Important : before programming, check the following points :
- Use tre transmr ittes mated with the roller shutter.
"When you switch on, all the FRS receivers have 10 emit } short beep every two secands as long as you have not program. At this stage, the wansmitter works in unstable mode and only nearer the anteana. If not, cancel the prograraming (see 7), perhaps the seceivers have already been programmed.
+ Motos direct on of rotation according to the transmitter keys (see 2). In case of direction reversal, press the stap key of the concerned transmitter{s) until you hear a beep of a second. The working direction is now reversed.
= Program an individual transmitter
* move the transmitter nearer the antenna. BB press on the programe key of the transmitter until you hear B short beecs. The process is finished.
= @ Program a 2 control point You don't need to move the transmitters nearer the antenna. BB press on the programm key of the individual transmitter already programmed in the process @ until you hear 3 short beeps. you hear 3 short beeps. The process & finished. the process is the same as for the 2~ control point. The process @ has to be repeated J Program a general control transmitter 8B OB itor each S 31 the group. es aon Program a group controt transmitter
(without indiy dual transmitter) the process isthe same as for an individual transmitter. The process 3 has to be
= repeated for each FRS of the group. A when the programing is finished, if one o several recaivars ting one beep every 2 5, walt for the automatic stop of the signal (2 mn), without touching the transmitiess, the inital programming will not change. 2 $ are necessary in order that the programmiag becomes effective. 2
= . ptess on the progream key of the 2 contro! point transmitter until st
@ in case of loss or theft of a transmitter individual transmitter :
At the reczipt of the new transmitter (or to cancel the former programming) :
* Disconnect the power supply of the roller shutter according to the following process :
- cut of 2 ta 5 seconds.
- power supply during 7 to 10 seconds.
- cut of 2 to 5 seconds.
- connect again the power supply,
(=@ the receiver rings 1 short beep every 2 seconds). move tre transmitter nearer the antenna Ss fem press on the program key of the transmitter until you hear 8
? short beeps the transmitter Is programmed.
* the other associated transmitters (2 control point, group control and/or general) must be programmed again.
* group or general control transmitters :
the process to follow is the same as for the programming of the FRS (4, 5 & 6) A Note that in case of loss or theft of a transmitter, it is better to program again the whole installation by precaution. Caution: The changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.