E880 SINOTECH R&D GROUP LIMITED 5. Troubleshooting Battery might be drained, please replace the battery or charge it. Battery might not be installed correctly, please replace it with a Silent, fully charged battery or charge the no response battery. Check if the device has been power on. Check if the external audio accessory is connected. Unable to | Check if you are in the same group. make/ Check whether the network is receive calls | connected. Shut down the Wi-Fi and GPS if not in use. Cannot . Check USB cable, replace if faulty. Charge
[1] Before using the product, please read the Quick Guide to fully benefit from it.
[2] This product involves constant upgrading and/or improvement, our company reserves the right to change the specifications of software and/or hardware mentioned in this operating guide without any prior notice. The product specifications and information mentioned in the operating guide are for reference only.
@ Check list
[1] Please check the following accessories before you discard the packing material. Please contact your local dealer immediately if there is any missing or damage parts. FCC Statement 15.19 Labeling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. 15.105 Information to user. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference ina residential installation. This equipment generates uses and can radiate radio 1 Charging Plug Quick Start Guide 1. Overview of E880 Emergency Button Flash light |
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet ona circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information:
This product meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough e =LED indicator light Charging Red (Steady) Message Prompt Blue (Steady) More than 90% charge capacity Green (Steady) 2. Installation of SIM card Anticlockwise the switch of battery cover 45, open it and remove battery. Insert the SIM card as shown in the picture. Insert the SD card into the slot as shown in the picture. Battery Compartment Groove Place the battery in the correct direction Slot SD Card Slot SIM 4 Card Raleane in the battery slot, and Slot [i Groove then close the battery cover by turning the battery cover switch clockwise 45 to lock the battery cover. A evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. This device was tested for typical body-worn operations when the device used at 25mm from front face and 10mm from back of the product, 0mm from the belt, for maintain compliance with FCC RF exposure requirements. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. This transmitter may operate with the antenna(s) documented in this filing in body-
worn configurations. RF exposure compliance is limited to the specific belt-clip and accessory configurations as documented in this filing and the separation distance between user and the device or its antenna shall be at least 25 mm. No 3. Charging the Battery e Using USB Data Cable To USB Power Adapter 7 USB Data Gable Connect the IP smart terminal and power adapter using the USB Data Cable. Red light on the IP smart terminal indicates battery charging in progress. Green light indicates fully charged. 7 IC STATEMENT This device complies with Industry Canadas licence-exempt RSSs. Operation is subject to the following two conditions:
(1)This device may not cause interference; and
(2)This device must accept any interference, including interference that may cause undesired operation of the device. Le prsent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorise aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radiolectrique subi, mme si le brouillage est susceptible d'en compromettre le fonctionnement. Specific Absorption Rate (SAR) information:
This product meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health. Important:
Use only the designated charger. Battery must be fully charged before first use. Do not expose the battery to high temperature. Do not dismantle the battery. 4. Basic operations e Startup Press the power on button for 3 seconds, Once the screen goes light up, You will see the Logo, it indicates successful Startup. e Shut Down Press the power off button for 3 seconds, Popup window showing shutdown and restart, click on shutdown, Once the screen goes blank, the smart terminal is fully shut down.
@ Unlock e Press Home or Power to light the screen. Slide lock icon on the screen to unlock. IC RF Exposure Information and Statement The SAR limit of USA (IC) is 1.6 W/kg averaged over one gram of tissue. This device was tested for typical body-worn operations with the back of the handset kept 10mm for body worn. To maintain compliance with IC RF exposure requirements, use accessories that maintain a 25mm from front face and 10mm from back of the product, 0mm from the belt. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with IC RF exposure requirements, and should be avoided. This transmitter may operate with the antenna(s) documented in this filing in body-
worn configurations. RF exposure compliance is limited to the specific belt-clip and accessory configurations as documented in this filing and the separation distance between user and the device or its antenna shall be at least 25 mm. e@ Group Call Press and hold the PTT button until you hear the Permit Tone. You are now connected to the Group. You may begin to talk. Release PTT button to end the call and the device will be in the receiving mode. e@ Emergency Call Press and hold the Emergency button for 3 seconds can start. e = Backlight Press Power button to on and off backlight. You can select the time duration of the backlight. e Low Batt When the battery power fall below 15%, a beeping tone will be heard. e Document Manager Select document manager, you will see all folder including pictures and videos. E880 Series Operating RED Statement 1. Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. 2. The product shall only be connected to a USB interface of version USB2.0 or higher. 3. Adapter shall be installed near the equipment and shall be easily accessible.4. The operating temperature of the EUT cant exceed 40C and shouldnt be lower than -20C. 5. The plug considered as disconnect device of adapter. 6. The device complies with RF specifications when the device used at 25mm from front face and 5mm from back of the product, 0mm from the belt. Hereby, SINOTECH R&D GROUP LIMITED declares that this Mobile phone product is in compliance with essential requirements and other relevant provisions of Directive 2014/53/EU. This product is allowed to be used in all EU member states.