FCC ID: 2AT82-890 Wireless fence dog training collar

User Manual Waterproof Intelligent 2 in 1 Wireless Dog Fence & Remote Dog Trainer Combo Please take a few minutes to read the instructions. Precautions The fence controller unit should be placed more than 3 feet above the ground and in the open area as any structures/ obstacles/ barriers like walls, trees, and a garden shed can affect the transmission of radio Not recommended for aggressive dogs or dogs prone to behave signals. aggressively. If you are not sure if this product is right for your dog, please consult your For safety of the product, the fence controller unit should be used indoor veterinarian or a certified trainer. or in a dry place ONLY. To avoid irritation or injury to dogs neck skin, collar should never be worn for more than 12 hours in a single day. Check dogs neck frequently and reposition the collar if needed. Always keep dogs neck area clean. If a rash or sore is spotted, stop using the collar until the condition is improved or recovered. Parts and Accessories:

Wireless Transmitter-1 Screws - 2 + 2 Waterproof & Rechargeable Receiver Collar-1 Metal Probes 4 Reflective Strap Fluorescent TPU-1 Silicone Case -4 Test Light Tool -1 5V Charger -1 USB Cable -1 English Manual -1 Introduction This product combines wireless dog fence and remote trainer in one single package. It gives the convenience to contain your dog wirelessly without the hassle to bury a boundary wire. From the fence controller box, you can instantly send a correction signal (beep sound, vibration, or shock) to train your dog. You can use it inside the house or outdoor. Working PrincipleWireless fence:

1. Receiver will not work among setting distance, will work as below when 2. When dog not in the range, Receiver working modes as below (indicator light exceed the range. flashing when working):

1).Sound 5 seconds;

2). Vibration 5 seconds;

3). Sound & vibration at same time for 6 seconds;

4). Shock 5 seconds;

5). Sound& Shock at same time for 6 seconds. 3. After 5 working modes, it will launch di-di-di sound always. The receiver will not work until the dog return to the setting distance range or press power Off. 4. After the second no signal 5 second delay work. QUICK START Turn on the fence controller and press the MODE button. This will allow you to select the MODE, either Fence mode or Remote trainer mode. If you see 100,200,300,500,990 on screen, it is in Wireless Fence mode. If you see 001,002 or 003 on screen, it is in Remote Trainer mode. Please read the following information about Wireless Fence Mode and Remote Dog Trainer Mode. Wireless Fence Mode Push the power button of the collar to turn on the collar. Push the power button again to turn off. Collar works automatically with fence controller without a sync/pairing procedure. From low range 100 feet to max 990 feet, you can always adjust it by pressing the Minus - and Plus + buttons. You can test the collars with the shock test kit. When you are within the safe zone, collar will not react till you reach the warning zone. Inside the warning zone, collar beeps fast and red-light flashes rapidly. When exceed the setting range, receiver will start working mode automatically. (refer to the working modes at Working Principle ).When you are back in the safe zone, collar will not have beep or any warning lights. One fence controller box can work with multiple collars, you can add as many collars as you need to use the wireless fence feature. Keep in mind, this system can work with up to 3 collars individually as a remote dog trainer. Remote Dog Trainer Mode Usually collar already paired with the fence controller by factory. In 1-dog set, collar paired with channel 001; In 2-dog set, collars paired with channel 001 and 002 while 3-dog sets collars paired with channel 001,002,003, respectively. You can press the Minus - and Plus + buttons to switch the dog collars among 001,002,003. When a channel is chosen, push Minus - and Plus + buttons to change levels of corrections (sound, vibration, shock). Each correction method has 3 levels(1-3). Remote control range is up to 990 feet. If by any chance you need to re-sync a collar with the fence controller, you can follow guide below:

Instructions to sync a receiver with remote controller:

Turn the receiver on first, the red light is on. Turn on fence controller, push the Mode button to show 001(if display otherwise showing 100,200, etc.), push the Mode button again till it shows 001. Then push and hold the MODE button AND the power button of the receiver at the same time. The fence controllers display and receivers light will flash and then turns solid red. Release your fingers on both units. At this point, the receiver and the fence box are matched on channel 001. Do the same for the 2nd on 002 or 3rd collar on 003. How to Test:

1.Turn on fence controller and receiver, and switch to Wireless Fence mode. Select a range like 100 or any other higher ranges (200,300,500,990), with the collar in hand, walk away from the fence controller. When you approach the limit of the range, collar will beep and its red-light flash rapidly. This indicates the collar is in warning zone. If you move away further, collar will discharge VIBRATION till you return to the warning and safe zone. 2. When in remote dog trainer mode, press a SOUND, VIBRATION or SHOCK button to test. Push the SHOCK button and check if the shock test kit lights up. Charging Fence controller Receiver:

DC 5V3.7V lithium battery 2500mah. LED will display" 000" flashing When low battery, please charge it and it takes about 4-5 hours for full battery charge

