modelTT1142 Heyday Mini Speaker Front Side Press - Volume Up Hold - Next Track Press - Play/Pause/
Answer/End Calls Hold - On/Off/
Pairing/Reject incoming call Bottom Charge Light Press - Volume Down Hold - Last Track Charge Port Heyday Mini Speaker Micro USB charging cable Power ON speaker Rapid ashing white light Use Bluetooth settings on your phone to pair with HEYDAY SPEAKER White light turns solid followed by a chime-pairing successful Microphone Included Pairing Indicators Flashing Red - Low Battery Solid Red - Charging No Red Light - Fully Charged Flashing White Fast - Pairing Mode Flashing White Slowly - Bluetooth Connected Ascending Tones - Power on Descending Tones - Power off Three Rapid Tones - Ready to pair Single Chime - Paired Two Rapid Dings - Low Battery Quick Ascending Tone - Max Volume Quick Descending Tone - Min. Volume Charging Full charge requires approximately 2-3 hours Charging is complete when red light turns off Plug micro end of charging cable into the bottom of speaker DC 5V socket Plug USB end of charging cable into a DC 5V USB power supply Troubleshooting If the speaker is not working correctly, turn it on/off to reset If the speaker wont turn on, recharge the battery and try again If the speaker wont charge, make sure the supply works, is 5V >1A, and not damaged If the speaker makes no sound or does not show as an available device, make sure it is not paired, if so unpair the device and repair the desired device Need some help?
Cant get it to pair? Have a question or comment?
Call us at: 877-698-4883 or: 877-MyTgtTech online at: TargetTechSupport.com Safety The speaker is splash resistant, do not submerge under water Do not modify or repair this device Do not use in high temperatures or extreme weather Do not use chemical detergents to clean your device, use a so dry cloth FCC ID: OKUSB25D3A0 Model: TT1142 Input: 5V Max 1A Made in China This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept interference received, including interference that may cause undesired operation. Warning: Changes or modi cations to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by using one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. RF warning statement:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Target Corp. Mpls. MN, 55403 Phone: 1-612-304-6073