BKH600 User Guide 09/06/2019 T R U E W I R E L E S S E A R B U D S IN THE BOX TOP LED Indicator Multifunction Touchpad Ear Detection True Wireless Earbuds USB Type-C cable Charging Connector Microphone CHARGING Charging using the USB Type-C cable Insert the USB Type-C cable into the USB port of the charging case as shown below and connect the other end to any USB Charger or charging device. The Charging Cases LED indicators will ash while charging and become solid when fully charged. Charging Case USB Type-C port T R U E W I R E L E S S E A R B U D S Charging Case B K H 6 0 0 Earbud Tips User Guide LED Indicators USB Type-C port Wall outlet USB Charger
(not included) USB Type-C Cable Qi Wireless Charging Pad See pages 12 and 13 for more details regarding the charging cases LED indicators. Qi Charging Wirelessly charge the case by placing it on any Qi wireless Charging Pad (not included) as shown below. Charging Case POWER ON/OFF The earbuds will automatically power on when taken out of the charging case and power o when placed back into the charging case. To manually power the earbuds ON or OFF follow the instructions below:
BLUETOOTH PAIRING Follow the steps below to pair and connect the earbuds to your Bluetooth enabled device. Connecting 1. The earbuds will automatically be in Bluetooth pairing mode when taken out of the case for the rst time. 4. Once paired, the voice prompt Connected will be heard and the LEDs of both earbuds will slowly ash WHITE. Disconnecting Open the Bluetooth settings on your device, and select Disconnect to disconnect from an already connected device. You'll hear a voice prompt "Disconnected" and the earbuds will go into pairing mode. USING ONE EARBUD You can use the Right earbud alone to make or answer calls while the Left earbud is in the case but the Left earbud cannot be used alone while the Right earbud is in the case. L R EAR DETECTION The Ear Detection feature conveniently pauses the audio playback when either earbud is taken out of your ear. Just place the earbud back into your ear to resume the audio playback. Bluetooth DEVICES Brookstone BKH600 i Bluetooth DEVICES Brookstone BKH600 i
< Bluetooth Disconnect Forget this device Ear Detection When you take out an earbud, the music pauses Power ON:
Press and HOLD the Multifunctional Touchpad on both earbuds for 2 seconds. L R Power OFF:
Press and HOLD the Multifunctional Touchpad of any earbud for 8 seconds. Note: If not connected to a Bluetooth enabled device, the earbuds will automatically power o after 3 minutes. 2. After the earbuds link with each other, the LED of the right earbud will quickly ash RED while the LED of the left earbud will slowly ash WHITE indicating they are in Bluetooth pairing mode. 3. Open your devices Bluetooth menu and nd Brookstone BKH600 and select it to pair. Slowly ash L Quickly ash R Bluetooth menu Earbud Bluetooth Proles:
A2DP V1.3, AVRCP V1.6 HFP V1.7, HSP V1.2 Note: After taking the earbuds out of the case, they will automatically link to each other and then try to connect to a previously paired Bluetooth enabled device. If they do not nd a device to connect to, they will automatically be in Bluetooth pairing mode. Note: Do not select Forget this device or you will have to go through the pairing process again. Wrong Correct 1 2 3 4 5 6 7 8 9 10 TOUCH CONTROL The earbuds include a multifunction touchpad. Just touch the earbuds to control the audio playback and answer calls. LED INDICATORS The earbuds and charging case include LED indicators that are used to explain their dierent states. Charging Case (while charging) Charging Case (not charging, when the cover is opened or closed) Earbuds (not in the Charging Case) Earbuds (in the Charging Case) TOP of the Earbud TOP of the Charging Case Charging Case LED Indicators Charging Case LED Indicators Multifunction Touchpad Multifunction Touchpad Operation Play/Pause:
Double-tap the Left earbud. Next track:
Double-tap the Right earbud. Answer/End call:
Double-tap the Right or Left earbud during an incoming call to answer, and double-tap again during the call to end it. Rejecting a call:
Press and HOLD the Right or Left earbud during an incoming call. Voice Assistant:
Press and HOLD the Right or Left earbud. Press and HOLD once again to cancel the Voice Assistant. USB Type-C Cable Battery Level LED 0% 30%
The rst LED will slowly ash WHITE. 30% 70%
The rst LED is solid WHITE while the second LED is slowly ashing WHITE. More than 70%
The rst two LEDs are solid WHITE while the third LED is slowly ashing WHITE. Fully charged All three LEDs are solid WHITE. LED Earbud Status LED Charging Status LED LED Indicator LED Indicators Battery Level Less than 5%
5% 30%
30% 70%
The rst LED will slowly ash WHITE for 5 seconds. The rst LED is solid WHITE for 5 seconds, then it will turn o. The rst and second LEDs are solid WHITE for 5 seconds, then they will turn o. Low Battery Quickly ashes RED twice every minute. Bluetooth Pairing Connected The Right earbud LED is quickly ashing RED and the Left earbud LED is slowly ashing WHITE. The LED indicators of both earbuds are slowly ashing WHITE. Charging Solid WHITE. Charging Case Fully Charged Solid WHITE for 1 minute and then turns o. 11 12 More than 70%
