Instructions for SBox_K_0021 This system is mainly used for locking or unlocking the doors of the vehicle. The transmitter sends a radio wave signal while the button is pushed. The receiver becomes active in response to the signal from the transmitter. Button Functions Unlock Lock Panic Using the Remote Ensure you are within range of the vehicle before preforming remote functions. Please Lock button to Lock all doors (horn will honk) Press Unlock button one (1) time to Unlock drivers door. Press Unlock button a second time within 5 seconds to unlock all doors. Press and hold Panic button to sound alarm o Press Unlock button to disable alarm Note: Specific vehicle responses to remote interaction very from vehicle to vehicle. Please check the vehicle manual for more information. FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the users authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Connect the equipment into an outlet on a circuit different from that to which the Increase the separation between the equipment and receiver. receiver is connected. Consult the dealer or and experienced radio/TV technician for help.