Product Name: ATSS122 self timer lever Produt model ATSS122 Tensile length:18.5cm~69cm Product weight:130g Battery model: CR1616button battery Voltage:3V Capacity:50mah Wireless version:4.0 Wireless name:VIP Product Image Instructiones:
1) Press and hold the switchi for three secondi to start up and White LED flashes 2) Press the Bluetooth of the phone, and Search for GT105. 3) Pair and use the switchi for taking pictures 4)Press and hold the switchi for three secondi to shut donn 5)Enter standby mode without operation for 90 seconds 6)Disconnect and press can connect again 7)Automatic shutdown without operation for 600 seconds FCC Statement This device complies with part 15 of the FCC Rules. Operation is subject to the following two co nditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interfer ence received, including interference that may cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance c ould void the users authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable pr otection against harmful interference in a residential installation. This equipment generates us es and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no gu arantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, equipment generates, uses and can radia te radio frequency energy and, if not installed and used in accordance with the instructions, ma y cause harmful interference to radio communications. However, there is no guarantee that int erference will not occur in a particular installation. If this equipment does cause harmful interf erence to radio or television reception, Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.