Smart Temperature
& Humidity Sensor User Manual 01/Product Introduction This smart temperature and humidity sensor adopts high precision temperature and humidity sensor, with quality MCU to process detected temperature and humidity conditions and 02/Illustrations Status Network communication technology to help send Humidity Power Temperature 03/Technical Parameters 04/Networking Open APP, select a gateway, tap + in my Smart Temperature and Humidity Sensor and continue to operate according to APP prompts. 2.Power icon instructions 07/Installation Wall mounting Low power Battery power 25%
Battery power 50%
Battery power 75%
Full mounting bracket and the wall. Desktop 1.Insert desktop bracket onto the mounting 08/Battery installation and replacement Insert the pin key into the disassembly hole, press the mounting bracket inwards, meanwhile rotate the mounting bracket Long press reset button by the pin key to networking status automatically. normal working. Reset button shopping mall, hotel, teaching building, bank, library, warehouse, etc. 1 will enter networking state automatically:
networking icon When networking icon becomes keeping on, APP will prompt network inclusion is done. Air inle Desktop bracket Disassembly hole Battery compartment Reset button 2 Mounting bracket Note: Pressing the reset button again during networking state will stop networking process. 05/Functions Tips Due to the APP upgrade and update, this in the APP. will stop and networking icon 5 7 06/Visual indication 1.Networking icon status instructions Status Long press the reset button, networking been added into the network, it will quit Networking icon networking status. networking status. Temperature or humidity too high or too low 10 11 12 mounting bracket back in place. Align on mounting bracket and on the sensor, rotate the mounting bracket toward close arrow direction to install it back to the sensor. When and are aligned, it indicates its locked in place. mounting bracket is locked. mounting bracket is loosed. 15 17 K C O L O P E N K C O L O P E N 09/Statement As the technology is constantly updated, 165mm 55mm FCC Statement FCC Statement FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. 1 This equipment generates uses and can radiate radio frequence energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. if this quipmemt does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an autlet on a circuit different from that to which the receiver is onnected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement,This equipment should be installed and operated with a minumum distance of 20 cm between the radiator and your body. 2 3