(solid red LED light). Please use the included charger for best performance. DC 5V 3.7V 400mah lithium battery. It takes 2-3 hours for full charge (solid green light). If receiver is not in use for 5 minutes, it will hibernate and be in standby status. Gentle shakes or movements can activate the collar instantly. FCCCaution Thisd evice complies withp art 15 oft heFCC Rules. Operationiss ubject tothe following twoco nditions: (1) Thisd evice may not cause harmfulin terference, and (2) thisd evice must accept any interferencer eceived, includingin terference thatm ay cause undesiredo peration. Any Changes orm odifications not expressly approvedb yth e party responsiblefor compliance couldv oid theu ser's authorityto operatet hee quipment. Note: Thiseq uipment has beentes tedan dfo undto comply witht helim its foraClass B digital device,p ursuantto part1 5o f theFCC Rules. These limits are designedto provide reasonable protection against harmfulin terference inares idential installation. Thise quipmentg enerates uses and canrad iate radio frequencyen ergy and,if not installedan du sedin accordancewit hth ei nstructions, may cause harmful interference torad ioco mmunications.Ho wever, thereis no guarantee thatin terferencewillnot occur inap articularin stallation.If thise quipmentdoes cause harmfulin terferenceto radio ort elevision reception,w hich canbed eterminedb ytu rningth e equipmento ff and on,t heuserisencourag edto tryto correctthe interference by oneorm oreo f the followingm easures:

-Reorient orr elocate therec eivingan tenna.

-Increase thes eparationb etweenth eequip ment and receiver.

-Connect thee quipmentinto ano utleto nac ircuitd ifferent fromth at towh ichthe receiverisc onnected.

-Consultth e dealer oran experiencedrad io/TV technician forh elp. This equipmentcom plieswithFCC uncontrolledenviro nment. radiation exposure limits setfor thfo ran

C5266091_X10_Ed.2 Shenzhen New Discovery Pet Products Co., LTD. Office of Engineering Technology Federal Communications Commission 7435 Oakland Mills Road Columbia, MD 21046 Date:

2022.2.26 Subject: Request for Confidentiality FCC ID: 2AT82-890 To Whom It May Concern, Pursuant to the provisions of Sections 0.457 and 0.459 of Commission's rules

(47CFR0.457, 0.459), we are requesting the Commission to withhold the following attachment(s) as confidential document from public disclosure. Exhibits ID Label/Location Attestation Statement External Photos Block Diagram Schematics Test Report Test Setup Photos Users Manual Internal Photos Parts List / Tune Up RF Exposure Info Operational Description Cover Letter(s) SDR Software / Security Info Long-Term Confidentiality No No No No No NOTE 1 NOTE 1 No No Short-Term Confidentiality NOTE 2 No No No No No No NOTE 1: Long-Term Confidentiality may be permitted under special conditions (See II. LONG-TERM CONFIDENTIALITY, Section 3 of KDB 726920, use last in force) NOTE 2: Short-Term Confidentiality can be requested for a maximum of 180 days from the date of the grant. Above mentioned document contains detailed system and equipment description are considered as proprietary information in operation of the equipment. The public disclosure of above documents might be harmful to our company and would give competitor an unfair advantage in the market. In case of short-term Confidentiality, the applicant requests the exhibits selected above are withheld from public view for a period of ____45__ days from the date of the Grant of Equipment Authorization and prior to marketing. It is our understanding that all measurement test reports, FCC ID label format and correspondent during certification review process cannot be granted as confidential documents and those information will be available for public review once the grant of equipment authorization is issued. 1/1 C5266091_X10_Ed.2 Sincerely, Signature:

Name: Tina Xie Title: sales manager 1/1

C5266091_X8_Ed.1 Letter of Authorization Shenzhen New Discovery Pet Products Co., LTD Company: Shenzhen New Discovery Pet Products Co., LTD. Address: 406, Block A2, Jianyuan Zhichuang Park, Hangcheng Industrial Zone, Xixiang, Baoan, Shenzhen, China Product Name: Wireless fence dog training collar Model Number: 890, 891, 892, 893 FCC Identifier: 2AT82-890 We authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, to act on our behalf on all matters concerning the above named equipment. Any individual within LGAI Technological Center S.A. is authorized to act on our behalf and take action on the application. We declare that authorize LGAI Technological Center S.A., Ronda de la Font del Carme, s/n, 08193 Bellaterra, Spain, is allowed to forward all information related to the approval project to the Federal Communication Commission and to discuss any issues concerning the approval application. Any and all acts carried out by LGAI Technological Center S.A. on our behalf shall have the same effect as acts of our own. Name: Tina Xie Title: sales manager Date: 2022.2.26 Signature of applicant:

1/1

JiNan Huiquan Electronic Co., Ltd. Model Difference Product description: Wireless fence dog training collar Model name: 890, 891, 892, 893 Trade Name: /

FCC ID: 2AT82-890 All the model are the same circuit and RF module, only for model name. Regards Sincerely Clients signature:

Clients name / title : Tina Xie (sales manager) Contact information / address: 406, Block A2, Jianyuan Zhichuang Park, Hangcheng Industrial Zone, Xixiang, Baoan, Shenzhen, China