All three LEDs are solid WHITE for 5 seconds, then they will turn o. 13 14 15 FACTORY RESET If the earbuds are not linking with each other, or not working properly, try doing a factory reset by following the steps below. 1. Place both earbuds inside the Charging Case and make sure they are charging (the LED of both earbuds should be solid WHITE). 2. While in the Charging Case, touch and HOLD the multifunction touchpad of either earbud for 8 seconds until the LED of that earbud ashes RED 3 times. This will clear the pairing information. Multifunction Touchpad 16 3. Repeat step 2 with the other earbud. Charging Case Multifunction Touchpad 4. Take both earbuds out of the case, then put them back into the case for 10 seconds. 5. Remove both earbuds from the Charging Case and let them link with each other (this will occur automatically). 6. Once linked, they will automatically go into pairing mode. The LED of the Right earbud will quickly ash WHITE while the LED of the left earbud will slowly ash WHITE. 7. Open your devices Bluetooth list and delete Brookstone BKH600 from your paired devices list. 8. Turn o the Bluetooth feature of your device and then turn it back on and search for Brookstone BKH600 to connect. 17 FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected. Consult the dealer or an experienced radio/ TV technician for help Information Regarding Exposure to Radio Frequency Energy Your device is designed and manufactured not to exceed the emission limits for exposure to RF energy set by the Federal Communications 18 Commission of the United States (FCC). Information on your Device is on le with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/ea/ after searching on the FCC ID for your Device, which can be found on the back of the Device. LITHIUM POLYMER BATTERY WARNINGS This device contains a non-removable Lithium-
Polymer battery. The battery must be recycled or disposed of properly. Contact your local waste management oce for information on battery recycling or disposal. Rating Label Denitions Direct current symbol. LIMITED WARRANTY 1-Year Limited Warranty Territory: United States/Canada LIMITED WARRANTY TO ORIGINAL CONSUMER This product (including any accessories included in the original packaging) as supplied and distributed new by an authorized retailer is warranted by Southern Telecom, Inc. to the original consumer purchaser against defects in materials and workmanship
(Warranty) as follows:
To obtain warranty service:
Visit our website at www.southerntelecom.com Click on Product Support Select the Brand of your device Select Service Request and ll out the form to begin your inquiry Or call the Customer Support number below:
1-877-668-4839 (Toll Free) Monday - Friday: 8AM - 10PM (EST) This symbol signies the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. This symbol signies and declares that this equipment has battery charging which complies with California CEC and energy eciency. This symbol signies that this is a wireless device powered by Bluetooth technology. The Bluetooth word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., used under license. Your product will be repaired or replaced, at our option, for the same or similar model of equal value if examination by the service center determines this product is defective. Products received damaged as a result of shipping will require you to le a claim with the carrier. Warranty service not provided This warranty does not cover damage resulting from accident, misuse, abuse, improper installation or operation, lack of reasonable care, unauthorized modication including software modications such as the installation of custom rmware. This warranty is voided in the event any unauthorized person opens, alters or repairs this product. All products being returned to the authorized service center for repair must be suitably packaged. NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, OTHER THAN THOSE EXPRESSLY DESCRIBED ABOVE SHALL APPLY. DISTRIBUTOR 19 20 FURTHER DISCLAIMS ALL WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE. NO OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON, FIRM OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BE BINDING ON DISTRIBUTOR. REPAIR, REPLACEMENT, OR REFUND OF THE ORIGINAL PURCHASE PRICE - AT DISTRIBUTORS SOLE DISCRETION - ARE THE EXCLUSIVE REMEDIES OF THE CONSUMER. IN NO EVENT WILL DISTRIBUTOR OR ITS MANUFACTURERS BE LIABLE FOR ANY INCIDENTAL, DIRECT, INDIRECT, SPECIAL, PUNITIVE OR CONSEQUENTIAL DAMAGES (SUCH AS, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) CAUSED BY THE USE, MISUSE OR INABILITY TO USE THE PRODUCT. EXCEPT AS STATED HEREIN, NO OTHER WARRANTIES SHALL APPLY. NOTWITHSTANDING THE FOREGOING, CONSUMERS RECOVERY AGAINST DISTRIBUTOR SHALL NOT EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY DISTRIBUTOR. THIS WARRANTY SHALL NOT EXTEND TO ANYONE OTHER THAN THE ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT TRANSFERABLE. Some countries, states or provinces do not allow the exclusion or limitation of incidental or consequential damages or allow limitations on warranties, so limitation or exclusions may not apply to you. This warranty gives you specic legal rights, and you may have other rights that vary from state to state or province to province. Contact your authorized retailer to determine if another warranty applies. The BROOKSTONE trademarks, names and logos are owned by BKST Brand Holdings LLC. 2019 All rights reserved. www.brookstone.com Manufactured, marketed and distributed by Southern Telecom Inc. under license. Airphones is a registered trademark of Southern Telecom, Inc. The "Qi" symbol is a trademark of the Wireless Power Consortium. The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. All other trademarks and trade names are those of their respective owners. Made in China v1.0 08-2019 21