D UserManual QH-1085 Wireless Digital Doorchimes LED FLASHING INDICATOR VOLUME SWITCH (low,medium or high) High Quality Loudspeaker Can be put on the bable with the]
click-in base TUNES SELECTION SWITCH (16 tunes selectalbe) RING OPTION SWITCH:ring only,or LED flash only,or combination of ring and flash Water proof push button with LED Indicator Name plate Can be hung on the wal through the nail hole on the back side. keep the code-matching button on the receiver pushed, and push the button of the transmitter at the same time. Release the code-matching button on the receiver as soon as the bell rings, accordingly. In this case, the code matching of the doorbell set is finished. and then release the button of the transmitter 2X1.5V AA batter operated Set the fastening tab of the top cover into the slot of the base Press here by hand to fix the top cover onto the base. Use double sided tape to fix the unit to the desired place
. Use a minus driver to carefully open the top cover of the unit. Set a battery into the battery compartment in correct polarity direction. 1.5V AA alkaline battery Battery Battery cover Receiver Load in battery and replace the cover Steel Nail Wall Hang on the wall FCC NOTE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation. THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR CHANGE TO THIS EQUIPMENT. SUCH MODIFICATIONS OR CHANGE COULD VOID AND CHANGE ANNTENA WHICH THE MANUFACTURER PROVIDES. IT IS THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi dential installation. This equipment generates, uses and can radiate radio frequenc y energy and, if not installed and used in accordance with the in structions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular insta llation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to corr ect the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experien ced radio/TV technician for help. To maintain compliance with FCCs RF exposure guidelines, this equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.