintain an agent for no less than one year after the grantee has terminated all marketing and importation or the conclusion of any Commission-related proceeding involving the equipment. TianHeng Consulting, LLC accepts, as of the date of the filing of the application, the obligation of the designated U.S. agent for service of process. Sincerely, Designated U.S. Agent Information:

Name: TianHeng Consulting, LLC FRN: 0033401258 Contact Person: Hualing Dong Address: 392 Andover Street, Wilmington, MA 01887, United States Tel.: +1 617-997-4010 Email: tianhengconsulting@gmail.com U.S. Agent Signature:

Hualing Dong, President Applicant:

Company Name:Shenzhen Funpower General Technology Co., Ltd. Grantee Code:2ABUP FRN: 0023358385 Contact Name: Yi Chen Address: Room 201B,Habor Venture Building, No.1041 Houhai Avenue, Shekou, Nanshan District, Shenzhen City, PRC. Tel.: (0755)27586889 Email: simon_chen@szfunpower.com Applicant Signature:

Shenzhen Funpower General Technology Co.,Ltd Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: 12-05-2023 Ref: Attestation Statements Part 2.911(d)(5)(i) Filing FCC ID:2ABUP-FT0311YB Shenzhen Funpower General Technology Co.,Ltd(the applicant) certifies that the equipment for which authorization is sought is not covered equipment prohibited from receiving an equipment authorization pursuant to section 2.903 of the FCC rules. Sincerely, Yi Chen Rev 1/26/2023 Shenzhen Funpower General Technology Co.,Ltd Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 USA Date: 12-05-2023 Ref: Attestation Statements Part 2.911(d)(5)(ii) Filing FCC ID: 2ABUP-FT0311YB Shenzhen Funpower General Technology Co.,Ltd(the applicant) certifies that, as of the date of the filing of the application, the applicant is not identified on the Covered List (as a specifically named entity or any of its subsidiaries or affiliates) as an entity producing covered equipment. Sincerely, Yi Chen Rev 1/26/2023

Shenzhen Funpower General Technology Co.,Ltd Date:December 5, 2023 Federal Communications Commission Authorization and Evaluation Division Confidentiality Request regarding application for certification of FCC ID:2ABUP-FT0311YB Pursuant to Sections 0.457 and 0.459 of the Commissions Rules, we hereby request confidential treatment of information accompanying this application as outlined below:

Exhibit Type Schematics Block Diagram Operational Description File Name Schematic.pdf Block Diagram.pdf Operational Description.pdf The above materials contain trade secrets and proprietary information not customarily released to the public. The public disclosure of these materials may be harmful to the applicant and provide unjustified benefits to its competitors. The applicant understands that pursuant to Section 0.457 of the Rules, disclosure of this application and all accompanying documentation will not be made before the date of the Grant for this application. Sincerely, Shenzhen Funpower General Technology Co.,Ltd Signature Yi Chen/Marketing Manager Typed name and Title

Shenzhen Funpower General Technology Co.,Ltd FCC ID:2ABUP-FT0311YB POWER OF ATTORNEY Date: December 5, 2023 Federal Communications Commission Authorization and Evaluation Division 7435 Oakland Mills Road Columbia, MD 21046 To Whom It May Concern:

We, the undersigned, hereby authorize Waltek Testing Group (Foshan) Co., Ltd.

(Dara Zhou) on our behalf, to apply to the Federal Communications Commission on our equipment. Any and all acts carried out by Waltek Testing Group (Foshan) Co., Ltd. (Dara Zhou) on our behalf shall have the same effect as acts of our own. This authorization expires on October 26, 2024 . This is to advise that we are in full compliance with the Anti-Drug Abuse Act. We, Shenzhen Funpower General Technology Co.,Ltd are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section. Sincerely, Shenzhen Funpower General Technology Co.,Ltd Signature Yi Chen/Marketing Manager Typed name and Title