Single Modular approval Declaration letter We ,apply Single modular approval for Product Name: WIFI Module Model: HM-WF8266A, HM-WF8266C, HM-WF8266D, HM-WF8266E, HM-WF8266F FCC ID: 2ASEO-HM-WF8266A According to 996369 D01 Module Equip Auth Guide v01r04 and 15.212 requirement:
1) The radio elements must have the radio frequency circuitry shielded. Physical components and tuning capacitor(s) may be located external to the shield, but must beon the module assembly;
Answer Yeswith shielded 2)The module must have buffered modulation/data inputs to ensure that the device will comply with Part 15 requirements with any type of input signal;
Answer Yes All inputs to the modules are buffered through logic or microprocessor inputs. 3)The modular transmitter must have its own power supply regulation. Answer Yes A low drop out regulator is used for modular power supply regulation. 4)The module must contain a permanently attached antenna, or contain a unique antenna connector, and be marketed and operated only with specific antenna(s), per Sections 15.203, 15.204(b), 15.204(c), 15.212(a), 2.929(b);
Answer Yes Device is equipped with Integral antenna.
(5)The module must demonstrate compliance in a stand-alone configuration;
Answer Yesdistance between modular and all AEs are longer than 20cm refer to setup photo.
(6) The module must be labelled with its permanently affixed FCC ID label, or use an electronic display (See KDB Publication 784748 about labelling requirements);
Answer Yes The modular has a permanent fixed label, and below statement was listed in the User Manual;The host device must be labeled to display the FCCID of the module Contains FCC ID: 2ASEO-HM-WF8266A
(7)The module must comply with all specific rules applicable to the transmitter including all the conditions provided in the integration instructions by the grantee;
Answer Yes The module comply with all specific rules applicable to the transmitter including all the conditions provided in the integration instructions by the grantee, Refer to test report and user manual .
(8)The module must comply with RF exposure requirements Answer Yes Transmitter meets MPE calculation of 47 CFR 1.1307 . Refer to MPEReports and Refer to modular installation manual Date 2019-04-24 Signature Name: xiaolei.zou Title: R&D Manager Company: Shenzhen HOPE Microelectronics Co., Ltd. Address: 2/F Building 3, Pingshan Private Enterprise Science & Technology Park, Nanshan District, Shenzhen, China