This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Wireless Charging Zone Automatic switch clamp Indicator light Magnetic plug Car wireless charger Touch Switch (Back) Infrared Sensing Zone 1 / 4 Instruction:
The car wireless magnetic charger is not only suitable for all mobile phones that pass the QI wireless charging protocol, but also for mobile phones that do not have wireless charging function. Mobile phones without wireless charging only need to be plugged in the corresponding magnetic plug. It is also convenient to use mobile phone bracket, automatic induction switch and automatic charging with one-handed operation, so it makes a better trip. List:
1, wireless car charger 2, Type-c data cable 3, magnetic plug 4, vent clamp 5, 3M rubber bracket 6, Packaging box Instruction:
1. Install wireless charger. the air outlet clamp or 3M rubber bracket of the car 2 / 4 2. Connect the wireless car charger and cigarette lighter charger with the Type-c charging cable, and plug in the power supply. 3. The mobile phone that does not have the wireless charging function is equipped with the magnetic suckers with corresponding interfaces. Note :
1. This product should be used as required, otherwise it may cause fire, explosion or other danger. 2. Please use the QC3.0 or PD fast charger, otherwise, it may not be able to turn on or off automatically ,or not charge or charge slowly. 3. Please use the original data cable. This device has a large input current and needs to support charging cables for more than 2A. Otherwise, it may not be able to turn on or off automatically ,or not charge or charge slowly. 4. Do not attempt to disassemble, shake, or knock off the device. 5. Please touch the top back sensing area when removing (1.5 cm below the top) Technical parameters:
Input interface: Type-c Input power: QC3.0 or PD Input voltage / current: 5V3A 9V2A 4. Place mobile phones that need to be recharged. 5. Touch the top back sensing area when removing 3 / 4 12V1.5A Output: 15W 10W 7.5W 5W Magnetic Absorption Charging: 1A 4 / 4