EFR32ZG14 Zen Gecko UZB-7 Z-Wave Controller USB Dongle BRD1001A Datasheet
\ Note 1 Note 1 The Silicon Labs UZB-7, Z-Wave Controller USB Dongle, is a simple reference design featuring the latest generation Z-Wave SoC, EFR32ZG14 Zen Gecko, as a gateway and controller in smart home application. UZB-7 exposes the well-documented and proven Z-Wave Serial API via USB. It allows the host processor to control up to 232 Z-Wave devices and Z-Wave Plus devices through Z-Wave protocol. With the developer PC application software, PC Controller, or any software compliance with Z-Wave Serial API, the host is empowered to communicate with various Z-Wave devices through Z-Wave Command Classes, making your computer the heart of your Z-Wave network With the benefits of Z/IP from Silicon Labs, controller software base on Z/IP such as Z-Ware from Silicon Labs, enable you to create your own Z-Wave gateway that is locally or remotely hosted. Z-Wave is an established short range interoperable two-way RF mesh network technology. Refer to http://www.z-wave.com for the technology description, various Z-Wave Plus ready certified products, and Z-Wave Alliances Key Features & Benefits Z-Wave 700 Series SoC EFR32ZG14 Zen Gecko
+6 dBm sensitivity improvement in 100kbps channels Firmware upgradable through USB AES 128-bit encrypted communication and security feature Compliance approval (tbc) EU US ANZ Japan EN 300220 FCC CFR47 Part 15.249 ANZ 4268 ARID STD-T108 Worldwide SAW filters for additional out-of-band blocking consideration CP2102N USB-to-UART SoC for VCP USB 2.0 Full Speed Compliance Royalty-free Virtual COM port drivers, CP210x VCP Driver Work with Windows / Mac / Linux silabs.com | Building a more connected world. Rev 0.30 General Specification ERF32ZG14 Zen Gecko SoC USB powered RF Transmit current RF Receive current RF Transmit power *1 RF Sensitivity 9.6 kbps 40 kbps 100 kbps 5.00 0.25V 22 mA (typ.) 20 mA (typ.) Up to +13 dBm (max.) 101 dBm (typ.) 100 dBm (typ.) 97 dBm (typ.)
-15 to 55C PCB antenna
< 25uA
> 40 m open space line-of-sight Operating Temperature Internal antenna Sleep current * 2 Range* 1 Note* 1 Allowable transmit power are governed by respective regulatory Note* 2 UZB-7 is typically always active Block diagram UZB-7 Z-Wave Controller User Manual Product Specification Z-Wave Libraries Z-Wave Library Z/IP Application Version 5.64 Version 5.64 Z-Wave DLL Ordering Information SLUSB7000A Bridge Controller UZB-7 Z-Wave Controller Refer to [1] UZB-7 Reference Manual for further descriptions of each blocks, and design considerations and options for UZB-7. silabs.com | Building a more connected world. Rev 0.30 UZB-7 Z-Wave Controller User Manual Table 1. Frequencies Allocation US EU Japan Korea Australia New Zealand UZB-7 Z-Wave 7.00 9.6 kbps / 40 kbps / 100 kbps 100 kbps 908.42 MHz 908.40 MHz 916.00 MHz
-1 dBm 868.42 MHz 868.40 MHz 869.85 MHz 13 dBm 2 / 3 921.42 MHz 921.40 MHz 919.80 MHz 12 dBm 922.50 MHz 923.90 MHz 926.30 MHz 0dBm 920.90 MHz 923.90 MHz 926.30 MHz 13dBm Frequency Allocation Region Model Firmware Data Rate Number of Channels Frequency Max. Power Quick Start Up Here is a Quick Start Up guide to get UZB-7 to work with Z-Wave PC Controller. The Z-Wave PC Controller is a PC application software tool enable communications to Z-Wave nodes such as switches and sensors. 1. Connect UZB-7 to your computer 2. Install the Virtual COM Port (VCP) drivers UZB-7, CP201x UART-to-USB Driver, CP210x VCP Driver. The latest drivers are available at www.silabs.com/interface-software. Install and Run Z-Wave PC Controller from Simplicity Studio 3. 4. Click on the Setting-wheel on Right-Top corner of PC Controller and select Silicon Labs CP210x USB to UART Bridge. Click OK silabs.com | Building a more connected world. Rev 0.30 UZB-7 Z-Wave Controller User Manual 5. Click on Next Work Management 6. UZB-7 is detected and appears as [S2] Pc Controller. The bottom panel display information and Z-Wave Command Class supported by UZB-7. 7. From here, you can perform basic commands to end devices. Refer to [3] PC Controller User Guide for more info. silabs.com | Building a more connected world. Rev 0.30 UZB-7 Z-Wave Controller User Manual EU Declaration of Conformity This device complies with Radio Equipment Directive 2014/53/EU issued by the Commission of the European Community. The following test methods have been applied to prove presumption of conformity with the essential requirement of the directive. EN 300 220-1: V3.1.1(2017-02) EN 300 220-2: V3.1.1 (2017-02) EN 301 489-1: V2.1.1 (2017-02) Final draft EN 301 489-3: V2.1.1 (2017-03) EN 623112008 EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013 FCC Federal Notice This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:
Increase the separation between the equipment and receiver. Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. silabs.com | Building a more connected world. Rev 0.30 Document Revision History Revision 0.30 2019-01-05 Beta-2 document revision UZB-7 Z-Wave Controller User Manual Contacts Silicon Labs Silicon Labs International Silicon Labs Denmark Silicon Labs Norway 400 West Cesar Chavez, Austin TX78701 USA 18 Tai Seng, #05-01 18 Tai Seng Street, Singapore 539775 Emdrupvej 28B, 2100 Copenhagen Denmark Sandakerveien 118 0484 Oslo Norway silabs.com | Building a more connected world. Rev 0.30 BRD1001A Reference Manual Document Revision History