Science and
(2) Cet appareil doit accepter toutes les interfrences, y compris celles susceptibles de provoquer un fonctionnement indsirable. FCC Caution:
Any Changes or modifcations not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Specic Absorption Rate (SAR) information SAR tests are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest certified power level in all tested frequency bands, although the SAR is determined at the highest certified power level, the actual SAR level of the device while operating can be well below the maximum value. Before a new device is a available for sale to the public, it must be tested and certified to the FCC that it does not exceed the exposure limit established by the FCC, tests for each device are performed in positions and locations as required by the FCC. Non-compliance with the above restrictions may result in violation of RF exposure guidelines. Noncompliance with the above restrictions may result in violation of RF exposure guidelines. 7.1.4 Radio Apparatus Containing Digital Circuits (ICES-003) Radio apparatus containing digital circuitry which can function separately from the operation of a transmitter or an associated transmitter, shall comply with ICES-003. In such cases, the labeling requirements of the applicable RSS apply, rather than the labeling requirements in ICES-003. Waring Class B digital apparatus:
This Class B digital apparatus complies with Canadian ICES-003. Cet appareil numrique de la classe B est conforme la norme NMB-003 du Canada. 5GWIFI ISEDC SAR Waring :
The device has been tested and compliance with SAR limits, users can obtain Canadian information on RF exposure and compliance Le prsent appareil est conforme Aprs examen de ce matriel aux conformit aux limites DAS et/ou aux limites dintensit de champ RF, les utilisateurs pe uvent sur lexposition aux radiofrquences et la con formit and compliance dacqurir les informations correspondantes 5150-5250MHz shall be indoor use only. SAR tests are conducted using standard operating positions accepted by the ISEDC with the device transmitting at its highest certied power level in all tested frequency bands, although the SAR is determined at the highest certied power level, the actual SAR level of the device while operating can be well below the maximum value. tested and certied to the ISEDC that it does not exceed the exposure limit established by the ISEDC, tests for each device are performed in positions and locations as required by the ISEDC. Noncompliance with the above restrictions may result in violation of RF exposure guidelines. Les tests SAR sont effectus l'aide de positions de fonctionnement standard acceptes par l'ISEDC, l'appareil transmettant son niveau de puissance certi le plus lev dans toutes les bandes de frquences testes, bien que le SAR soit dtermin au niveau de puissance certi le plus lev. bien en dessous de la valeur maximale. Le nonrespect des restrictions cidessus peut entraner une violation des consignes d'exposition aux RF. ISEDC Warning This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Economic Development Canadas licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of Science and the device. Cet appareil contient des metteurs / rcepteurs exempts de licence conformes aux RSS (RSS) d'Innovation, Sciences et Dveloppement conomique Canada. Le fonctionnement est soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer dinterfrences, et
(2) Cet appareil doit accepter toutes les interfrences, y compris celles susceptibles de provoquer un fonctionnement indsirable.