User Manual Please read this manual carefully before using the device Safety This device is intended for indoor use only. Protect the device from direct water contact. Switch the device off, disconnect all power cords and cables before moving the device. Do not plug or unplug cords with wet hands. Do not twist the power cord. Only use the supplied power adapter. When performing an OTA upgrade or USB local upgrade,Do not power off during the upgrade process, ensure that the power is turned off only after finish upgrade process, and the new system is automatically reboot. A sudden power off during upgrade process will damage the system and lead to fail boot. Whats in the box Model 1 Stick USB Power adapter 5V/2A Bluetooth RCU USB split cable ( one USB Type-C male; one USB type-A male, one Type-A Female) AAA batteries Connection 1. Use HDMI to connect the Model 1 TV stick to your TV. 2. Wifi pairing Long press the reset button on the device for 3 seconds Pairing button Remote control POWER UP LEFT ENTER BACK OAN VOL+
VOL-
MUTE RIGHT DOWN HOME Remote control instructions 1). When Bluetooth is connected, the remote control sends the Bluetooth key value; when Bluetooth is not connected, the infrared key value is sent. 2). Indicator light: red, each time you press the button, the indicator lig 3). Low voltage reminder: When the battery is lower than 2.4V, the indicator light flashes quickly, as long as it is still in operation, it will keep flashing. When the remote control is no longer operated, it flashes 5 times or flashes for 3 seconds and then stops And goes out. 4). Pairing method:
a. Press and hold the "OK" + "VOL-" keys at the same time for 3 seconds, the indicator light flashes, and the pairing success indicator light is always on for 3 seconds and then goes out. b. When the pairing is not successful, if you still press the OK+VOL- key, you must keep sending the pairing broadcast so that the user can pair. c. Press the OK+VOL- button once to be able to pair successfully, do not clear the pairing repeatedly and then pair. After a key pairing is successful, the pairing broadcast can no longer be sent until the key is pressed again next time. d. Connection interval<12ms 5). Remote control distance: 10m 6). Bluetooth device name: BTRCU 7). Support to connect to devices with Bluetooth version 5.0 8). Press "OK+Volume+" at the same time to cancel Bluetooth pairing FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. FCC Warning This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help. NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC/Model1(8822) 105g 85x100mm 2022.8.8