FCC ID:2AMJR-IFOCUSMOTOR c. Manually rotate the lens to the end point, then select Advanced>iFocus>End point to confirm the end point. The iFocus motor will start automatically. Note: The iFocus motor can be turned on by selecting Advanced > IFocus>
turn on during calibration. Note that if the start and end points are not calibrated, the calibration is invalid. 5.Control iFocus movement by Air 2 a. Enter the Air 2 menu, Gimbal Set>Operations>Wheel>Function>Focus-1 or Focus-2 to select the wheel to control the follow focus. You could also press the Mode button on the Air 2 until the wheel mode on the screen turns to Foucs-1 or Focus-2 mode. b. Rotate the wheel to control the motion of iFocus 6.iFocus Control Sensibility Settings Enter the Air 2 menu, and select Gimbal Set>Operations>Wheel>Sensi to adjust the control sensibility. Note: Turn down the sensibility level if the iFocus rotates too fast, and turn the level up it if the iFocus rotates too slowly. Firmware Upgrade iFocus needs to be connected to MOZA Air 2 for firmware upgrade. a. Connect the iFocus to MOZA Air 2 via Multi-CAN cable. b. Long press the power button for 3 seconds in power off status until the white indicator lights up. c. Follow MOZA Air 2 firmware instruction to upgrade the firmware. d. Restart the iFocus and MOZA Air 2 after the upgrade is complete. Specifications Weight(battery excluded) 198g Dimensions Operating Voltage Battery Capacity Bluetooth Charging Port 115*65*30mm 7.4V 600mAh Support USB-C NoteThis product must be used with USB line with ferrite. 4 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment.When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements.This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec Industrie Canada RSS exemptes de licence standard(s).