Technical Support For advanced setup, please download the user manual:
https://reolink.com/software-and-manual/
For more troubleshooting, please go to FAQs on our website:
https://reolink.com/faqs/
For other technical support, please contact us at support@reolink.com Reolink C1 Pro Quick Start Guide QG1_A Welcome to Reolink Easy Setup Within Minutes!
Camera Connection Diagram Your smart device Power adapter Router For initial setup, please connect the camera to your router LAN port with an Ethernet cable, and then follow the steps below to set up your camera. Make sure that your camera and your smart devices are connected to the same router. Access the Camera by Smartphones Device Settings 1 Scan Show Password Wi-Fi Signal Device Settings Wifi Settings Wifi Settings SSID Password Wi-Fi Test SSID ASUS 5G 4 TP-LINK_5G_F8F4 ASUS 2.4G ASUS 5G
******
3 Wi-Fi Test 2 5 OK Scan succeed!
1. Scan the SSID. 2. Double click the SSID which you choose. Enter the password. 3. Click Wi-Fi Test to test the password. 4. Press Wi-Fi test:
a) If Wi-Fi test succeeds, please go to step 5. b) If Wi-Fi test fails, please check your Wi-Fi password and network connection, and then try again. 5. Click OK. Remove the Ethernet cable and you can access the camera via Wi-Fi on computer now. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator
& your body.