WARNING To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. WARNING THIS APPARATUS MUST BE EARTHED. CAUTION Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. When you dispose of the battery, you must obey the law in the relative area or country. WARNING When installing the unit, incorporate a readily accessible disconnect device in the fixed wiring, or connect the power plug to an easily accessible socket-outlet near the unit. If a fault should occur during operation of the unit, operate the disconnect device to switch the power supply off, or disconnect the power plug. CAUTION About the LAN connector For safety, do not connect the connector for peripheral device wiring that might have excessive voltage to this port. WARNING 1. Use the approved Power Cord (3-core mains lead) /
Appliance Connector / Plug with earthing-contacts that conforms to the safety regulations of each country if applicable. 2. Use the Power Cord (3-core mains lead) / Appliance Connector / Plug conforming to the proper ratings
(Voltage, Ampere). If you have questions on the use of the above Power Cord / Appliance Connector / Plug, please consult a qualified service personnel. Caution Two size AAA (R03) batteries are required for Remote Control. To avoid risk of explosion, use size AAA (R03) manganese or alkaline batteries. For the customers in the U.S.A. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. All interface cables used to connect peripherals must be shielded in order to comply with the limits for a digital device pursuant to Subpart B of part 15 of FCC Rules. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. If you have any questions about this product, you may call;
Sony Customer Information Service Center 1-800-222-7669 or http://www.sony.com/
3GB Sony LSPX-A1 4-732-088-11(1) GB For the customers the U.S.A. and Canada CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This product is classified as a CLASS 2 LASER PRODUCT. Carrying the projector Only lift the projector with four or more people, one person at each corner. Firmly grasp the handles located at the bottom of the projector with both hands. Notes The projector is heavy. Grasp it firmly when moving it to avoid dropping it and causing injuries. It may be difficult to see the ground when carrying the projector. Note the following to avoid injury. Do not step on the AC power cord or cables from the Do not get caught in the AC power cord or cables from the Do not set the projector down on your feet. Do not subject the projector to strong impacts when moving it. It may drop or break, resulting in serious injuries. Use the box and packing materials that originally contained the projector when it needs to be carried for repairs or moving. WARNING LASER RADIATION DO NOT STARE INTO BEAM CLASS 2 LASER PRODUCT CAUTION Do not look into the lens while in use. CAUTION Do not allow children to operate this product without supervision. CAUTION The use of optical instruments with this product will increase eye hazard. For the customers in other countries IEC 60825-1:2014 CLASS 1 LASER PRODUCT As with any bright light source, do not stare into the beam, RG2 IEC 62471-5:2015. CAUTION Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION Do not look into the lens while in use. CAUTION The use of optical instruments with this product will increase eye hazard. Declaration of Conformity Trade Name:
Model:
Responsible party: Sony Electronics Inc. Address:
SONY LSPX-A1 16535 Via Esprillo, San Diego, CA 92127 U.S.A. Telephone Number: 858-942-2230 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)this device must accept any interference received, including interference that may cause undesired operation. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. For the customers the U.S.A. and Canada Radiated Exposure Statement:
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation
(MPE). For the customers in Canada This device complies with Industry Canadas licence-
exempt RSSs. Operation is subject to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause undesired operation of the device. For the customers in Canada CAN ICES-3 (B)/NMB-3(B) CAUTION When you connect the LAN cable of the unit to peripheral device, use a shielded-type cable to prevent malfunction due to radiation noise. 4GB Sony LSPX-A1 4-732-088-11(1)